Err Message

The "Err" message on your Zanussi ZDH8333W dryer typically indicates a problem with the sensor or the wiring in the machine. There are a few possible causes for this error message, but the most common is that the sensor is not working properly or that the wiring has become loose or disconnected during the move of the dryer.

To troubleshoot this issue, first check to make sure that the sensor and wiring are securely connected to the machine. The sensor is typically located near the drum and is connected to the control board by a small wiring harness. Make sure that the harness is plugged in securely on both ends.

If the sensor and wiring appear to be fine, you may need to check the control board for any loose connections or damage. The control board is typically located behind the control panel and is responsible for sending power to the sensor and other components of the machine.

If you are still unable to resolve the issue, it may be best to contact a professional for further assistance. They will be able to diagnose the problem and repair or replace any faulty parts that may be causing the error message.

---

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

The "err" message on a Zanussi ZDH8333W tumble dryer typically indicates that there is an error with the electronic control board. This could be caused by a malfunctioning component, a problem with the wiring, or a software issue. To resolve the issue, you should try unplugging the dryer for a few minutes to reset the control board, and then check to make sure that all of the connections are secure. If the problem persists, you may need to contact a professional for repairs or consider getting a new tumble dryer.

It's possible that moving the dryer may have caused a loose connection or dislodged a component inside the machine, leading to the "Err" error message. Here are some steps you can take to troubleshoot the issue:

1. Unplug the dryer: Turn off the dryer and unplug it from the electrical outlet. Wait a few minutes before plugging it back in and turning it on again. Sometimes this can reset the machine and clear the error message.
2. Check the wiring: Make sure all wiring and connections are secure and properly connected. If you notice any loose or disconnected wires, reconnect them.
3. Check the control board: The control board is the electronic component that controls the dryer's functions. If the "Err" message persists, there may be an issue with the control board, such as a faulty circuit or a malfunctioning sensor. You may need to replace the control board or contact a professional technician to diagnose and repair the issue.
4. Contact the manufacturer: If the issue persists and you're unable to resolve it yourself, it's best to contact the manufacturer for assistance. They may be able to provide additional troubleshooting tips or schedule a service call to have a technician examine the machine.It's important to note that if you're not comfortable working with electrical components or if you're unsure of how to troubleshoot the issue, it's best to consult a professional technician or the manufacturer for assistance.

---

s jagadeesh