Cisco C7400VPN/K9 - 7400 Router Support and Manuals
Get Help and Manuals for this Cisco item
This item is in your list!
View All Support Options Below
Free Cisco C7400VPN/K9 manuals!
Problems with Cisco C7400VPN/K9?
Ask a Question
Free Cisco C7400VPN/K9 manuals!
Problems with Cisco C7400VPN/K9?
Ask a Question
Popular Cisco C7400VPN/K9 Manual Pages
Configuration Guide - Page 9
... document comments to nexus7k-docfeedback@cisco.com
Configuring vPC Peer Links and Links to the Core on a Single Module 7-19 vPC Interactions with Other Features 7-20 Virtualization Support 7-27 vPC Recovery After an Outage 7-27 High Availability 7-28 Licensing Requirements for vPCs 7-29 Guidelines and Limitations 7-29 Default Settings 7-30 Configuring vPCs 7-30...
Configuration Guide - Page 16
... for which you must enter is in boldface.
A nonquoted set of code
indicates a comment line. Document Conventions
Command descriptions use quotation...Guide, Release 5.x
xvi
OL-23435-03 Document Conventions
Preface
Send document comments to nexus7k-docfeedback@cisco.com
Chapter
Description
Chapter 8, "Configuring IP Tunnels"
Describes how to material not covered in the manual...
Configuration Guide - Page 17
... Documentation as an RSS feed and set content to be careful.
The RSS feeds are a free service. OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
xvii Preface
Document Conventions
Send document comments to the What's New in equipment damage or loss of data. Cisco currently supports RSS Version 2.0.
Obtaining Documentation and...
Configuration Guide - Page 19
... 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
1-1 Most of the interface types supported by the Cisco NX-OS software. Table 1-1 shows where to nexus7k-docfeedback@cisco.com
1 C H A P T E R
Overview
This chapter provides an overview of these parameters are covered in this document
Layer 2 access and trunk port settings
Chapter 3, "Configuring Layer 2 Interfaces" of the...
Configuration Guide - Page 23
... are in the correct VDC. High Availability for Interfaces
IP tunnels and vPCs require the Enterprise Services license. You must install this license on a supervisor switchover.
OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
1-5 A stateful restart occurs on every system that interface if you can create multiple virtual device...
Configuration Guide - Page 37
... port send parameter is configured, set the local port send parameter to enabled.
-
OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
2-13 If you do not know that the remote port receive parameter is a Layer 3 interface. Interfaces with Cisco-supported transceivers are using Cisco-supported transceivers, use Cisco-supported transceivers.
Configuration Guide - Page 52
...
2-28
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
interface interface 3. duplex {full | half | auto} 5. Note The interface speed that supports your changes for an interface, so you should configure both of 1000 Mb/s (1 Gb/s) or faster, full duplex is automatically configured to use a specific speed, you must set the...
Configuration Guide - Page 132
... and default VRF unless you to upgrade software without impacting forwarding. For a complete explanation of BFD packets.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
5-4
OL-23435-03
VRFs exist within virtual device contexts (VDCs).
For all asynchronous and echo request packets, the BFD neighbor sets the TTL value to the BFD...
Configuration Guide - Page 223
...manually configuring the system priority, you need not configure these required matched settings. You can have different system priority values, vPC will not cause any problems...supports 16 LACP interfaces: 8 active links and 8 hot standby links.
A lower numerical value system priority means a higher LACP priority. See the Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide...
Configuration Guide - Page 225
... excluded from both sides of the Cisco Fabric Service over Ethernet (CFSoE) protocol.
vPC Multicast-PIM, IGMP, and IGMP Snooping
Note The Cisco NX-OS software for more information ...topology. The access switch traffic is not supported. You can cause traffic disruption. See the Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.x, for information on STP ...
Configuration Guide - Page 228
...the system displays an error message.
7-26
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL... its active Layer 3 uplinks.
CFSoE
The Cisco Fabric Services over Ethernet (CFSoE) is a reliable state...up , use -bia) for HSRP or manually configuring virtual MAC addresses for when a group ...be converged before the vPC is not supported on FHRPs and routing.
You should...
Configuration Guide - Page 230
...upgraded. You must save this setting in the startup configuration. The device elects itself to be STP primary regardless of its peer fails to come online by using the reload restore command.
We recommend that you can configure the Cisco Nexus 7000 Series device to restore vPC services... See the Cisco Nexus 7000 Series NX-OS High Availability and Redundancy Guide, Release 5.x,...
Configuration Guide - Page 267
...interface sets the Don't Fragment (DF) bit on a supervisor switchover. When you specifically configure ...Support
You can also configure what VRF to use to its destination. PMTUD reduces the send MTU value for this feature:
Product Cisco NX-OS
License Requirement
IP tunnels require an Enterprise Services license.
OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide...
Configuration Guide - Page 268
... Membership to the switch. • You have installed the Enterprise Services license for Cisco NX-OS. • You must be familiar with Cisco NX-OS Release 5.2(5) and for later 5.2(x) releases...Settings
Table 8-1 lists the default settings for IP tunnel parameters.
Guidelines and Limitations
IP tunnels have the following configuration guidelines and limitations:
• Cisco NX-OS supports...
Configuration Guide - Page 283
... and is not supported.
• You should use MAC address-based frame distribution.
• Asymmetrical links do not support the Dynamic Trunking Protocol (DTP) because only one port on the link is based on Cisco Nexus 7000 Series devices. For a complete explanation of the Cisco NX-OS licensing scheme, see the Cisco NX-OS Licensing Guide.
Cisco C7400VPN/K9 Reviews
Do you have an experience with the Cisco C7400VPN/K9 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Cisco yet.
Earn 750 points for your review!