Whirlpool WTW57ESVW Support Question
Whirlpool WTW57ESVW Support Question
Find answers below for this question about Whirlpool WTW57ESVW - Plus Ing Washer.Need a Whirlpool WTW57ESVW manual? We have 5 online manuals for this item!
Question posted by susanwilliams333 on September 3rd, 2015
Height Weight Capacity
height weight capacity
Current Answers
Answer #1: Posted by Odin on September 3rd, 2015 9:31 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Sorry, but I can't find the weight online--I suggest you ask the vendor. As for the rest:
- Width : 26 7/8"
- Depth : 25 1/2"
- Height : 42 1/2"
- Capacity : 4 Cu. Ft.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WTW57ESVW Manual Pages
Owners Manual - Page 3
... that are required to maximize your water and energy savings:
BEFORE STARTING THE WASHER:
■■ Presort all of your laundry. ■■ Add all of your garments and laundry products to fill. If the lid is opened during fill, the washer will reduce or eliminate water savings. then, filling resumes and continues to...
Owners Manual - Page 4
...wash water safe for your fabric.
Cool -
This will be cooler than what your previous washer provided. See "Cycle Guide" for different fabrics and soil levels. Select a wash temperature ...(15.6° C), detergents do not dissolve well and soils can be cooler than what your previous washer provided.
■■ Even in Cool wash, some warm water is properly distributed in the rinse...
Owners Manual - Page 5
... in loose heaps.
Prewash does not include a rinse cycle;
Select prior to starting washer to automatically add to wash cycle, eliminating need to return later to remove stains. To...setting Fabric Select and Cycle Select knobs and add laundry products as normal.
5 Add laundry products and start a new wash cycle as normal.
Add laundry products and start a new wash cycle as ...
Owners Manual - Page 6
....
4. Add liquid fabric softener to your Lloiqaudi.d chlorine
bleach dispenser
5. Close the washer lid. Fabric softener is added automatically during the wash cycle.
■■ Always dilute ....
STARTING YOUR WASHER
WASHER USE
BEFORE STARTING THE WASHER: Add all items and laundry products to the washer before pulling the Cycle Control knob out to the bottom of the washer. Items need...
Owners Manual - Page 7
....
If you should: 1. See "Accessories" for a list of factory specified hoses available for about 30 seconds to mix the antifreeze and remaining water.
3. Winterizing your washer during freezing weather, winterize it.
Pour this process if necessary. Rinse dispenser under warm water, then replace it through a complete bulky items cycle with
1 cup...
Owners Manual - Page 8
... the dispensers. ■■ Did you completely remove the yellow shipping strap with
a cycle? Washer won't run, fill, rinse, or agitate; Turn the Timer knob to the right slightly and...Check the following: Are the fill hoses tight? This will interrupt the sensing feature and cause the washer to the basket. Reinstall hoses, turn on ? Water level seems too low
■■ Auto...
Owners Manual - Page 9
...?
The cooler temperatures save energy while providing good cleaning. Allow the cycle to drain pipe. Washer will not agitate or spin with the lid open ? Hot and warm temperatures are wet
&#... not what I selected
■■ Are the hot and cold water inlet hoses reversed? The washer pauses for more than you expected?
Do not seal the drain hose with a higher spin speed ...
Owners Manual - Page 10
... household use or when it was purchased. If outside the 50 United States and Canada, contact your complete model number and serial number. WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or...
Dimension Guide - Page 1
...)
3" (76 mm)
4.5" (113 mm)
Laundry tub drain system
See requirements for closet door ventilation openings which are minimum required. Ref. or 20-amp, fused electrical supply is recommended.
install no more space for ease of washer to improve performance and minimize noise and possible "washer walk". Minimum carry-away capacity: 17 gal. (64 L) per...
Installation Instructions - Page 2
... back page of your washer to 19⁄16" (39.5 mm)
Optional tools:
Flashlight
Bucket
Parts supplied: NOTE: All parts supplied for installation are in a basement, laundry room, closet, or recessed... space saving
90° elbow, hypro-blue steel couplings (2 pack)
Alternate parts: (Not supplied with washer)
Adjustable or open end Level wrench 9/16" (14 mm)
4" min (102 mm)
Wood block...
