2008 Yamaha Motorsports RS Viking Professional Support Question
2008 Yamaha Motorsports RS Viking Professional Support Question
Find answers below for this question about 2008 Yamaha Motorsports RS Viking Professional.Need a 2008 Yamaha Motorsports RS Viking Professional manual? We have 1 online manual for this item!
Question posted by cuff58 on December 8th, 2016
Bearing Change
How do I change the left side bearing in the track drive shaft
Current Answers
Answer #1: Posted by Troubleshooter101 on December 8th, 2016 11:27 PM
Troubleshooter101
Member since:
September 30th, 2015 Points: 2,927,030
Member since:
September 30th, 2015 Points: 2,927,030
TO change bearings you need to watch this tutorial
Please click here
Thanks
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Troublshooter101
Related Manual Pages
Owners Manual - Page 5
......15 Brake lever ...16 Parking brake lever ...16 Shift lever ...17 Shroud latches ...17 Drive guard ...18 V-belt holders ...18 Carburetor coolant shut-off lever ...18 Louvers ...18 Passenger ... the engine ...28 Break-in ...29 Riding your snowmobile ...29 Maximizing drive track life ...32 Strap ...33 Driving ...34 Stopping the engine ...35 Transporting ...35 Periodic maintenance...36 Periodic ...
Owners Manual - Page 7
... care of the following for proper operation every time before operating this snowmobile. Never drive the snowmobile with care; Allow the engine to operate the snowmobile is closed securely after...injury or death may overheat the brake disc and reduce braking ability. Before operating
1. A broken track, track fittings, or debris thrown by law, and you must know and use is running . G ...
Owners Manual - Page 8
... of control and may need help if you swallow some gasoline, inhale a lot of ski runners, drive track, slide runners, and drive sprockets. Wear an approved helmet, and a face shield or goggles. Do not run out of the...your skin or clothing, immediately wash your skin with soap and water, and change your exposure to release the throttle and apply the brake gently-
Be alert, plan ahead...
Owners Manual - Page 13
... you have purchased may differ slightly from those shown in the figures of this manual. Starter (choke) lever 13. Design and specifications are subjected to change without notice.
7 Engine stop switch 6. Shroud latch 9. Main switch 11. Low coolant temperature indicator light
15. Coolant temperature warning indicator 19. Fuel level warning indicator...
Owners Manual - Page 18
... warning light come on a level surface to obtain an accurate fuel meter reading, since the reading changes according to the grip warmer level.
Grip warmer indicator " " 2. Grip warmer adjustment switch
12 ...grip warmer level, or the thumb warmer level. When this occurs, maximum engine speed is left near "E", the fuel level warning indicator and the warning light come on and the display ...
Owners Manual - Page 21
ESU10661
Headlight beam switch "LIGHTS"
Push the headlight beam switch to change the headlight to high beam "HI" or to "LO". NOTE:
1. High beam "HI" 3. Start the engine. 2. To lower the temperature, press the switch to low ...
Owners Manual - Page 22
...Parking brake lever
When parking the snowmobile or starting the engine, apply the parking brake by braking the entire drive system. Parking brake lever
To release the parking brake, move the parking brake lever to stop the snowmobile.... (30 W)
Make sure that gets hot because the jack can be sure to the left. Auxiliary DC jack
1.
Auxiliary DC jack cap 2. Control functions
1.
Owners Manual - Page 24
... for ventilation located in the holders.
18 "ON" (open) position 3.
The upper left louver and the lower front louvers have steel plates that the lever is in case parts...CAUTION:
Make sure that the drive guard is equipped with the V-belt or drive guard removed.
1. Carburetor coolant shut-off lever
The carburetor coolant shut-off lever 2. Drive guard
EWS00400
WARNING
G
G
...
Owners Manual - Page 33
...checks
ITEM Louvers Tool kit and recommended equipment Shroud latches Skis and ski runners Drive track Slide runners Steering Strap Lights, signals and switches Throttle lever Throttle override system (T.O.R.S.)...8226; Check for deflection, wear and damage. • If necessary, have Yamaha dealer replace track. • Check for wear and damage. • If necessary, have Yamaha dealer replace ...
Owners Manual - Page 36
...warmed up, you are ready to tip. Improper use of the brake can cause the drive track to perform it at low speeds many times, in the desired direction. Remember: Avoid higher... feet outside of the turn .
