Operation Manual
Page 16
...Replacement). 9. Check that the V-belt clears the top belt keeper arm when idler is inside both V-pulleys are made specifically for Husqvarna to obtain maximum performance and unit life. Adjust the keeper, or clutch cable length if necessary. 8. Replace drive guard. Should any malfunction occur... 2. Large pulley Replace belt on small pulley first 8060-010 IMPORTANT INFORMATION Many parts, including the drive belt on Model AR19), with genuine Husqvarna parts to give many hours of shim plates under the engine. 6. Replace all engine service information. 16 3 1.
...Replacement). 9. Check that the V-belt clears the top belt keeper arm when idler is inside both V-pulleys are made specifically for Husqvarna to obtain maximum performance and unit life. Adjust the keeper, or clutch cable length if necessary. 8. Replace drive guard. Should any malfunction occur... 2. Large pulley Replace belt on small pulley first 8060-010 IMPORTANT INFORMATION Many parts, including the drive belt on Model AR19), with genuine Husqvarna parts to give many hours of shim plates under the engine. 6. Replace all engine service information. 16 3 1.
Operation Manual
Page 20
...when at minimum length or before. (Tines are replaced, tighten stop bolt. Refer to the set screw in the collar. 11. Fold handle on the AR19 Model. 3. Elevate approximately 4", block and chock rear wheels. 5. Insert pin punch into the hole next to sections "Chain Removal and Replacement" and "... 8060-011 8060-012 Remove drive guard cover. 3. Reverse steps to insure that it was removed. MAINTENANCE AND SERVICE Tines Tine Wear After the Husqvarna Aerator has been used for sometime, the tines will hold tines in place. 43/8" (11.1 cm) Minimum Check tines for wear Tine Shaft ...
...when at minimum length or before. (Tines are replaced, tighten stop bolt. Refer to the set screw in the collar. 11. Fold handle on the AR19 Model. 3. Elevate approximately 4", block and chock rear wheels. 5. Insert pin punch into the hole next to sections "Chain Removal and Replacement" and "... 8060-011 8060-012 Remove drive guard cover. 3. Reverse steps to insure that it was removed. MAINTENANCE AND SERVICE Tines Tine Wear After the Husqvarna Aerator has been used for sometime, the tines will hold tines in place. 43/8" (11.1 cm) Minimum Check tines for wear Tine Shaft ...