Installation Instructions - Page 3
...from bottom of laundry tub must be at least 39" (991 mm) above floor; Top of washer. (Additional hoses might be needed.)
Laundry tub drain system
4.5" (113 mm)
A
39" (991 mm)
Minimum capacity: 20 gal....for ease of washer.
3
If a closet door or louvered door is not recommended.
■■ Floor must support washer's total weight (with maximum slope of washer. Floor drain ...
Installation Instructions - Page 4
...then continue to step 6; if power cord is looped, skip to avoid excessive noise from washer.
1. If it must be in accordance with a qualified electrician if you start: remove shipping...-type outlet, grounded in a fully upright position. NOTE: To avoid floor damage, set washer onto cardboard before moving it is recommended that a qualified electrician determine that the ground path ...
Installation Instructions - Page 5
...from rear panel. Remove looped power cord
C
A
Gently pull hose out of back of washer cabinet from top until both ends are completely removed from power cord
Gently place power cord ... console
D
B A
Firmly grasp power cord (A) and pull to determine what you may need . For a laundry tub or standpipe drain, follow steps 8 and 9. 3. Place power cord over console to allow free access to...
Installation Instructions - Page 6
... in standpipe
4.5" (113 mm)
11.
A small amount of drain hose should run until clear.
12. Clear water lines
Place hose into a laundry tub, drainpipe, or bucket to faucets or washer. IMPORTANT: Do not overtighten or use tape or sealants on valve when attaching to prevent clogs. Water should be arranged vertically or...
Installation Instructions - Page 7
... hose
Laundry Tub
Standpipe
Wall
17. Tilt washer forward; Check levelness of washer. Rock washer back and forth to make sure all four feet make solid contact with a wood block or similar object that will support weight of washer
Place level here
1" (25 mm)
Prop up or down, repeating as necessary.
16. Gently lower washer to floor...
Installation Instructions - Page 8
... steps to see what was skipped.
■■ Check that you have all of your washer, measure 1/2 of normal recommended amount of powdered or liquid detergent and pour it from turning ... .
■■ Check for levelness. Select any tape remaining on washer.
■■ Check that all packaging materials.
■■ Read "Washer Use" in your "Use and Care Guide".
■■ To...
Warranty - Page 1
... not allow the exclusion or limitation of the Use & Care Guide. ITEMS EXCLUDED FROM WARRANTY
This limited warranty does not cover:
1. If you . WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from defects in -warranty service. EXCLUSION OF INCIDENTAL AND CONSEQUENTIAL DAMAGES
YOUR SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer continues to fill - Front-load washer
... machine (siphoning) as described in the drainpipe or laundry tub. Top-load washer Washer not draining, not spinning out water; Is the drainpipe (standpipe) less than the minimum height of drain hose in the Installation Instructions), will continue to drain - Front-load washer Why does my washer continuously fill and drain? Is the drain hose taped... -
How do I clean my top-loading super- or large-capacity washer?
... and then replace it is not cleaning laundry - Do not use abrasive products. top-loading washer? or large-capacity washer? here. Some models are labeled "washer safe." Cleaning the interior Do...necessary. NOTE: For information on Whirlpool® here, or the Cabrio top-loading washer with both hands; How do I clean my top-loading super- Cleaning the liquid fabric ... -
Washer continues to fill or continues to drain - Top-load washer
... gravity. Is the drainpipe (standpipe) less than the minimum height of the machine due to flow out of 39" (99 cm)? Top-load washer Not draining, not spinning out water, wet loads - What should be too far down inside the drainpipe (standpipe) or laundry tub. The drain hose should I do? Make sure that...
Similar Questions
Where Is The Load Sensor Switch On A Whirlpool Washer Wtw57esvw
(Posted by tbjulys 9 years ago)
Whirlpool Top-load Washer Wtw57esvw Won't Spin
(Posted by neAsel 10 years ago)
How To Fix Whirlpool Washer Wtw57esvw
(Posted by CrystGuido 10 years ago)
Where Is The Auto Sensor On A Whirlpool Washer Wtw57esvw
(Posted by Fawdigg 10 years ago)
Whirlpool Top Load Washer Wtw57esvw Will Not Run Any Cycle Or Run Water
(Posted by tstatfra 10 years ago)