Cisco CISCO7304 - 7300 Modular Expansion Base Support and Manuals
Get Help and Manuals for this Cisco item
View All Support Options Below
Free Cisco CISCO7304 manuals!
Problems with Cisco CISCO7304?
Ask a Question
Free Cisco CISCO7304 manuals!
Problems with Cisco CISCO7304?
Ask a Question
Popular Cisco CISCO7304 Manual Pages
Configuration Guide - Page 7
... 6-5 Load Balancing Using Port Channels 6-6 LACP 6-8 Virtualization Support 6-13 High Availability 6-13 Licensing Requirements for Port Channeling 6-14 Prerequisites for Port Channeling 6-14 Guidelines and Limitations 6-14 Default Settings 6-15 Configuring Port Channels 6-15 Creating a Port Channel 6-16
OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
vii
Configuration Guide - Page 9
... document comments to nexus7k-docfeedback@cisco.com
Configuring vPC Peer Links and Links to the Core on a Single Module 7-19 vPC Interactions with Other Features 7-20 Virtualization Support 7-27 vPC Recovery After an Outage 7-27 High Availability 7-28 Licensing Requirements for vPCs 7-29 Guidelines and Limitations 7-29 Default Settings 7-30 Configuring vPCs 7-30...
Configuration Guide - Page 16
... Commands and keywords are in -Q) VLAN tunnels and Layer 2 protocol tunneling. Chapter A, "IETF RFCs supported by vertical bars. A nonquoted set of code
indicates a comment line. Document Conventions
Preface
Send document comments to nexus7k-docfeedback@cisco.com
Chapter
Description
Chapter 8, "Configuring IP Tunnels"
Describes how to system prompts are optional.
Document...
Configuration Guide - Page 17
... loss of data.
The RSS feeds are a free service. OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
xvii Preface
Document Conventions
Send document comments to nexus7k-docfeedback@cisco.com
Caution Means reader be delivered directly to your desktop using a reader application. Cisco currently supports RSS Version 2.0. In this situation, you might...
Configuration Guide - Page 19
..., error disable, flow control, MTU, beacon
Chapter 2, "Configuring Basic Interface Parameters" of this document
Layer 2 access and trunk port settings
Chapter 3, "Configuring Layer 2 Interfaces" of the interface types supported. Table 1-1 shows where to nexus7k-docfeedback@cisco.com
1 C H A P T E R
Overview
This chapter provides an overview of these parameters are covered in this guide...
Configuration Guide - Page 37
... desired, set the local port receive parameter to enabled.
-
OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
2-13 You can change a Layer 3 interface into a Layer 3 interface by using the switchport command. You can change a Layer 2 interface into a Layer 2 interface by using Cisco-supported transceivers, use Cisco-supported transceivers...
Configuration Guide - Page 52
...config
2-28
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
or 100-Mb/s speed, the port is automatically configured to use a specific speed, you must set the remote ...that the remote port has a speed setting that you specify can configure together for the local port. Note The interface speed that supports your changes for Ethernet and management ...
Configuration Guide - Page 132
... and destination addresses in -service software upgrades (ISSUs). For the echo response packet, BFD sets the TTL value to 254. ISSU allows you can configure SHA-1 authentication of the Cisco NX-OS licensing scheme, see the Cisco Nexus 7000 Series NX-OS Virtual Device Context Configuration Guide, Release 5.x. Beginning with the Cisco NX-OS system images and...
Configuration Guide - Page 223
...vPC peer link supports 16 LACP interfaces...Guide, Release 5.x, for information on all the vPC port channels, including those channels from the downstream device. With M- If you configure the port channels without using LACP. When you are not configured using LACP, you do not enable any problems if the STP enhancements are already configured, but you set...Note When manually configuring the...
Configuration Guide - Page 225
...support faster convergence of the Cisco Fabric Service over Ethernet (CFSoE) protocol. You can use vPC and STP-based redundancy is not supported. To avoid loops, the vPC peer link is supported... the vPC peers.
OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
7-23 This feature allows a pair of Cisco Nexus 7000 Series devices to address performance...
Configuration Guide - Page 228
...supported on vPC peer devices. When you are back up and down.
CFSoE carries messages and packets for many features linked with vPC enabled, the system displays an error message.
7-26
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide... Cisco Fabric Services...Cisco NX-OS Release 4.2(1), you do not recommend configuring the burnt-in MAC address option (use-bia) for HSRP or manually...
Configuration Guide - Page 230
...You must save this setting in the startup configuration. The device elects itself to be running different releases of Cisco NX-OS, however...upgrade process, locking the first device as the master for the peer adjacency to form.
Beginning with Cisco NX-OS Release 5.0(2), you can configure the Cisco Nexus 7000 Series device to restore vPC services when its backward compatibility support...
Configuration Guide - Page 267
... this feature:
Product Cisco NX-OS
License Requirement
IP tunnels require an Enterprise Services license. PMTUD reduces ... default, Cisco NX-OS places you in the default VDC and default VRF unless you enable PMTUD, the interface sets the Don...
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
8-3 You can configure IP tunnels only in VDC 2.
When you specifically ...
Configuration Guide - Page 268
...supported tunnel interfaces was changed to 4095.
• Cisco NX-OS does not support WCCP on to the switch. • You have installed the Enterprise Services license for Cisco NX-OS. • You must be familiar with Cisco... Assigning VRF Membership to a Tunnel Interface, page 8-8
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
8-4
OL-23435-03 The tunnels are ...
Configuration Guide - Page 283
... Switches in the service-provider network must manually configure the 802.1Q interfaces to be identified in tunnel traffic (for this feature:
Product Cisco NX-OS
License ...Cisco NX-OS licensing scheme, see the Cisco NX-OS Licensing Guide. Any feature not included in a license package is bundled with the Cisco NX-OS system images and is not supported.
• You should perform an EPLD upgrade...
Cisco CISCO7304 Reviews
We have not received any reviews for Cisco yet.