eMachines EL1300G-02w Support Question
eMachines EL1300G-02w Support Question
Find answers below for this question about eMachines EL1300G-02w - 2 GB RAM.Need a eMachines EL1300G-02w manual? We have 1 online manual for this item!
Current Answers
Related eMachines EL1300G-02w Manual Pages
User Guide - Page 5
..., since improper adjustment of other risks. iii Product servicing
Do not attempt to service this product yourself, as opening or removing covers may result in damage and will often require extensive work by a qualified technician to restore the product to dangerous voltage points or other controls may expose you need for
service...
User Guide - Page 7
..., bad posture, poor work habits, stress, inadequate working in one fixed posture • avoid slouching forward and/or leaning backward • stand up and walk around regularly to remove the strain on how to relax your neck and shoulders • avoid tensing your muscles or shrugging your company's health and safety department. Observe...
User Guide - Page 8
... possible. • Exercise regularly and maintain a healthy body. If this is unavoidable, work habits to a comfortable level for
enhanced text readability and graphics clarity. • Eliminate ...-reduction filter • using the computer on a couch or bed.
Developing good work habits
Develop the following work for extended
periods of time. :
• Blink frequently to keep your eyes ...
User Guide - Page 9
Contents
Chapter 1: Checking Out Your Computer . . . 1
About this guide 2 Product Registration 2 Front 3 Back 4
Chapter 2: Setting Up and Getting Started 7
Working safely and comfortably 8 Avoiding discomfort and injury from repetitive strain 8
Preparing power connections 9 Protecting from power source problems 9 Checking the voltage selection 10
Connecting to a ...
User Guide - Page 18
... to avoid excessive
repetition.
• Take breaks to change your position,
stretch your muscles, and relieve your eyes.
• Find ways to break up the work area and avoiding discomfort and strain:
• Keep hands and arms parallel to the
floor.
• Adjust the screen so it is perpendicular to
your...
User Guide - Page 19
If you run your computer long enough to save your work and shut down your computer normally.
9
Preparing power connections
Protecting from reaching your computer. During an electrical storm, unplug both the power cord and the ...
User Guide - Page 22
Chapter 2: Setting Up and Getting Started
2 Insert the other end of the modem cable into a telephone wall jack. (The modem will not work with digital or PBX telephone lines.)
3 If you want, you can connect a telephone to the PHONE jack on the modem on the back of related ...
User Guide - Page 27
...
• 4-port switch to eliminate the need to ISP. If the connection is working , contact your current setup. When buying your router, be activated. Before you begin... onto the Internet using for setting up wired Ethernet network hardware
Making sure your broadband connection works Important
If you need for
additional network hardware
• DHCP server/dynamic IP address assignment ...
User Guide - Page 36
...is turned on.
• If a peripheral device (such as a keyboard
or mouse) does not work, make sure that you followed each instruction.
• If an error occurs in a program, see the...online help Customer Care in diagnosing and fixing the problem.
• If you added or removed peripheral
devices, review the installation procedures you performed and make sure that all connections are listed...
User Guide - Page 37
..." on your network
• Make sure that your
network have the same workgroup name.
27 For more information, see the documentation that all computers are working.
User Guide - Page 43
... poster that a key is
plugged in correctly. A keyboard character keeps repeating or you know works to
make sure that the keyboard cable is not stuck. Let the keyboard dry before using ....
33 Press
each key to loosen a key that might be stuck, then restart your computer.
• Remove all extension cables and switch
boxes.
• Clean the keyboard by using it again. Memory
Help
For more...
User Guide - Page 44
... Make sure that the modem cable is less
than 6 feet (1.8 meters) long.
• Remove any line splitters or surge
protectors from your
computer. Memory card reader
Drive letters for additional troubleshooting...all programs, then restart your telephone line, then check for a dial tone by plugging a working telephone into the modem jack and not the Ethernet network jack. Modem (dial-up)
See ...
User Guide - Page 45
The faster the modem, the less line noise it can tolerate and still work with your modem.
• Check for line noise (scratchy, crackling,
or popping...
35 Help
For more information about dialing properties, click Start, then click Help and Support. These lines do not work correctly. Listen to see if that makes a difference. Wiggle the modem cable to the line using a
digital, ...
User Guide - Page 46
... fax technology only supports a
maximum send and receive rate of 14,400 bps.
36 If your ISP for technical support.
• See if the modem works with just one program.
• Review the troubleshooting information
under "Internet" on this line, call your telephone service.
User Guide - Page 47
The modem is not recognized by your computer
• Make sure that the line connected to the
modem is working and plugged into the appropriate port on your computer. • Run Windows modem diagnostics.
Monitor
The screen resolution is a digital "getting acquainted" conversation between the ...
User Guide - Page 48
...; Shut down and restart your computer. • Remove all extension cables and switch
boxes.
• Try a mouse you know is working to
make sure that you know works
to read
• Adjust the brightness and contrast
controls....
• Change the display settings. Mouse
The mouse does not work
• Make sure that the mouse cable is
plugged in the Search box, then...
User Guide - Page 49
The mouse works erratically
• If the mouse pointer begins moving
erratically across the computer display or becomes difficult to control precisely, cleaning the mouse will likely improve ...
User Guide - Page 51
... DVD drive's regional code must match. Power
Your computer will not turn it on , and working device, such as a lamp, into the outlet and turn on .
• If your... code must match the regional code for the United States and Canada is 1. To test the outlet, plug a working correctly. Replace any damaged cables.
41 The regional code for the disc.
If the DVD movie does not play ...
User Guide - Page 52
... online.
• Check the cable for bent or broken pins. • If the printer you have selected it is connected to is not set to
work offline.
• Wait until files have an online/offline button that you may need to press after adding paper.
42 See the printer documentation for...
User Guide - Page 54
... instructions, see "Returning your system to its factory condition" on page 47.
44 Recovery discs take some or all of software or hardware have stopped working correctly, the problem may be solved by reinstalling the software or the device drivers. For instructions on page 47.
4 Reset your system to its factory...
Similar Questions
How Do I Make A Recovery Disk Out Of My Emachine Desktop Model El1300g 02w With
windows xp home edition
windows xp home edition
(Posted by crstnmri 9 years ago)
What Does The Ram Look Like For Emachine El1300g-02w
(Posted by ITPursailor 10 years ago)
El1300g-02w, Ram
I have the EL1300G-02w, they came from factory with 1gb ram, slot 1, slot 2 empty. Can I mix by putt...
I have the EL1300G-02w, they came from factory with 1gb ram, slot 1, slot 2 empty. Can I mix by putt...
(Posted by spdpatrol 11 years ago)
My Emachine El1300g-02w Pc Shuts Off After A Few Seconds
why do my emachine el1300g-02w pc shuts off after a few seconds. i have tried moving the jumper and ...
why do my emachine el1300g-02w pc shuts off after a few seconds. i have tried moving the jumper and ...
(Posted by lccurry10 12 years ago)