HP ProLiant DL380G5-WSS Support and Manuals
Get Help and Manuals for this Hewlett-Packard item
This item is in your list!
View All Support Options Below
Free HP ProLiant DL380G5-WSS manuals!
Problems with HP ProLiant DL380G5-WSS?
Ask a Question
Free HP ProLiant DL380G5-WSS manuals!
Problems with HP ProLiant DL380G5-WSS?
Ask a Question
Popular HP ProLiant DL380G5-WSS Manual Pages
HP StorageWorks Clustered File System 3.6.0 Windows Storage Server Edition Setup Guide (403102-005, January 2008) - Page 12
... This step is needed only if your servers use Emulex
HBAs. If
you will be installing a firewall, ensure that the service
ports required by
WINS clients. Set the network
information (IP address) and user/password.
HP Clustered File System
requirements for MPIO Software
Set up HP's MPIO software to http://
h18006.www1.hp.com/products/sanwo rks/
softwaredrivers...
HP StorageWorks Clustered File System 3.6.0 Windows Storage Server Edition Administration Guide (403103-005, January 2008) - Page 54
...-Wide Configuration tab, select all servers except the server to a cluster, complete the following procedure.
1. Restart the HP Clustered File System service on your product.
2. If you are prompted for the user name and password, specify the appropriate values.
3.
See the HP StorageWorks Clustered File System Installation Guide or Setup Guide, depending on the existing nodes. Start...
HP StorageWorks Clustered File System 3.6.0 Windows Storage Server Edition Administration Guide (403103-005, January 2008) - Page 251
... partitions, and resilvering corrupt partitions.
• The Storage Settings tab on the Configure Cluster window contains options to have problems, contact HP Support.
Depending on the status of the SDMP process, when you invoke mxsanlk you continue to add, repair, or replace membership partitions. This step should restart the SDMP process.
These commands can be used...
HP StorageWorks Clustered File System 3.6.0 Windows Storage Server Edition Administration Guide (403103-005, January 2008) - Page 254
... "Reset the Cluster ID" on a server, it checks the status of service or if you can be used if a disk containing a membership partition is out-of-sync among the membership partitions and must be replaced on the Storage Settings tab and click Repair. This operation can resilver the partition manually if desired.
• CORRUPT. Only one...
HP StorageWorks Clustered File System 3.6.0 Windows Storage Server Edition Administration Guide (403103-005, January 2008) - Page 272
... describes how to perform the following activities: • Collect HP Clustered File System log files with mxcollect • Check the server configuration • Disable a server for maintenance • Troubleshoot a cluster • Troubleshoot service and device monitors
Collect Log Files with mxcollect
The mxcollect utility collects error event logs that can be asked to run the mxcollect...
HP StorageWorks Clustered File System 3.6.0 Windows Storage Server Edition Administration Guide (403103-005, January 2008) - Page 275
...HTTP server is not set properly on the command line and check for the HP StorageWorks Clustered File System service. This problem ...HP Clustered File System indicates that it is okay, verify that the service is not installed. To check this , check the Services applet in the Control Panel) and the %WINDIR%\system32\drivers\etc\hosts file.
Built-In NT Backup Software Fails on the server...
HP StorageWorks Clustered File System 3.6.0 Windows Storage Server Edition Administration Guide (403103-005, January 2008) - Page 284
...55 PSFS filesystems 93 SAN disks 62 server 45 service monitor 196 system design guidelines 14 virtual host 180
configurations, supported 15 Connect window
authentication parameters 25 bookmarks...monitor 209 SHARED_FILESYSTEM monitor 210 troubleshooting 265
device monitor configuration add or update 213 advanced settings
273
probe severity 216 script ordering 220 servers 222 virtual hosts 221 delete...
HP StorageWorks Clustered File System 3.6.1 Windows Storage Server Edition administration guide (AG515 - 96007, August 2008) - Page 282
...be replaced on page 279. The operation then takes place. Highlight the partition to replace a corrupt membership partition. Chapter 20: SAN Maintenance
270
Check the device for hardware problems....the Storage Settings tab and click Repair. If a single membership partition is started on a server, it checks the status of service or if you can resilver the partition manually if desired...
HP StorageWorks Clustered File System 3.6.1 Windows Storage Server Edition administration guide (AG515 - 96007, August 2008) - Page 305
... inaccessible but HP Clustered File System indicates that it is okay, verify that the server is considered down. Built-In NT Backup Software Fails on the server.
3. This problem typically occurs because either the hostname is not set properly on a PSFS volume, you will need to the network.
2. The PSFS filesystem does not support volume shadow...
HP StorageWorks 4400 Scalable NAS File Services wiring diagrams (AN595-96002, September 2008) - Page 1
... StorageWorks
4400 Scalable NAS File Services wiring diagrams
HP technical support
For worldwide technical support information, see the following information:
• Product model names and numbers • Technical support registration number (if applicable) • Product serial numbers • Error messages • Operating system type and revision level • Detailed questions
Back...
HP StorageWorks 4400 Scalable NAS File Services wiring diagrams (AN595-96005, January 2009) - Page 1
... of KVM 5. DL380 G5 Server 3 9. ProCurve 2824 network switch
2. EVA4400 M6412 JBODs
8. HP StorageWorks
4400 Scalable NAS File Services wiring diagrams
HP technical support
For worldwide technical support information, see the HP support website:
http://www.hp.com/support
Before contacting HP, collect the following information:
• Product model names and numbers • Technical...
HP StorageWorks 4400 Scalable NAS File Services wiring diagrams (AN595-96008, October 2009) - Page 1
...
4400 Scalable NAS File Services wiring diagrams
HP technical support
For worldwide technical support information, see the HP support website:
http://www.hp.com/support
Before contacting HP, collect the following information:
• Product model names and numbers • Technical support registration number (if applicable) • Product serial numbers • Error messages • Operating...
3.7.0 HP StorageWorks HP Scalable NAS File Serving Software administration guide - HP Scalable NAS 3.7 for Linux (AG513-96002, O - Page 18
...inactive server 390 Troubleshoot monitor problems 391
Monitor status 391 "Down" status 391 "Undefined" status 391 "SYSTEM ERROR" status 391 "Unknown" status 391 "Event" status 392 Clear an error 393
Monitor activity 393 "Activity Unknown" status 394 "Transitioning" activity 394 "Starting" activity 394 "Stopping" activity 394 Service monitor always down 394
Monitor recovery 395
A HP...
3.7.0 HP StorageWorks HP Scalable NAS File Serving Software administration guide - HP Scalable NAS 3.7 for Linux (AG513-96002, O - Page 316
...
FTP service monitor
By default the FTP service monitor probes TCP port 21 of service monitors
HP Scalable NAS supports the following information.
The message should begin with a failed monitored service. The default time that the service monitor waits for your FTP server. If the probe is five seconds. If there are no errors, the service status remains Up.
HP Scalable...
3.7.0 HP StorageWorks HP Scalable NAS File Serving Software administration guide - HP Scalable NAS 3.7 for Linux (AG513-96002, O - Page 387
...them. The command is in the following activities: • Collect HP Scalable NAS log files with mxcollect • Check the server configuration • Disable a server for maintenance • Troubleshoot a cluster • Troubleshoot service and device monitors
Collect log files with mxcollect
The mxcollect utility collects error event logs that location: /opt/hpcfs/lib/apache/cgi-bin/pmxs...
HP ProLiant DL380G5-WSS Reviews
Do you have an experience with the HP ProLiant DL380G5-WSS that you would like to share?
Earn 750 points for your review!
We have not received any reviews for HP yet.
Earn 750 points for your review!