GE 45117 - Deluxe Wireless Door Alarm Support and Manuals
Get Help and Manuals for this General Electric item
Most Recent GE 45117 Questions
Red Blinking Light On Ge Deluxe Home Door Alarm.
I have entered my code. It was accepted and the alarm is mounted on the door but the red light conti...
I have entered my code. It was accepted and the alarm is mounted on the door but the red light conti...
(Posted by cashionfam2011 2 years ago)
Has This Product Been Listed As Being In Compliance With Ul 2017
(Posted by MikeKrenn 8 years ago)
Ge 45117 Deluxe Wireless Door Alarm What Kind Of Door Do You Need?
(Posted by wallwi 9 years ago)
How Loud Is The Deluxe Ge Door Alarm
(Posted by andgial 9 years ago)
How To Adjust Volume?
Try to adjust the volume. How do I do that its too loud for the space it is in.
Try to adjust the volume. How do I do that its too loud for the space it is in.
(Posted by tarafitz07 10 years ago)
Popular GE 45117 Manual Pages
User Manual - Page 1
Personal Security
Deluxe Door Alarm User Manual
Do not use in wet locations
User Manual - Page 3
Average battery life for typical usage is up to one year. When the batteries reach a low level, the indicator light will flash slowly. Deluxe Door Alarm
Keypad Controlled
Home/ Away Switch
Indicator Light
Alarm/ Chime Switch
Magnet
Screws
Keypad
Learn LEARN
button Doublesided tape
Mounting Plate
Battery Compartment
Low Battery Indicator The alarm unit has a low battery circuit.
User Manual - Page 4
To install the batteries:
1.
INSTALLING BATTERIES The keypad controlled door alarm requires three (3) AAA Alkaline batteries (not included).
Slide off the door in the direction of the unit. Replace door and secure screw. Insert three (3) AAA batteries noting the polarity diagram inside the battery compartment .
3. Remove screw from battery compartment door located on back of the ...
User Manual - Page 5
... code. Replace cover and
secure screw. The unit will flash a green light 3 times to set a personal 4-digit code for 15 seconds. Slide off the door in the direction of the alarm
will confirm each input. LEARN
.
CREATING YOUR PERSONAL ALARM CODE The keypad allows you to
Learn button
confirm the new 4-digit
code has been saved. Remove screw from battery...
User Manual - Page 6
... or to the door itself. Recommended Mounting Method Alternate Mounting Method Use either the provided screws (for permanent mounting) or double-sided tape (for alarm. The alarm is the back of the door, with the magnet mounted to the door ensures that the alarm will not be damaged by opening and closing the door.
INSTALLATION 1. Select desired location...
User Manual - Page 7
... the back side of the double-sided tape and then apply to mounting plate.
Attach the mounting plate to either side of the alarm. Distance must be less than 1/2"
IMPORTANT: Whether mounting to the door or door frame, the gap distance between the alarm and magnet must be mounted to the back of the...
User Manual - Page 8
NOTE: When mounting to is final.
double-sided tape and lightly mount the alarm in the desired position. Double-sided tape
Mounting Plate Alarm
Do not apply firm pressure until location is clean and dry. For best results, clean the mounting surface with a mixture of 50% isopropyl alcohol and 50% water.
Make sure the surface you are mounting to a door
User Manual - Page 9
... the left or right in order to position alarm closest to the edge of the door.
3. If it does not sound, move either the alarm or magnet closer so that gap distance is 1/2" or less. To test the gap distance, slide the ALARM/CHIME switch to the alarm. If chime sounds, then the gap distance is correct...
User Manual - Page 10
10
plate itself. Apply firm pressure to the magnet to ALARM position. 3. OPERATING IN THE ALARM MODE 1. Choose HOME or AWAY on right side of the alarm unit. Locate ALARM/CHIME switch on the left side of the alarm unit. 2. Slide switch to secure its position as well.
the door is greater than 1/2" (i.e. HOME MODE In HOME mode...
User Manual - Page 11
... correctly the unit will sound a higher tone and flash red 3 times. When the 4 digit code is a 30 second delay to allow time to leave the protected area without triggering the alarm. Arm the alarm by pressing your 4-digit code. The delay allows time for you that the unit has been activated and has begun...
User Manual - Page 12
... respond with two tones and will flash red 3 times. Enter the correct code anytime after the light stops flashing. Re-enter the correct code after the alarm has sounded to disarm the alarm. When the fourth digit of hearing damage. Enter your code is entered, the unit will sound a louder beep and will flash a green...
User Manual - Page 13
... sound immediately if the distance between the alarm and magnet is opened). Deactivating the Chime: 1. To deactivate the chime slide ALARM/ CHIME switch to CHIME mode. Do not use a soft cloth slightly dampened with water and wipe dry. 13
OPERATING IN THE CHIME MODE 1. the door is greater than 1/2" (i.e.
Slide switch to ALARM position. CARE AND MAINTENANCE To clean...
User Manual - Page 14
..., or other adverse events. improper maintenance; dead or improperly installed batteries; 14
WARNING Limitations of Alarm Products
This product should protect themselves with proper insurance. However,...range and certain environmental conditions may impact performance and audible alarm signals may be outside of hearing range, muted by doors, walls, and floors, unheard by deep sleepers or ...
User Manual - Page 15
..., OK 73114.
45117 9/17/2007
Please contact Customer Service at the same time • Replace fully discharged batteries immediately
For indoor use in wet locations. 15
WARNING Risk of the General Electric Company and is a trademark of personal injury • Prolonged exposure to Jasco Products Company LLC, 10 E. is used under license to alarm siren may cause...
User Manual - Page 16
...FCC Rules. 16
NOTE: This equipment has been tested and found to comply with the instructions, may cause harmful interference to radio communications. However, there is connected.
• ...to which can radiate radio frequency energy and, if not installed and used in a particular installation. These limits are designed to Part 15 of the following measures:
• Reorient or relocate...
GE 45117 Reviews
We have not received any reviews for GE yet.