Home » Zanussi » Ovens » Zanussi ZCG63330XA

Zanussi ZCG63330XA Support Question

Find answers below for this question about Zanussi ZCG63330XA.
Need a Zanussi ZCG63330XA manual? We have 1 online manual for this item!

Zanussi Overview Questions Manuals Reviews Videos Research

Question posted by josiehanson on August 11th, 2019

Thermocouple Replacement

I need to replace the thermocouple on my Zanussi ZCG63330XA gas oven. I have removed the burners but I don't know how to remove the hob top. Thank you.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by techyagent on August 11th, 2019 7:34 AM

This answer was accepted by the poster of the original question.

techyagent

Member since:
June 17th, 2014

Points: 4,799,780

1,100
points

Turn off the gas supply.
Make sure that the gas controller is in the off position before attempting this repair.
Unfasten the three nuts that hold the thermocouple and the two gas tubes to the valve.
The burner typically sits loosely - or under clips - in the burning chamber and just slides out.
Detach the thermocouple from the burner.
The thermocouple is usually attached to the pilot gas supply tube with one or more clips that snap into place. The end of the thermocouple is inserted into the pilot assembly and can simply be pulled out.
Take the detached thermocouple with you to the home center or hardware store and buy a new one.
Install the new one the same way that you removed the old one.
Attach the end of the new thermocouple into the pilot assembly and reattach the thermocouple to the pilot gas supply using the clips previously removed, reinstall the burner and, using a small open-end or adjustable wrench, reconnect the thermocouple lead, the gas tube to the main burner, and the pilot gas tube to the valve.
Turn the gas back on and follow the lighting instructions on the water heater.
Check for gas leaks by applying soapy water to joints and looking for bubbles while the main burner is firing.

https://www.buyspares.co.uk/zanussi/zkg5540xn-94890551103-20090521/fsd-assembly/product.pl?pid=1632424&path=462784:496321,108061:462802&model_ref=920143

Thanks

Techygirl

Related Zanussi ZCG63330XA Manual Pages

Product Manaul - Page 11

... not be regularly cleaned on the plate situated inside www.zanussi.com and outside (AT LEAST ONCE A MONTH). Put...any cleaning or maintenance operation, disconnect hood from appliances burning gas or other fuels. Do not dispose appliances marked with the...gloves for their safety. This must therefore be operated by removing the plug or disconnecting the mains electrical supply. USE ...

Product Manaul - Page 12

...oven for the cooking equipment on the type of cooking and the regularity of cleaning of the fat ﬁlters) internally and externally. Eliminate excess water without damaging the ﬁlter, then remove the mattress located inside the plastic frame and put it is necessary to replace.... Type 20 12 www.zanussi.com Do not use , depending on the hob and the lowest part of...

Product Manaul - Page 13

...with a control panel with aspiration speed selection control and a light switch to control cooking area lights. 1 23 4 5 1. Replace with bare hands. Prior to touching the light bulbs ensure they are cooled down. Follow package directions and do not touch new ... kitchen vapours. LIGHTING Disconnect the hood from the electricity. ON/OFF lighting 2. www.zanussi.com 13