Zanussi ZWH6160P Support Question
Zanussi ZWH6160P Support Question
Find answers below for this question about Zanussi ZWH6160P.Need a Zanussi ZWH6160P manual? We have 1 online manual for this item!
Question posted by proclubmaker on February 22nd, 2015
'water Fault'
Newmachine performed one 'full' cycle and now fails every wash cycle with water fault.Already checked.Water filters - OKHose - OK not kinked (water goes in OK at the start of each cycleWater does not wash the detergent out of the tray.
Current Answers
Answer #1: Posted by waelsaidani1 on February 22nd, 2015 5:43 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
hello refer here for solution http://www.how-to-repair.com/help/dishwasher-filling-water-aeg-electrolux-zanussi-error-code-al5-als-time-fault/
Related Zanussi ZWH6160P Manual Pages
Product Manaul - Page 2
... and turn off the water supply after use, cleaning...Before first starting up a damaged appliance . Never connect up , check the appliance...hose and the worktop is
2 If parts are damaged, contact your local Service Centre. Contents
Safety information 2 Frost precaution 4 Environment concerns 4 Product description 5 Technical data 5 Installation 6
First use 10 Daily use 10 Washing...
Product Manaul - Page 3
...hose supplied with the delay start...this type of the washing cycle.
• Garments...
• Check that the ...water supply.
• Do not use the appliance if the power supply cable, the control panel, the working surface or the base are used for this appliance incorporates a special feature.
3 If it was designed.
• Only wash fabrics which have to purchase a new, longer hose...
Product Manaul - Page 4
... the environment and human health, which could drop below 0°C, proceed as household waste.
unplug the appliance;
2. unscrew the water inlet hose from sink or spigot;
6. screw the water inlet hose to the tap and the drain hose to start the appliance up again, make sure that this product may not be taken to remove any...
Product Manaul - Page 5
>PP
Product Manaul - Page 6
... and keep all transit devices so that no ho-
2
ses are crushed in the process.
• Remove the polystyrene base from the bottom.
6
Electrical connection
Water supply pressure
Maximum Load Spin Speed
Information on the electrical connection is given on the rating plate, on it.
Product Manaul - Page 7
Refer to "Frost precaution" and "What to drain the water.
Do not remove the drain hose from the hose holders (C) on the rear of the appliance.
• Plug the smaller... supply cable and the draining and inlet hose from the rear support. Warning! Remove this hose only if it 's upright position.
• Open the door and remove the plastic hose guide, the bag containing the instruction booklet...
Product Manaul - Page 10
...wash, run a cotton cycle at the highest temperature without moving
machine to enable electrical isolation of appliance prior to cleaning or service. • Do not pull the mains cable to disconnect the appliance. SHOWER BATH
SINK TOILET BIDET
RAINWATER 'RUN-OFF'
WASHING MACHINE DISHWASHER
SURFACE WATER...the main wash compartment and start the machine.
10 Sort the laundry as this water is ...
Product Manaul - Page 11
... fast coloureds only). For dried stains, soak overnight in water with bleach and then rinse thoroughly.
Remove stubborn stains before washing: Blood: treat fresh stains with bleach, rinse well (... spirits. Open the door by carefully pulling the door handle outwards Load the laundry
Place the laundry in the laundry (e.g. General rules: • Cotton, linen: drum full but not too tightly...
Product Manaul - Page 12
...,
• the laundry is in the main wash compartment, is lightly soiled,
• large amounts of liquid), ensure that the flap, placed in the desired position. Although biodegradable, detergents contain substances which, in .
• Carefully put the drawer back.
12 The choice of detergent will depend on hardness of the water in so...
Product Manaul - Page 14
...Select the new programme by turning the selector to the required programme. Start the new programme by turning the programme selector dial to indicate a wrong selection. The water in the tub will not perform the new selected programme.
• To switch the appliance off by ...-clockwise.
Push the temperature button to select the most suitable temperature for washing your laundry .
14
Product Manaul - Page 15
... the water of the last rinse is not emptied out to rinse the laundry using an extra quantity of the pro- With this option after having started the programme...goes off .
5 Delay Start
3h 6h 9h
Delay Start
The start the programme.
The relevant light illuminates.
Short cycle for lightly soiled items or for that programme. Cancelling the delayed start after you start...