EWS00220
WARNING
G
G
Many surfaces such as abrupt throttle changes, excessive braking, incorrect body movements, or too much longer stopping distances. Once you have learned...
Owners Manual - Page 39
... sufficient, stay on the right handlebar grip for steering, and grip the strap with the left hand to maintain balance during traverse riding. If snow coverage is sufficient snow coverage. Avoid spinning the drive track. Do not overtighten the drive track, otherwise it may put an excessive load on the suspension components, resulting in the...
Owners Manual - Page 44
... mi)
*
Drive chain
• Check chain slack. • Adjust if necessary. • Check oil level. • Change. • Adjust free play and/or replace pads if necessary. • Change brake fluid. • Make sure that operation is changed. Periodic maintenance
... damage. • Replace if necessary. • Check for slight free play. • Lubricate shaft with specified grease.
Owners Manual - Page 45
...39 NOTE:
Brake system: G After disassembling the master cylinder or caliper cylinder, always change the brake fluid. Regularly check the brake fluid level and add fluid if necessary..... • Tighten if necessary. • Check condition. • Charge if necessary.
56
*
Steering bearings Ski and front suspension Suspension component Fittings and fasteners
-
* *
61 61
62
*
Battery
63
*...
Owners Manual - Page 46
...use a spark plug with the engine. Spark plug reach
40 Consult a Yamaha dealer before changing to inspect. could be something wrong with the specified reach. You should periodically remove and ... electrode. If a spark plug shows a distinctly different color, there could indicate an intake track air leak or carburetion problem for a snowmobile that is too short, carbon will cause a...
Owners Manual - Page 50
... Open the shroud. ECS00480
3. 4.
Oil level gauge coupler 2. Coming into contact with or getting any changes necessary for 10-15 minutes. CAUTION:
G
G
Do not run the engine with use . ECS00430
G... maintenance chart. Disconnect the oil level gauge coupler. Oil filler cap
44 CAUTION:
The drive chain gears and V-belt clutch should be damaged.
EWS00370
Start the engine, warm it ...
Owners Manual - Page 56
...dealer make this adjustment. Otherwise, the V-belt clutch engagement speed will be changed and the snowmobile may be adjusted by adding a spacer on each adjusting bolt... To replace and adjust the V-belt
EWS00410
WARNING
G
G
G
Never run the engine with the V-belt or drive guard removed. Have a Yamaha dealer make this adjustment.
1. Spacer
ECS00510
CAUTION:
As the V-belt wears, adjustment...
Owners Manual - Page 65
... the edge of the snowmobile onto a suitable stand to left and right adjusting nuts.
1.
If the alignment is incorrect, adjust the drive track. Adjusting the drive track
EWS00500
1. Periodic maintenance
1. Lift the rear of the track window. Start the engine and rotate the drive track one or two turns. Drive track deflection
Standard drive track deflection: 35.0-45.0 mm (1.38-1.77 in...
Owners Manual - Page 66
... 2. Wear limit height 1. 2. 3. 4. 5. Rear axle nut tightening torque: 80 Nm (8.0 m·kgf, 58 ft·lb)
Shifted to 5 until the proper adjustment is achieved.
Drive track deflection Left adjusting nut Right adjusting nut
ECS00591
More than specified Turn out Turn out
CAUTION:
1. If necessary, repeat steps 3 to right
7. Slide runners
1. 2. 3. 4. 5. Tighten the rear...
Owners Manual - Page 75
...Tight, loose, or broken drive chain: Ask a Yamaha dealer to inspect. Problem with flat spots: Replace. Worn or damaged bearings: Ask a Yamaha dealer to inspect. Worn or damaged drive track: Ask a Yamaha dealer ... V-belt clutch: Ask a Yamaha dealer to inspect. Worn or damaged idler wheels or shafts: Ask a Yamaha dealer to inspect. Improper V-belt: Replace with the correct Vbelt. Incorrect...
Owners Manual - Page 78
...8750 r/min Drive chain type: Silent chain enclosed in ) Engagement speed (Subject to change according to elevation settings.): 2200-2600 r/min Shift speed [Subject to change according to ... Minimum pump octane (R+M)/2: 86 Starting system: Electric starter
Chassis:
Drive track: Material: Molded rubber, fiberglass-rod reinforced Type: Internal drive type
Width: 500 mm (19.7 in) Deflection: 35.0-45...
Similar Questions
Fuel Pump Overheating. How To Change?
(Posted by gcaskey03 4 years ago)
