Husqvarna LE475 Support and Manuals
Get Help and Manuals for this Husqvarna item
This item is in your list!
View All Support Options Below
Free Husqvarna LE475 manuals!
Problems with Husqvarna LE475?
Ask a Question
Free Husqvarna LE475 manuals!
Problems with Husqvarna LE475?
Ask a Question
Popular Husqvarna LE475 Manual Pages
Owners Manual - Page 1
OPERATOR'S MANUAL / 2008
WITH PARTS LIST
EDGER/TRIMMER Model: LE475 / 966951101
• Speci cations • Operating
Instructions • Maintenance
Information
Owners Manual - Page 2
... 6 Stopping The Engine 6
Correct Edger-Trimmer Usage 8 Operation of the Edger-Trimmer 8
Maintaining Your Edger-Trimmer 9 Maintenance Check List 9 Engine 9 Oil Quality 9 Oil Level 9 Oil Changes 9 Spark Plug 9 Blade Maintenance 9 Blade Changes 9 Lubrication 9 Storage Instructions 13 Maintenance Notes 13-15
Parts Illustration 10 Parts List 11 Troubleshooting Chart 12 Warranty Back...
Owners Manual - Page 3
...setting or overspeed engine.
3.
Keep edger-tirmmer in good operating
condition, and keep engine free of trouble. Stop blade when crossing gravel drive, walks, or roads.
6. Never carry passengers. Avoid blade unless
7. sharp corners by Outdoor Power Equipment Institute
DO NOT MODIFY EDGER.... Read the Operating and Maintenance Instruction Manual carefully. familiar with gasoline
be ...
Owners Manual - Page 5
... OPERATION
Install 6 Bolts Through Handle Lower Support & Handle Brace Holes
Throttle Cable Clip
Fig. 1
CAUTION
Before starting engine.
Slip on handlebards.
If the throttle cable is potentially lethal. CAUTION
Handlefuelwithcare-itishighly ammable. Also insure that can cause extensive internal damage to top notch of the handle, facing forward. The lawn edger, except...
Owners Manual - Page 6
... operating the edger-trimmer. WARNING
Never adjust cutterhead angle when engine is also used to position the blade horizontally for trimming or choose several vertical positions for edging.
CLUTCH AND DEPTH LEVER SETTINGS (See Fig. 3)
Clutch and Depth lever is not rotating before starting engine. Sudden starts can throw dirt or debris.
Manually pull...
Owners Manual - Page 7
... once again install the spacer on the axle between the front wheels.
Remove the spacer from between the frame and wheel. Only vertical edging can be sure the wheels and cutterhead are positioned to the right when edging with open side down.
The wheels are positioned so the blade will not strike the wheels.
NOTES
7 Wheel Spacer Positioned...
Owners Manual - Page 8
..., set blade depth and by slightly lifting rear wheels, guide edger-trimmer around corners when front wheels are placed together at this equipment is dry. CORRECT EDGER-TRIMMER USAGE
CAUTION
Read all shields in place. If this speed your lawn with Section 4442 of trimmer-edger.
Always push edger-trimmer at handle). at right side of the California Public Resources Code...
Owners Manual - Page 9
... edges of blade to the engine manual for tightness.
9 Check all exposed bearings, linkage, and front wheels. Refer to prevent bodily harm.
Spark plug should be checked after each fty hours of grey or tan deposit. Use a spark wrench to adjust the electrode air gap as possible. CAUTION
Sharp edges of edger-trimmer blade can cause...
Owners Manual - Page 11
...Wheels 505289916 8" Rear Wheel Complete w/
Bearings, Wide Tire & Hub Cap
505289917 8" Rear Wheel Outside Bearing
Only
505289918 8" Rear Wheel Inside Bearing
Only. PART NO. NO.
inches 1 inch = 25.4 mm
11 LAWN EDGER AND TRIMMER PARTS LIST
REF. No 33,53,51,52,54,55,56,61,37,(2)63, (2)36) LE475...Clamp, Blade Guard Bolt 1/4-28 x 1-1/2 Hex (2 Req.) Blade Guard Main Complete Blade Guard ...
Owners Manual - Page 12
...air passages in off pos ition. Engine fails to proper oil level.
* NOTE: For repairs beyond the minor adjustments listed above, please contact your local Lawn Mower Service... B. Carburetor improperly adjusted. TROUBLESHOOTING CHART
PR OB LE M
1. A. Dirty air cleaner.*
5. A. Carburetor idle speed too slow.* B. Carburetor idle mixture adjustment improperly set.*
6. Hard Starting or ...
Owners Manual - Page 13
...completely. 2. Pull starter rope on essential parts such as the carburetor and fuel tank. While engine is important that the following instructions be completely drained of fuel to prevent gum...a ect the operation of oil into the cylinder. Replace spark plug. 5. MAINTENANCE NOTES
13 Re ll with fresh oil. 4.
STORAGE INSTRUCTIONS
Edger-trimmers stored for any length of time should be ...
Owners Manual - Page 16
...'s/Operator's manual or instruction sheet furnished by third part engine manufacturers for those components which the purchaser has received a separate warranty with the product information supplied at time of incidental or consequential damages, or limitations on the care label.
SECTION 2: HUSQVARNA'S OBLIGATIONS UNDER THE WARRANTY
Husqvarna will repair or replace defective components...
Parts Guide - Page 1
Illustrated Parts List / 2008
EDGER/TRIMMER Model: LE475 / 966951101
• Speci cations • Operating
Instructions • Maintenance
Information
Parts Guide - Page 3
...525594401 Set Screw 5/16-...36) LE475 Decal...Blade 1-1/4 Pin U-Clamp Spacer Grease Fitting Handle and Wheel Bearing Cutting Head Complete (Inc.
Also for 7" & 8" Rear Wheels
505289916 8" Rear Wheel Complete w/
Bearings, Wide Tire & Hub Cap
505289917 8" Rear Wheel Outside Bearing
Only
505289918 8" Rear Wheel Inside Bearing
Only. PART NO. PART NO. NO.
LAWN EDGER AND TRIMMER PARTS...
Husqvarna LE475 Reviews
Do you have an experience with the Husqvarna LE475 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Husqvarna yet.
Earn 750 points for your review!