Product Manaul - Page 16
... below instructions to empty out the water:
• Turn the programme selector dial to carry out Remove the laundry from the point at which is operating.
• The additional rinses pilot light (7.2) illuminates when the appliance performs an extra rinse.
• When the programme has finished the end cycle pilot light (7.3) comes on. The...
Product Manaul - Page 17
...START
AUTOMATIC SPIN REDUCTION
RINSE HOLD SUPER QUICK 1)
EXTRA RINSE DELAY START
AUTOMATIC SPIN REDUCTION
RINSE HOLD EXTRA RINSE DELAY START
Detergent Compartment
17 Leave the door open to obtain a good washing...safety" in the inner side of Laundry
COTTONS 90°-Cold Main wash -
Rinses - This allows to prevent the formation of every cycle, check from the door seal and remove ...
Product Manaul - Page 18
... 3,5 kg Highly energy efficient cold wash programme for lightly soiled laundry. Cycle Description - Rinses -
Cold Main wash - Reduced load 2 kg Synthetic or mixed fabrics: underwear, coloured garments, nonshrink shirts, blouses . load kg 3,5 - Reduced load 2 kg Delicate fabrics: acrylics, viscose, polyester . Rinses - If the appliance doesn't perform the final spin phase, add more...
Product Manaul - Page 19
... with synthetic filling or dawns. Cycle Description - Cold Main wash - AUTOMATIC SPIN REDUCTION
DELAY START
EASY IRON 60°- Lightly soiled items or which only needs freshening up. load 3 kg Synthetics and delicates. Programme - Gentle wash and spin to obtain the best anti-creasing result, reduce the load of Laundry
Options
Detergent Compartment
SPIN Drain...
Product Manaul - Page 20
... water temperature may differ from the socket before any cleaning action. Switch the appliance off and remove the mains plug from the declared cycle temperature.
They are suitable to get a build up of residues inside the drum. To run a maintenance wash: • The drum should be empty of laundry. • Select the hottest cotton wash...
Product Manaul - Page 22
... appliance is not working. for more details), check if the water inlet filters are due to lack of cloth.
• Screw the hose back to the appliance and make sure the ...stiff brush. The appliance does not start or stops during operation. Before contacting your local Service Centre, please carry out the checks listed below.
Cleaning the water inlet filters
Important! display (if available) ...
Product Manaul - Page 23
... not start or stops during operation without discharging the water , first carry out an emergency drain: -
Carry out the drain filter cleaning as described in the inlet hose or the inlet valve filter are blocked • Clean the water inlet filters (read "Cleaning the water inlet filters" for more details). The drain filter is squashed or kinked. • Check the inlet hose connection...
Product Manaul - Page 24
... the feet.
There is water in the power socket.
• Insert the plug into the power socket. The delay start has been selected.
• If the laundry are any leaks from one . The end of the inlet hose fittings. Check whether there are to be washed immediately, cancel the delay start :
• Please check your domestic electrical installation...
Product Manaul - Page 25
... economically using very little water without affecting performance. In this case, redistribute the load manually and select the spin programme.
• Load more items, redistribute the load manually and then select the spinning programme.
No water is too small.
• Add more laundry. The correct temperature was not selected.
• Check if you write the...
Similar Questions
Waste Water Filter?
cannot locate a waste water flyer following a washing cycle.Is there one
cannot locate a waste water flyer following a washing cycle.Is there one
(Posted by grahamedurrant 1 month ago)
How Can I Open Door When Water In Drum Won't Drain Or Spin
can press button 6 which is green for drain and spin but machine will not operat
can press button 6 which is green for drain and spin but machine will not operat
(Posted by kathleenlynex 2 years ago)
The Machine Overflows With Water When Going Through A Wash Or Rinse Cycle
the machine fills with water and it overflows out of the top drawer
the machine fills with water and it overflows out of the top drawer
(Posted by emmagoldsworthy 8 years ago)
Zanussi Zkg7165 Washing Machine Fault.
Hi, I have a ZKG7165 which is abotu 2 years old. Recently, it has developed a fault where it complet...
Hi, I have a ZKG7165 which is abotu 2 years old. Recently, it has developed a fault where it complet...
(Posted by ricky87462 10 years ago)