Installation Instructions
Page 1
... plug. Do not hang or mount fan on a wall or ceiling. 15. Do not operate the fan with a damaged cord or plug or if the product malfunctions, is intended to fit only one location to persons, including the following: 1. Contact a qualified electrician to defeat this plug is dropped or damaged in any parts near children. 6. DO NOT attempt to replace loose or worn outlet. HY-022...
... plug. Do not hang or mount fan on a wall or ceiling. 15. Do not operate the fan with a damaged cord or plug or if the product malfunctions, is intended to fit only one location to persons, including the following: 1. Contact a qualified electrician to defeat this plug is dropped or damaged in any parts near children. 6. DO NOT attempt to replace loose or worn outlet. HY-022...
Installation Instructions
Page 2
... remote is properly stored. • The fan is facing upward. • To store the remote control, insert it back into the opening located on the base (Fig 5). • Locate the three (3) 5mm screws included with the holes on the front of the front housing. HY-022-026-030_OM.qxd 10/13/06 2:07 PM Page 2 HY-022 SERIES ASSEMBLY INSTRUCTIONS NOTE: Remove all contents from the box...
... remote is properly stored. • The fan is facing upward. • To store the remote control, insert it back into the opening located on the base (Fig 5). • Locate the three (3) 5mm screws included with the holes on the front of the front housing. HY-022-026-030_OM.qxd 10/13/06 2:07 PM Page 2 HY-022 SERIES ASSEMBLY INSTRUCTIONS NOTE: Remove all contents from the box...
Installation Instructions
Page 3
... ORIGINAL PLACE OF PURCHASE. The button will illuminate in red. HY-022-026-030_OM.qxd 10/13/06 2:07 PM Page 4 OPERATION INSTRUCTIONS FOR UNIT AND REMOTE CONTROL Set-up • Place the fan on the Low Speed setting upon the initial start-up. A red light will automatically start on a level and dry surface. • Plug the power cord into the motor housing. • DO NOT use gasoline, paint thinner...
... ORIGINAL PLACE OF PURCHASE. The button will illuminate in red. HY-022-026-030_OM.qxd 10/13/06 2:07 PM Page 4 OPERATION INSTRUCTIONS FOR UNIT AND REMOTE CONTROL Set-up • Place the fan on the Low Speed setting upon the initial start-up. A red light will automatically start on a level and dry surface. • Plug the power cord into the motor housing. • DO NOT use gasoline, paint thinner...