Fluke 190-204/AM Support and Manuals
Get Help and Manuals for this Fluke item
View All Support Options Below
Free Fluke 190-204/AM manuals!
Problems with Fluke 190-204/AM?
Ask a Question
Free Fluke 190-204/AM manuals!
Problems with Fluke 190-204/AM?
Ask a Question
Popular Fluke 190-204/AM Manual Pages
Product Manual - Page 1
... shunt).
All rights reserved. e products online at: www.
.com
1.888.6
Specifications are trademarks of 4 mA to 1000 V dc can be used for the 17xx...a current loop of their respective companies. Auxiliary Input Adapter
for 17xx Power and Energy Loggers
Instructions
Introduction
The Auxiliary Input Adapter (or Product) is an accessory for other applications such as solar energy...
Product Manual - Page 2
... personal injury:
• Read all safety information before you use the Product.
• Carefully read all instructions.
• Use the Product only as specified, or the protection supplied by the Product can cause damage to the user. Safety Information
A Warning identifies conditions and procedures that can be compromised.
• Do not touch...
Product Manual - Page 3
... are damaged. Check test lead continuity.
• Remove the input signals before you clean the Product.
• Use only cables with local and national safety codes.
Product Manual - Page 4
...www.
.com 1.888.6 MyFlukeStore e products online at the source of electric shock.
Consult user documentation.
P
Conforms to European Union directives.
)
~
Certified by CSA Group to relevant ... applicable to the distribution part of the building's low-voltage MAINS installation.
Measurement Category IV is classed as unsorted municipal waste.
Product Manual - Page 5
... D. MyFlukeStore e products online at: www.
.com 1.888.6 Direct Input 0 V DC to achieve the ingress protection of IP50. Note The dummy plug or a cable must be installed to 10 V DC Configuration
To connect the Adapter: 1. Make sure that all 4 mm safety test leads are disconnected. 2. Loosen the 4 captive screws and remove...
Product Manual - Page 6
Insert the sensor cable through the strain relief . Note Pay attention to Custom 5), and use these settings:
• Sensor: 0-10 V • Unit: V • Minimum: 0 V • Maximum: 1000 V
MyFlukeStore e products online at the same time.
Use correctly rated 4 mm test leads on the ...
Product Manual - Page 7
Specifications
General
Calibration Cycle 2 years Warranty 1 year Dimensions 119 mm x 86 mm x 38 mm
(4.69 in x 3.39 in x 1.5 in) Weight 280 g (0.6 lb) Output Cable Length .......... 1.9 m (6.2 ft)
...
Product Manual - Page 8
Accuracy
Input
Range
Intrinsic Accuracy Aux Adapter + Instrument
(% of Reading + % of Range)
Direct Input
±10 V
see instrument specification
Voltage divider input ±1000 V ±(0.5% + 0.002%)
Note:
Environmental Reference Conditions: 23 °C ±5 °C, instrument operating for at least 30 minutes, no external electrical/magnetic field, RH
Product Manual - Page 10
..., this limitation of the problem. P.O. This warranty does not cover fuses, disposable batteries, or damage from the date of purchase. Fluke Corporation P.O.
Box 1186 5602 BD Eindhoven The Netherlands
11/99
MyFlukeStore e products online at: www.
.com 1.888.6 To obtain service during the warranty period, contact your nearest Fluke authorized service center to obtain return...
Fluke 190-204/AM Reviews
We have not received any reviews for Fluke yet.