Husqvarna ST 227P Support and Manuals
Get Help and Manuals for this Husqvarna item
View All Support Options Below
Free Husqvarna ST 227P manuals!
Problems with Husqvarna ST 227P?
Ask a Question
Free Husqvarna ST 227P manuals!
Problems with Husqvarna ST 227P?
Ask a Question
Most Recent Husqvarna ST 227P Questions
Model St227p Broken Spring
the spring to the traction control cable broke. where does this connect underneath when the bottom p...
the spring to the traction control cable broke. where does this connect underneath when the bottom p...
(Posted by hopthebop 1 year ago)
Auger Handle Return Spring Placement
The return spring on my auger handle fell out of place and I do not see an obvious reattachment poin...
The return spring on my auger handle fell out of place and I do not see an obvious reattachment poin...
(Posted by newgreenchicken09 2 years ago)
St227p - Throttle Dial
Throttle dial won't stay on "full" setting when using. Engine vibration causes it to rotate back tow...
Throttle dial won't stay on "full" setting when using. Engine vibration causes it to rotate back tow...
(Posted by dpeterson16419 2 years ago)
My St227 Husqvarna Snow Blower Only Moves Reverse
my ST227 Husqvarna nowblower only moves forward in 6th gear and very slowly I might add. All other g...
my ST227 Husqvarna nowblower only moves forward in 6th gear and very slowly I might add. All other g...
(Posted by PeteN 2 years ago)
St227p Drive Locks Wheels But Goes Forward If Steering Levers Are Used.
Is there a fix for the above? Sometimes one side will lock. Put in reverse and will back up like its...
Is there a fix for the above? Sometimes one side will lock. Put in reverse and will back up like its...
(Posted by Edlutkus 3 years ago)
Husqvarna ST 227P Videos
Husqvarna USA Snow throwers ST 227P at work 01-09-2015
Duration: :27
Total Views: 109
Duration: :27
Total Views: 109
Popular Husqvarna ST 227P Manual Pages
Owners Manual - Page 1
English Operator's Manual
ST 227P
Gasoline containing up to 10% ethanol (E10) is acceptable for use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
115 68 34-27 Rev. 3
Please read the owner's manual carefully and make sure you understand the instructions before using the machine. The use in this machine.
Owners Manual - Page 2
... the snow thrower.
4. Look for hidden hazards or traffic.
3.
Keep clear of all times.
2. WARNING: Always disconnect spark plug wire and place it where it on contact, stay away from the truck or trailer and refuel it cannot contact plug in order to observe the following safety instructions could result in the manual(s) before starting when setting...
Owners Manual - Page 3
... for proper tightness to clean out the discharge chute. The instructions will enable you cannot easily remedy, please contact your nearest authorized service center.
When cleaning, repairing or inspecting the snow thrower, stop the engine and make certain the collector/ impeller and all moving parts have stopped rotating.
3. exhaust fumes are present such as necessary...
Owners Manual - Page 9
... material thrown from the discharge chute.
TO CONTROL SNOW DISCHARGE (See Fig. 11)
WARNING: Snow throwers have exposed rotating parts, which snow is to stop the forward or reverse movement of the snow thrower. The DIRECTION in desired position.
AUGER CONTROL
LEVER
FIG. 10
FIG. 12
9
Set the deflector low to "OFF" position.
2. Do not use . The DISTANCE...
Owners Manual - Page 11
.... Use fresh fuel next season. Adjust skid plates evenly to separation and formation of this manual. Check engine oil with snow thrower on your parts bag may become worn. Purchase fuel in quantities that can be emptied before requiring replacement.
Skid plates are adjusted evenly. After considerable use gasoline near an open flame.
Adjust skid...
Owners Manual - Page 13
...the spark plug and check belts for loose fasteners.
3. Some adjustments will help your snow thrower well lubricated (See "LUBRICATION CHART").
Check for wear. To receive full value from the warranty, operator must maintain snow thrower as instructed in Maintenance section ➂ White Lithium Grease
➂ Interlock
bosses Pivot points
Engine oil
13
All adjustments in this manual...
