Zenith SL-5318-WH-C Support Question
Zenith SL-5318-WH-C Support Question
Find answers below for this question about Zenith SL-5318-WH-C - Heath - Motion-Sensing Shielded Wide-Angle Twin Security Light.Need a Zenith SL-5318-WH-C manual? We have 1 online manual for this item!
Question posted by stevenwkime on December 28th, 2013
Problem With New Heath Zenith Hz-5318-wh
I installed a new HZ-5318-WH Motion Sensor Light today. Tonight (after dark), the lights turn on and off continuously. It is set to stay on for 5 minutes and then go off but instead it comes on and goes off about once every minute. What could be the problem?? I finally shut the switch off to disable the light completely.
Current Answers
Related Zenith SL-5318-WH-C Manual Pages
User Guide - Page 1
... at night because daylight returns the sensor to AUTO.
2 Shells* * Model SL-5318 only
Gasket
6 Screws (3 sizes included)
Flip the light switch off for one second
then back on lighting when motion is detected. • Automatically turns lighting off. • DualBrite® Timer. • Photocell keeps the lighting off and ON-TIME is 1 or 5 minutes and when used with a junction...
User Guide - Page 2
... continue to dim mode.
For eave mount only:
❒ Swing the sensor head towards the clamp screw joint. NOTE: If fixture is sensed, the light turns on half bright for the ON-TIME (1, 5, or 20 minutes) then returns to work as shown in the next two steps for replacement.
Wall Mount
Eave Mount
For under eave installation...
User Guide - Page 3
...from the sensor.
Wire the Light Control
WARNING: Turn power off at least 1" (25 mm) from the factory setting.When screwing in the floodlamps, do not overtighten.
595-5731-08
Secure with the...the light control's wires through the hole in the decorative shell with wire connectors. The small end of the cover plate. Secure with the mounting bolt.
❒ For model SL-5318 only...
User Guide - Page 4
... the lights on (also,
Ball Joint
the LED will flash several times
when motion is mounted higher than 8 ft.(2.4 m), aiming the sensor down , or
sideways to change temperature rapidly, such as needed. Do not overtighten the screw. Maximum Range
Maximum Coverage Angle
595-5731-08 TEST AND ADJUSTMENT
❒ Turn on , wait 1 1/2 minutes. Motion
Motion
NOTE: Model 5318 meets...
User Guide - Page 5
... is correct. 6. Daylight turn-off .
1. Light control may be installed in a relatively dark 1. light.
DualBrite® timer is in manual mode.
1. Re-aim light control.
2. Lights turn circuit breaker on for no apparent reason.
1. Lights stay on and off is on . 2. Light control is in TEST.
2. Lights flash on continuously.
1. Reposition light control.
3. Reposition flood...
User Guide - Page 6
... receipt, it is not extended to misuse, abuse or negligence, light bulbs, batteries, and other equipment and components that a customer uses..., please have other rights which gives you . If the problem persists, call 1-800-858-8501 (English speaking only) for...HeathCo LLC assembled products and is required for inconvenience, installation, setup time, loss of any malfunction caused by ...
Similar Questions
Motion Sensor
Hi. Just bought a 10 year old house with Heath sensor on the back porch. I turn on the light and it ...
Hi. Just bought a 10 year old house with Heath sensor on the back porch. I turn on the light and it ...
(Posted by Barry95996 9 years ago)
Motion Light Won't Turn On Unless It Is In Test Setting..
(Posted by Fishhooker2001 9 years ago)
Dusk To Dawn
This light has work properly for 5 yrs. then one day, in Dusk to dawn mode,set for 5 min. The light ...
This light has work properly for 5 yrs. then one day, in Dusk to dawn mode,set for 5 min. The light ...
(Posted by robtsrnka 11 years ago)
Sl-5525 Sensor Tested Ok But Won't Turn Light On In Auto Mode?
(Posted by simonikt 11 years ago)
