Hitachi NV65AC - 2-1/2" Full Head Pallet Coil Nailer Support and Manuals
Get Help and Manuals for this Hitachi item
View All Support Options Below
Free Hitachi NV65AC manuals!
Problems with Hitachi NV65AC?
Ask a Question
Free Hitachi NV65AC manuals!
Problems with Hitachi NV65AC?
Ask a Question
Most Recent Hitachi NV65AC Questions
What Is This Nailer Used For, Can It B Used For Roofing Or Siding?
(Posted by sotmechanical 14 years ago)
Popular Hitachi NV65AC Manual Pages
Instruction Manual - Page 3
... accidents that must be avoided by recognizing a potentially hazardous situation before operating or maintaining this Manual and in the sections which contain the operation and maintenance instructions. Hazards that result from the operation and maintenance of this nailer.
DEFINITIONS OF SIGNAL WORDS
DANGER indicates an imminently hazardous situation which , if not avoided, may...
Instruction Manual - Page 6
... INSTRUCTIONS FOR USING NV83A2 • NV65AC • NV50A1 COIL NAILER
WARNING
1. Do not operate the Nailer when you are not familiar with the nail guide open, the fasteners can fly out.
2. To avoid this Manual. and do not drop the Nailer or strike the Nailer against hard surfaces; USE ONLY PARTS, ACCESSORIES OR FASTENERS SUPPLIED OR RECOMMENDED BY HITACHI. CLOSE NAIL GUIDE...
Instruction Manual - Page 7
... EYE PROTECTION.
3. Enforce the use of EYE PROTECTION by operators and others in work area.
4. SAVE THIS MANUAL AND KEEP IT AVAILABLE FOR OTHERS!
- 7 - Keep Nailers in work area are not further used before repair. Maintain Nailers properly.
6. Ensure that Nailers are used only when operators and others in safe working order.
5. Ensure that this...
Instruction Manual - Page 8
... in the safe operation of the Nailer.
NAME OF PARTS
Exhaust Cover Piston
Piston O-ring Driver Blade
Nose
Body
Trigger Cap
Air Plug (Sold separately) Magazine
Magazine Assembly
Section A-A
Main nail stopper
Nail guide
Feeder
Push Lever
Feed piston
Feed spring
Firing Head (Outlet)
Knob Dust Cover
Magazine Cover Nail Holder
Exhaust Cover Trigger
Body
Piston
Piston...
Instruction Manual - Page 9
... at 7 kgf/cm2)
Air inlet
3/8 NPT Thread
NAIL SELECTION
Only nails shown in the above figue. NOTE: Use only genuine Hitachi nails to malfunction and resulting injuries.
Max.
.236" (6 mm)
.283" (7.2 mm)
NV65AC
Min. Max.
.245" (6.2 mm)
.266" (6.8 mm)
NV50A1
Min. ACCESSORIES
.083" (2.1 mm)
.083" (2.1 mm)
Wire-collated coil nails
WARNING
ⅷ Accessories other than those shown...
Instruction Manual - Page 10
... Drain daily.
2. Use Hitachi pneumatic tool lubricant. BEFORE ...Nailer and extend the Nailer life.
NOTE: ⅜ Aluminium nails may occur.
These units should always be used to supply compressed air to change without any obligation on Nailer.
1. sold separately
⅜ Sequential Trip Mechanism Kit (Code No. 876762)
(Single Shot Parts... pallets. ⅜ Making wooden ...
Instruction Manual - Page 11
... units should find a correct compressor size.
Do not use . 1 Reduce the air pressure to freefire the Nailer. COLD WEATHER CARE
⅜ Do not store the Nailer in work , test the Nailer by using the Nailer and contact a Hitachi authorized service center immediately.
- 11 -
Conduct the tests in the system, whichever is not available, supply 5 - 10 drops...
Instruction Manual - Page 12
..., depress the push lever against the workpiece.
Ⅺ THE NAILER MUST OPERATE.
(6) If no abnormal operation is observed, you may load nails in the Nailer.
Ⅺ THE NAILER MUST NOT LEAK AIR.
REMOVE ALL NAILS FROM NAILER. Ⅺ ALL SCREWS MUST BE TIGHTENED. If any nails in the Nailer. Adjust the air pressure at a higher than required air...
Instruction Manual - Page 13
... not depress push lever; and 3) keep Nailer pointed downward.
(1) Grip the nail guide and knob with the guide surface. Press the knob down and swing the nail guide open the magazine cover. And open .
Knob
Nail guide Magazine cover (2) Adjust the position of the feeder.
Nail holder Nails Magazine
(4) 1 2
3
Uncoil enough nails to the nail length reference points on the magazine...
Instruction Manual - Page 14
...ANSI Z87.1 specifications. English
(1) Press the magazine stopper and open . First Nail
Magazine Opening Magazine
Knob Nail Guide
(6) 1 2
3
Uncoil enough nails to the right, swing the nail guide closed without adjusting the nail holder correctly, the nail holder may be damaged.
(3) Place the nail coil into the magazine. Otherwise, the nail guide will not feed smoothly if the nail holder is...
Instruction Manual - Page 15
... trip mechanism may be operated in work area.
ⅷ Keep fingers AWAY from the trigger.
The nailer with a
bouncing motion. Nails can spark out of Operation". An OPTIONAL SEQUENTIAL TRIP MECHANISM kit (SINGLE SHOT) is important.
This Hitachi nailer has a STANDARD CONTACT TRIP MECHANISM (Bounce Fire). Trigger
3 2
Push Lever (2) Continuous operation (Push lever fire...
Instruction Manual - Page 16
...that: 1) the air pressure to the Nailer remains constant
(regulator is installed and working properly), and 2) the Nailer is always held firmly against yourself or ...PARTS) is for use the nails because, if used as described above and according to all nails from the Nailer; 2) remove all warnings and instructions. ⅷ Always handle nails and package carefully. If dropped, the collated nails...
Instruction Manual - Page 17
... the knob sliding part.
Main Nail Stopper Sub Nail Stopper
Nose Opening Feeder Shaft Feeder
4 Lubricate the feeding surfaces of frequent jam, contact a Hitachi authorized service center. Some illustrations in the following order : 1 DISCONNECT AIR HOSE. 2 Open the nail guide. 3 Insert a rod into the outlet.
and 2) clearing a jam.
1. Nail Guide
Nail Slotted Screw Driver
5 Cut the deformed...
Instruction Manual - Page 18
... service personnel trained by Hitachi, distributor or employer shall repair the Nailer.
ⅷ Use only parts supplied or recommended by pushing them with the tool to incorporate the latest technological advancements.
NOTE: Specifications are constantly being improved and modified to the Hitachi Authorized Service Center when requesting repair or other maintenance. Operator troubleshooting...
Instruction Manual - Page 19
... and lubricate.
---
Contact Hitachi for assistance.
Extend the Nailer life. Blow clean daily. If problems persist, contact a Hitachi authorized service center for replacement. Drives too deep. Skipping nails. Nails jam.
Contact Hitachi for proper nails.
Check position of plate or nail holder in direction opposite to cycle.
Driver blade worn? Clean magazine...
Hitachi NV65AC Reviews
We have not received any reviews for Hitachi yet.