Owners Manual - Page 14
... any spilled oil. The belts are of this manual).
7. The belts on dipstick.
10.
Wipe off any maintenance. Be careful not to allow dirt to the snow thrower. SPARK PLUG
Replace spark plug at "FULL" line on your snow thrower. Change the oil after each time you check the oil level. Install left wheel (if removed for accurate reading. Spark plug type and gap setting are shown...
Owners Manual - Page 15
...stopped.
4. SERVICE AND ADJUSTMENTS
WARNING: To avoid serious injury, before performing any other components. Make sure the augers and all moving parts have sheared.
Align holes in impeller hub with spark plug.
3. Insert safety ignition key and reconnect spark plug wire to direct discharging snow away from spark plug and place wire where it should be replaced. Install 1/4-20 locknuts...
Owners Manual - Page 16
...lower 5/16" bolts on your nearest service center/department. The front section will tip back and pivot to be replaced by original equipment manufacturer (OEM) belts available from around the arm.
Remove block from snow thrower. Lbs. / 5-8 Nm).
5. Continue with "AFTER REPLACING BELTS" instructions. ENGINE PULLEY
AUGER BELT TENSIONER ARM
AUGER BELT
HANDLE
MOUNTING BRACKET
FIG. 20...
Owners Manual - Page 17
...
WHEEL HUB
ENGINE
FIG. 23
SEE ENGINE MANUAL
CARBURETOR
Your carburetor is factory set for proper engine speed. If your engine does not operate properly due to make any necessary adjustments. SERVICE AND ADJUSTMENTS
DRIVE BELT REPLACEMENT (See Fig. 22)
TO REMOVE DRIVE BELT
1. Remove auger belt. Tighten securely.
3. INSTALL BELT COVER and two (2) screws. Tighten securely...
Owners Manual - Page 19
... storage. Run engine at the end of this manual).
3.
STORAGE
Immediately prepare your snow thrower for storage at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor.
Inspect and replace belts, if necessary (See "TO REPLACE BELTS" in minimizing the formation of oil through spark plug hole into cylinder.
3.
Acidic gas can if your...
Owners Manual - Page 20
... spark plug wire.
2. Clean or replace muffler.
snow.
4. Choke is off valve (if so equipped) 1. Choke in fuel.
11. Replace spark plug.
10. Empty fuel tank & carburetor, refill with ice or 3.
Check / replace drive belt. 2. Check / reinstall drive belt. 3. Augers / impeller jammed.
4. Start engine.
2. Auger belt is in manual unless directed to a service...
Owners Manual - Page 21
...the Limited Warranty, free of and replaces any defective product or part covered by this Limited Warranty is provided and included with the product at the Husqvarna Factory.
7. This Limited Warranty does not cover general maintenance parts and items ("Expendable Parts"), including without limitation spark plugs, bulbs, filters, lubricants, starter cords, belts, blades, and blade adapters...
Owners Manual - Page 22
...authorized Husqvarna servicing dealer during the warranty period;
(o) Dirt contaminated grease or oil, use of product, after the repairs have questions concerning this Limited Warranty. Documentation Required. Husqvarna encourages you to register your product is listed in the Husqvarna oil label and covered in your operator's manual;
(l) Operation of the unit with improperly installed...
Owners Manual - Page 24
...warranty, parts & labor, with Husqvarna.
EZ - Deck Shell replacement will be limited to a maximum of the warranty period
applicable to left
Consumer
Commercial
Rental
* See Separate Engine Manufacturer's or Manufacturer's warranty.
M-ZT - (ZT3400 transmission) Two (2) Year warranty, parts & labor, with Hydro-Gear Distributor network.
*** "Limited Lifetime Warranty" on specific Snow...
Husqvarna ST 227P Reviews
We have not received any reviews for Husqvarna yet.