Use and Care Manual
Page 16
In an area where it will come in contact with a maximum slope of door rOUgH-In DIMEnSIOnS FRONT 27.0" (68.6 cm) 20.4" (51.9 cm) ELECTRONIC TRANSPARENT VISOR 2.2" (5.6 cm) 40.6"* (103.1 cm) SIDE 30.6" (77.7 cm) 1.6" (3.9 cm) 40.6"* (103.1cm) 39.1" (99.2 cm) *NOTE: With ... On carpet. nOtE: If floor is in . (387 cm2), located 3″ (7.6 cm) from top and bottom of 1/2″ per foot (1.27 cm per 30 cm). To make sure the washer does not vibrate or move, you may have to the existing floor covering. In an area exposed to dripping water or outside weather...
In an area where it will come in contact with a maximum slope of door rOUgH-In DIMEnSIOnS FRONT 27.0" (68.6 cm) 20.4" (51.9 cm) ELECTRONIC TRANSPARENT VISOR 2.2" (5.6 cm) 40.6"* (103.1 cm) SIDE 30.6" (77.7 cm) 1.6" (3.9 cm) 40.6"* (103.1cm) 39.1" (99.2 cm) *NOTE: With ... On carpet. nOtE: If floor is in . (387 cm2), located 3″ (7.6 cm) from top and bottom of 1/2″ per foot (1.27 cm per 30 cm). To make sure the washer does not vibrate or move, you may have to the existing floor covering. In an area exposed to dripping water or outside weather...
Use and Care Manual
Page 19
... be able to help move the washer to flush the water lines and remove particles that all four rubber leveling legs are extended, the more the washer will vibrate. Do not crossthread or over-tighten these connections. 4. Adjust the front leveling legs up the water valve ...screens. 2. Installation Instructions InStaLLIng tHE WaSHEr 1. Connect the inlet hose ends to ensure the washer is installed under a counter, the washer should not be...
... be able to help move the washer to flush the water lines and remove particles that all four rubber leveling legs are extended, the more the washer will vibrate. Do not crossthread or over-tighten these connections. 4. Adjust the front leveling legs up the water valve ...screens. 2. Installation Instructions InStaLLIng tHE WaSHEr 1. Connect the inlet hose ends to ensure the washer is installed under a counter, the washer should not be...
Use and Care Manual
Page 22
... done. vibration or shaking No power/washer not working outlet. • Turn both hot and cold faucets fully on page 11. • Remove loose items from pockets. • Fasten snaps, hooks, buttons and zippers. See recommended maximum load sizes on . • Check house circuit breakers/fuses. this is normal Incorrect operation • Front-load washers start...
... done. vibration or shaking No power/washer not working outlet. • Turn both hot and cold faucets fully on page 11. • Remove loose items from pockets. • Fasten snaps, hooks, buttons and zippers. See recommended maximum load sizes on . • Check house circuit breakers/fuses. this is normal Incorrect operation • Front-load washers start...
