GE DPVH890EJWW Support and Manuals
Get Help and Manuals for this General Electric item
View All Support Options Below
Free GE DPVH890EJWW manuals!
Problems with GE DPVH890EJWW?
Ask a Question
Free GE DPVH890EJWW manuals!
Problems with GE DPVH890EJWW?
Ask a Question
Most Recent GE DPVH890EJWW Questions
How Do You Chande The Belt
(Posted by barry51163 9 years ago)
My Belt Isnt Turning In My Ge Electric Dryer
(Posted by barry51163 9 years ago)
Popular GE DPVH890EJWW Manual Pages
Owners Manual - Page 1
...Dryer 18-21 Connecting an Electric Dryer 22-24 Exhausting the Dryer 25-31 Final Setup 32 Installing the Pedestal 42-44 Location of your Dryer 15, 16 Reversing the Door Swing . . . . . .33-38 Stacking the Washer and Dryer 39-41
Troubleshooting Tips . . . . . .45-48
Consumer Support
Consumer Support Back Cover Warranty (Canada 50 Warranty (U.S 49
Owner's Manual & Installation Instructions...
Owners Manual - Page 4
... Do not touch the steam port after opening. DO NOT ATTEMPT TO LIGHT WITH A MATCH.
Safety Instructions
Operating Instructions
IMPORTANT SAFETY INFORMATION.
SAVE THESE INSTRUCTIONS
Troubleshooting Tips
Consumer Support
4 Burns may wish to prevent children from having your hand in poor dewrinkling performance. Additionally, it from service, remove the dryer door to soften your...
Owners Manual - Page 12
... shade
Troubleshooting Tips
Consumer Support
Care and Cleaning of the Dryer
Dryer Interior and Duct: The interior of the appliance and exhaust duct should be damaged by pulling straight up. A waxy buildup may cause fabric softener stains. Make sure that there is not covered by qualified service personnel. For example, do not wash)
Heat setting
High
Medium
Low...
Owners Manual - Page 13
... to be installed to interface with the local utility company to the module are starting until the level becomes Medium or Low.
The appliance will automatically extend these cycles. The following demand response features are 4 power levels available: Critical, High, Medium and Low. Operating Instructions
Troubleshooting Tips
Wait 5 minutes; then press the Settings button. On...
Owners Manual - Page 14
...8226; Service information and the wiring diagram are located
in any location where it could be exhausted to the outdoors. • Use only 4″ rigid metal ducting for local
electrical inspector's use.
• IMPORTANT - Observe all installation instructions.
• Clothes dryer installation must be UL-listed and installed in "Connecting the Dryer to Consumer - Gas appliances can be...
Owners Manual - Page 16
... at least 25 sq. If the closet contains both a washer and a dryer, doors must conform with local codes or, in the same closet with the NATIONAL ELECTRICAL CODE, ANSI/NFPA NO. 70 (for electric dryers) or NATIONAL FUEL GAS CODE, ANSI Z223 (for gas dryers). See EXHAUSTING THE DRYER.
• The installation must contain a minimum of 120 square inches of gas...
Owners Manual - Page 21
... provided does not meet the above specifications, it is equipped
with the NATIONAL ELECTRICAL CODE, ANSI/NFPA NO. 70.
Check all connections for gas leaks. If leaks are found, close the valve, retighten the joint and repeat the soap test.
ELECTRICAL CONNECTION INFORMATION FOR GAS DRYERS
WARNING - Never use .
Installation Instructions
TEST FOR LEAKS
WARNING - Ensure proper...
Owners Manual - Page 28
Installation Instructions EXHAUSTING THE DRYER (cont.)
BEFORE YOU BEGIN
• Remove and discard existing plastic or metal foil duct and replace with duct tape or a hose clamp. Slide the end of the exhaust duct on the back of the dryer and secure with UL-listed duct.
• Remove any lint from the wall exhaust opening.
Internal...
Owners Manual - Page 29
...of the appliance base. CAUTION: Do not pull or damage the
electrical wires and do not remove the vinyl cover from the electrical components inside the dryer exhaust duct...Electric models.
Lift the tab to the blower housing. PROTECT YOUR HANDS AND ARMS FROM SHARP EDGES WHEN WORKING INSIDE THE CABINET.
Dryer Exhaust to right of the dryer. Installation Instructions
SIDE VENTING:
Dryer...
Owners Manual - Page 31
Installation Instructions
BOTTOM VENTING (cont.)
ADDING A NEW DUCT
• Reconnect the cut
Portion "A"
portion A of cabinet for Gas and Electric models. Rotate the elbow through the bottom opening with a plate (Kit WE1M454) available from the rear opening , drill a 1/8″ hole through the elbow and pipe.
Fixing hole
• Tape the elbow in a 90-degree position to...
Owners Manual - Page 41
...Using a Phillips screwdriver, attach the 2 #8 x 1/2″ tapping screws. Repeat the above step with the holes in pinched fingers.
4 INSTALL DRYER AND BRACKET ON WASHER
Place hands here
Place hands here
A. Set the dryer upright. Refer to the washer Installation Instructions to install the 2 #12 x 1″ tapping screws. C. Align the holes in the left corner of its weight and size...
Owners Manual - Page 44
... each
side.
Drawer Divider
Align the
drawer
supports to be tight.
6 REMOVE SHIPPING SCREWS
Remove the 4 shipping screws on the back side of the pedestal. Move it closed . Installation Instructions INSTALLING THE PEDESTAL (if desired) (cont.)
4 LEVEL THE WASHER OR DRYER
A Stand the washer or dryer upright. B Make sure that the washer or dryer is level by placing a level on each...
Owners Manual - Page 45
... every load.
• Replace fuses or reset circuit breakers. GEAppliances.com
Operating Instructions
Troubleshooting Tips
PROBLEM Dryer shakes or makes noise Clothes take longer to call for 3 seconds to ensure proper tumbling.
When the dryer senses a low level of heavy and light fabrics
• When combining heavy and light fabrics in the load, the dryer will display the dry...
Owners Manual - Page 49
...serial number and model number available when calling for any labor or related service costs.
Warrantor: General Electric Company. The extra-large or super-capacity dryer drum and main electronic control board if any succeeding owner for products purchased for home use the product.
■ Improper installation, delivery or maintenance.
■ Failure of these parts should fail due...
Owners Manual - Page 156
... GEAppliances.com
Expert GE repair service is still in the packing material. Get on -line anytime, or call 1.800.561.3344
Real Life Design Studio
In the U.S.: GEAppliances.com
GE supports the Universal Design concept-products, services and environments that are available while your
phone number, or write to:
General Manager, Customer Relations
GE Appliances, Appliance Park
Louisville...
GE DPVH890EJWW Reviews
We have not received any reviews for GE yet.