D-Link DFE-2616IX - Hub - Stackable Support and Manuals
Get Help and Manuals for this D-Link item
View All Support Options Below
Free D-Link DFE-2616IX manuals!
Problems with D-Link DFE-2616IX?
Ask a Question
Free D-Link DFE-2616IX manuals!
Problems with D-Link DFE-2616IX?
Ask a Question
Popular D-Link DFE-2616IX Manual Pages
User Guide - Page 5
... / telephone / fax contact list of this manual, must be completed and sent to any update which may be to replace any defective software product with any hardware, or any application or system/platform software product provided by D-Link pursuant to this software warranty shall be provided for warranty service on a hardware product, or software product...
User Guide - Page 11
... in this manual to , FE-2600 series master hubs."
All x" models have 24 ports.
DFE-2616i, DFE-2616ix, DFE-2624i, and DFE-2624ix hubs are differentiated by referring to the DFE-2616, DFE-2616x, DFE-2624, DFE2624x; Model numbers are intelligent (that is, anaged") hubs capable of the rear panel. All " models are normally used only to install and use the DFE-2600 series...
User Guide - Page 12
..., all models. Describes the DFE-2600 series master hub boot configuration file.
♦ Appendix C, Specifications. xii
About This Guide Overview of the DFE-2600 series hubs.
♦ Chapter 2, Unpacking and Setup. Provides information on connecting to all information applies to the hub twisted-pair and console ports, stacking hubs, and linking with the hubs.
♦ Appendix...
User Guide - Page 13
...models, can connect all of your Ethernet and Fast Ethernet hosts to a DFE-2600 series hub stack, without any rewiring required when a host is upgraded from 10Mbps to 100Mbps. Introduction
1 1
1 INTRODUCTION
This chapter introduces the DFE...operating at 100 megabits per second). All of the twisted-pair ports support NWay autonegotiation, allowing the hub to another Class II Fast Ethernet stack ...
User Guide - Page 15
...replaced. Automatic voltage selection (100V to 240V, 50 or 60Hz) without opening the hub. ♦ Full hub stack and network management provided via a master hub.
♦ Standby backup master capability when two master model hubs are present within a single stack.
♦ Uplink port allows easy linking...via an SNMP management agent (DFE-2616i, DFE-2616ix, DFE-2624i, DFE-2624ix).
♦ An ...
User Guide - Page 19
Front Panel
DFE-2624i / DFE-2624ix Front Panel
DFE-2624 / DFE-2624x Front Panel
DFE-2616i / DFE-2616ix Front Panel
DFE-2616 / DFE-2616x Front Panel
Unpacking and Setup
7 Both the front and rear panels are shown, followed by a description of the hub.
Identifying... components of each panel feature. The indicator panel is damaged or missing, report the problem to your D-Link dealer.
User Guide - Page 21
... Port -- Master Models Only
Unpacking and Setup
9 Connect this ...install module options for various kinds of additional connections, as well as the DFE-260S 10Mbps/100Mbps bridge module. (In the DFE-2616x, DFE-2616ix, DFE-2624x and DFE-2624ix, module slot 1 is already occupied by the switch module which is standard on these models.)
♦ Daisy-Chain IN Port
When cascading a set of D-Link...
User Guide - Page 31
... if a 10BASE-T device is a DFE-2616i, DFE-2616ix, DFE-2624i, or DFE-2624ix master hub in the stack, then ports can choose to prevent a certain device from accessing the network. SNMP Indicator
(Master models only) This indicator comes on -board console interface or via an SNMP-based network management program such as D-Link D-View Network Management Program...
User Guide - Page 43
... the primary master segment. NOTE:
In a stack containing a DFE-2616i, DFE-2624i, DFE-2616ix, or DFE-2624ix intelligent master hub, more than one included in the DFE2616x, DFE-2616ix, DFE-2624x or DFE-2624ix) to provide increased reliability through redundancy. Dividing the stacks into separate domains. Note that the DFE-260S module can be installed in the hub or hub stack.
User Guide - Page 47
...set up and control all DFE-2600 hubs stacked with an ordinary terminal (or terminal emulator) or over the network using D-View or another SNMP-based network management system.
5
5 MASTER HUB SETUP AND MANAGEMENT
The DFE-2616i, DFE-2616ix, DFE-2624i, and DFE... Hub Setup and Management
35 This program can use the console program to follow the instructions in the first section of Chapter 4.
User Guide - Page 60
..., as well as updated versions of -band. This parameter can set to either Network or Out-of its internal firmware, using TFTP (the Trivial File Transfer Protocol) and BOOTP (the BOOTstrap Protocol). If set on Boot
The hub is enabled.
48
Master Hub Setup and Management
Dual-Speed Stackable Hubs User's Guide
DFE-2600 Stackable Hub - You...
User Guide - Page 72
...Stack
The hub supports several monitoring ...port.
60
Master Hub Setup and Management Network Monitoring : Port State Menu
Group ID(1-8) [1] Connector Type: UTP
Port ID(1-24) [1 ]
Port Status
Link Test:
Up
Receive Polarity:...NEXT PORT to switch to a different port.
DFE-2600 Stackable Hub - This field displays the port current speed setting, Auto for auto-detect/correct, 100M for ...
User Guide - Page 83
... the network through a standard browser such as a universal access tool and can communicate directly with the screen-shots (pictures) in their model numbers and include the DFE-2616i, DFE-2616ix, DFE-2624i and the DFE-2624ix. NOTE:
This Web-based Management Module does not accept Chinese language input (or other languages requiring 2 bytes per character).
Your...
User Guide - Page 90
...tftp or tftp only. If you are described as follows:
♦ Software Update Mode Set to either network or out-of the TFTP server where the configuration file is...9830; Software Update Control Determines whether or not the Hub should be obtained from the BOOTP server.
♦ Boot Server Address The IP address of -band. Dual-Speed Stackable Hub Web-based Management User's Guide
The fields ...
User Guide - Page 131
.../CD Network Data Transfer Rate: Fast Ethernet, 100Mbps; UTP Cat 5, 100-ohm UTP/STP (5m maximum) for hub-to -hub linking
Specifications
119 Ethernet, 10Mbps Number of Ports: 16 (DFE-2616i / DFE-2616ix / DFE-2616 / DFE-2616x) or 24 (DFE-2624i / DFE-2624ix / DFE-2624 / DFE-2624x) 10BASE-T / 100BASE-TX ports Network Media: Ethernet: Category 3 or better UTP cable, 100m maximum...
D-Link DFE-2616IX Reviews
We have not received any reviews for D-Link yet.