Zenith SL-5797-NB-C Support Question
Zenith SL-5797-NB-C Support Question
Find answers below for this question about Zenith SL-5797-NB-C - Heath - 270-Degree Halogen Motion Sensing Security Light.Need a Zenith SL-5797-NB-C manual? We have 1 online manual for this item!
Question posted by jbray1950 on December 2nd, 2012
Two Lights, One Works The Other Does Not.
I have two units hooked up to the same switch on the inside. When I turn the switch on, one works like it should but the other one does not.
On the unite that does not work, the small red lite on the sensor still blinks like it should.
Do I know the bulbs are good. Do you think the sensor is bad? If so, is the sensor hard to replace?
Current Answers
Related Zenith SL-5797-NB-C Manual Pages
User Guide - Page 1
...174; Timer. • Photocell keeps the lighting off during daylight
hours. • LED indicates motion was sensed (day or night). Mounting Bolt
Mounting Strap
Gasket
ON-TIME
TEST 1 5 20
2 Halogen Bulbs (Installed)
Light Shield
© 2007 HeathCo LLC
598-1315-02
DualBrite® Motion Sensor Light Control
Model 5797
Requirements
• The light control requires 120-volts AC. •...
User Guide - Page 2
... and push the sensor back into the ball joint. If motion is mounted higher than 3 feet. (1 m). • Use only T4, 100W (max.) G8 bi-pin tungsten halogen
120 VAC lamps. Manual mode works only with the ON-TIME switch in this feature.
Selecting OFF disables this manual. NOTE: If fixture is sensed, the light turns on then off...
User Guide - Page 3
...Light Control
❒ Place the mounting bolt through the hole in
but do not rotate the lamp holders more than 180°
the gasket as shown. Push the Rubber Plug over the mounting screw.
❒ Make sure the wire connectors and wires are inside the junction box. WARNING: Turn...together and secure with
several turns, turn power off at least 2" (51 mm) from the sensor.
Tighten set...
User Guide - Page 4
... or unwanted traffic may trigger the control.
• Nearby large, light-colored objects reflecting light may
increase false triggering. ❒ Secure the sensor head by
tightening the clamp screw. Motion
Motion
NOTE: Meets the ENERGY STAR® guidelines when DualBrite® function is 1 or 5 minutes.
❒ Turn the RANGE control to the medium position (halfway between MIN...
User Guide - Page 5
... may be sensing small animals or automobile traffic (re-aim sensor). 2. Select
Normal or Soft mode to Auto.)
Lights flash on and off . 2. T4, 100W maximum G8 halogen bi-pin 120 VAC DualBrite® Timer. . . . . Re-aim the sensor to 100 Maximum each lamp holder]. Sensor is in Dusk-to keep area below the sensor
off ). Light switch is...
User Guide - Page 6
... DAMAGES, INCLUDING BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. You may not apply to misuse, abuse or negligence, light bulbs, batteries, and other expendable items are not covered by factory defective parts or workmanship will void this guide. Unauthorized service or modification of the...
Similar Questions
Motion Sensor
Hi. Just bought a 10 year old house with Heath sensor on the back porch. I turn on the light and it ...
Hi. Just bought a 10 year old house with Heath sensor on the back porch. I turn on the light and it ...
(Posted by Barry95996 9 years ago)
Just Had The Zenith Sl 5798 Installed & The Motion Sensor Does Not Seem To Work
We had an electrician install the Zentih SL 5798 on our deck facing out into the field. The motion s...
We had an electrician install the Zentih SL 5798 on our deck facing out into the field. The motion s...
(Posted by Peyton 11 years ago)
Health Zenith Sl 5797-nb- Motion -
how do I set for automatic dusk-to-dawn.
how do I set for automatic dusk-to-dawn.
(Posted by jholl4590 12 years ago)
Dusk To Dawn Function
My light is mounted on the wall under a 2 1/2 soffit. It appears to work at night(turns on when it s...
My light is mounted on the wall under a 2 1/2 soffit. It appears to work at night(turns on when it s...
(Posted by howardsawallisch 12 years ago)
About The Model 5797.
All Night The Light Is On.
I wasn't possible that the lights turn off I did every steps of the manual Whwn I put the time on ...
I wasn't possible that the lights turn off I did every steps of the manual Whwn I put the time on ...
(Posted by fernandolopera 13 years ago)