HP 800 Support and Manuals
Get Help and Manuals for this Hewlett-Packard item
HP 800 Videos
Brabus Rocket 800 (Mercedes-Benz CLS 63 AMG)
Duration: 2:07
Total Views: 50,597
Duration: 2:07
Total Views: 50,597
GT-R BOFTL 94* GTR las Vegas 800 HP
Duration: :34
Total Views: 316
Duration: :34
Total Views: 316
13 HP Honda 4000 PSI Belt Drive Cat on Pull Out Truck Bed. Dan Swede 800-666-1992 [email protected]
Duration: 1:35
Total Views: 2,710
Duration: 1:35
Total Views: 2,710
Porsche 997 Techart Turbo Vs. Audi S2 Coupe 800 HP
Duration: :33
Total Views: 1,727
Duration: :33
Total Views: 1,727
Popular HP 800 Manual Pages
CIFS/9000 Client Release Note, June 2002 - Page 11
... with other PAM modules for Authentication errors. Windows NT - Refer to the CIFS/9000 Client manual for important additional information about use of either Unicode or any of authentication failures.
11 Windows 2000
See Known Problems and Workarounds below . • PAM NTLM now returns correct error codes for password change supports try_first_pass and use_first_pass options. PAM...
HP DLPI Programmer's Guide - Page 11
... of the OSI Reference Model terminology, OSI Data Link Services, and STREAMS.
HP-UX Release Name and Release Identifier
Each HP-UX 11i release has an associated release name and release identifier.
The document printing date and part number indicate the document's current edition. Table 1
HP-UX 11i Releases
Release Identifier
Release Name
Supported Processor Architecture
B.11.11...
HP DLPI Programmer's Guide - Page 20
... 2 in terms of an interface architecture, as well as addressing concepts needed to describe concepts that defines the protocol through which layer the services are used throughout this guide. A model of the data link layer is responsible for the transmission and error-free delivery of bits of the model assumes familiarity with the OSI Reference...
HP DLPI Programmer's Guide - Page 38
... DL_OK_ACK message and failure with a DL_ERROR_ACK message. Message Flow: Disabling a Specific Multicast Address on a Stream
DL_DISABMULTI request
DL_OK acknowledge
DL_PROMISCON_REQ requests the DLS ...is illustrated in Figure 1-8.
Introduction to DLPI DLPI Services
Figure 1-8
DL_ENABMULTI_REQ requests the DLS provider to disable specific multicast addresses on a per stream basis, either ...
HP DLPI Programmer's Guide - Page 93
... or response. dl_errno;
dl_unix_errno
UNIX system error code associated with the failure. dl_errno
DLPI error code associated with the failure. It is used to DL_SYSERR.
DL_ERROR_ACK
Informs the DLS user that prevent the processing of the DLPI 2.0 specification. dl_unix_errno; DL_ERROR_ACK dl_error_primitive
primitive that is set to report UNIX system failures that the...
HP DLPI Programmer's Guide - Page 124
... dl_ack_thresh
maximum number of I PDUs that can be greater than the remote receive window size. New State The resulting state is restarted. This value cannot be received before an acknowledgment is returned. Reasons for Failure DL_OUTSTATE
Primitive was issued from an invalid state. DLPI Primitives Connection-mode Service Primitives
NOTE
Setting the ack...
HP DLPI Programmer's Guide - Page 131
... containing the structure shown below. DL_SYSERR
A system error has occurred and the UNIX system error is indicated in an incorrect format or contained invalid information. The UNIX error returned may be set to (not limited to establish a data link connection. Chapter 2
131 DL_BADQOSTYPE
The quality of service structure type was in the DL_ERROR_ACK. DL_CONNECT_IND
Conveys...
HP DLPI Programmer's Guide - Page 135
... connect indication. Chapter 2
DLPI Primitives Connection-mode Service Primitives
DL_INCON_PENDING. DL_BADQOSPARAM
The quality of that stream is unchanged. DL_BADQOSTYPE
The quality of that stream and the responding stream is DL_DATAXFER. If the request fails, DL_ERROR_ACK is DL_DATAXFER. The UNIX error returned may only be set to (not limited to the only outstanding connect...
HP DLPI Programmer's Guide - Page 177
...; uint32_t
dl_reserved2[2];
} dl_hp_get_drv_param_ioctl_t;
uint32_t
dl_reserved1[2];
Before using other bits that retrieves the driver parameters. uint64_t
dl_value2; dl_duplex
Duplex mode (full or half).
Chapter 3
DLPI Input/Output Controls Supported ioctls
DL_HP_GET_DRV_PARAM_IOCTL
DL_HP_GET_DRV_PARAM_IOCTL is a DLPI defined transparent ioctl that are not defined by using...
HP DLPI Programmer's Guide - Page 11
... 8802/2 (LLC). The document printing date and part number indicate the document's current edition. Document updates may be made . See your HP sales representative for HP-UX 11i. The latest version of the OSI Reference Model terminology, OSI Data Link Services, and STREAMS.
HP-UX Release Name and Release Identifier
Each HP-UX 11i release has an associated release...
HP DLPI Programmer's Guide - Page 20
...error-free delivery of bits of information over a physical communications medium. The model is described in the OSI Reference Model) is presented here to identify different components of that architecture. The Service Interface
Each layer of the OSI Reference Model... through which layer the services are used throughout this guide. The model defines networking functionality at several layers and...
HP DLPI Programmer's Guide - Page 38
... DL_ERROR_ACK message.
38
Chapter 1 The provider indicates success with a DL_OK_ACK message and failure with a DL_ERROR_ACK message. Introduction to DLPI DLPI Services
Figure 1-8
DL_ENABMULTI_REQ requests the DLS provider to disable specific multicast addresses on a per stream basis. The provider indicates success with a DL_OK_ACK message and failure with a DL_ERROR_ACK message.
The normal...
HP DLPI Programmer's Guide - Page 132
... UNIX error returned may be set to (not limited to) errors listed in state DL_DATAXFER. Format The message consists of service parameters ...Service Primitives
Response There is indicated in the DL_ERROR_ACK. If the request is erroneous, DL_ERROR_ACK is returned and the resulting state is sent to the connect request. Reasons for Failure DL_BADADDR
The destination DLSAP address was not supported...
HP DLPI Programmer's Guide - Page 136
... not supported by the parameter dl_res_token), the resulting state is unchanged.
These streams may be the same when the response corresponds to ) errors listed in the DL_ERROR_ACK. If the current stream and responding stream are the same, the resulting state of service parameters contained invalid values. The UNIX error returned may only be set to...
HP DLPI Programmer's Guide - Page 179
...8226; DLPI does not interpret the request of this request between the driver's user space application and the driver.
• The DL_HP_SERIALIZE bit is an enumeration of type dl_hp_drv_param_req_type_t ...Mbits/sec.
uint64_t
dl_value3; Chapter 3
DLPI Input/Output Controls Supported ioctls
DL_HP_GET_DRV_PARAM_IOCTL
DL_HP_GET_DRV_PARAM_IOCTL is an enumeration of type dl_hp_duplex_mode_t (see...
HP 800 Reviews
We have not received any reviews for HP yet.