Whirlpool WTW4800XQ Support Question
Whirlpool WTW4800XQ Support Question
Find answers below for this question about Whirlpool WTW4800XQ.Need a Whirlpool WTW4800XQ manual? We have 5 online manuals for this item!
Question posted by raggs on January 8th, 2013
Won't Spin All The Water Out.
it spins but when through the clothes stii have water in them.
Current Answers
Related Whirlpool WTW4800XQ Manual Pages
Dimension Guide - Page 1
...minute. If you will need a sump pump system. Laundry tub drain system
Minimum capacity: 20 gal. (76 L).
Louvered doors with spacing of washer. If a closet door or louvered door is recommended... complete details, see Installation Instructions packed with cable tie. W10240509B 01/2011
Top of laundry tub must install higher than 4.5" (113 mm) of drain hose should be provided....
Installation Instructions - Page 2
... standpipe
2" (51 mm) diameter to toll-free numbers on back page of the washer.
To order, please refer to 1" (25 mm) diameter Standpipe Adapter Part Number ...367031 Connector Kit Part Number 285835
LOCATION REQUIREMENTS
Select proper location for installation are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (1067 mm)
...
Installation Instructions - Page 3
..., doors, and floor moldings. n Hot and cold water faucets located within 4 ft (1.2 m) of 1" (25 mm) under entire washer. Water remaining in washer after use may cause damage in temperatures below the top of washer. (Additional hoses may be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Wall standpipe drain system
14" max. (356...
Installation Instructions - Page 5
NOTE: Keep tray in Step 7. IMPORTANT: 4.5" (113 mm) of laundry tub. For a laundry tub or standpipe drain, go to move washer later.
4. Be sure to drain port
Remove tape from washer lid, open lid and remove cardboard packing tray from tray. Attach drain hose to remove all parts from tub. Squeeze clamp with pliers and...
Installation Instructions - Page 6
.... Do not use tape or sealants on water faucets to check for a few seconds through hoses into a laundry tub, drainpipe, or bucket to inlet valves. Connect inlet hoses to washer
Attach hose to hot water inlet valve marked with a red ring. Damage can result. Connect Inlet Hoses
Washer must use a Y-adapter (not provided).
8.
IMPORTANT: To...
Installation Instructions - Page 7
... lid, as a guide to prop up front of washer about 1/2" (13 mm) from the washer cabinet. If washer is not level, use a 9/16" or 14 mm open -end or adjustable wrench to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with floor. Rock washer back and forth to step 14.
Check levelness...
Installation Instructions - Page 8
... a grounded 3 prong outlet.
Close lid. Select any tape
remaining on washer. Start washer and allow to see what was skipped. q Remove protective film from back...washer. q Check that water faucets are now installed. q Check that all packaging materials. q Check that washer is an extra part, go back through steps to complete full cycle.
8 q Read "Washer Use" in your washer...
Owners Manual - Page 3
... check for your laundry load.
FABRIC SOFTENER ADDED-YES This option must be used to automatically add a second rinse to the washer.
NOTE: If the washer is added to most suitable for load balance. At each stage of fabric and soils being washed.
These spins may take several minutes before water is spinning, it may take...
Owners Manual - Page 4
... moves the load. You may take several minutes if the load was selected. Some cycles use spray rinsing. After draining and spinning out wash water, the washer will turn on the selected cycle and spin speed.
Remove the load promptly for the entire rinse time. Fabric softener will come on briefly (short hum) to...
Owners Manual - Page 5
...To set in mesh garment bags before washing. After time has expired, water will drain, but the washer will use for heavily soiled or sturdy items. This cycle uses spray rinses...-soiled no -iron fabrics such as sport shirts, blouses, casual business clothes, permanent
press, and blends. The washer will not spin. Items to shorten drying times for normally soiled cottons and mixed fabric ...
Owners Manual - Page 6
... agitator and become trapped, causing unexpected sounds.
• Sort items by recommended cycle, water temperature, and colorfastness.
• Separate heavily soiled items from lightly soiled.
•... the washer basket before adding clothes.
Sort and prepare your garments. USING YOUR WASHER
1. Separate lint-takers from lint-givers. If using an Oxi or color-safe bleach laundry boost ...
Owners Manual - Page 7
... water until the washer has completed filling, press the START/Pause/Unlock button to spill, splash, drip, or run into washer. Do not allow liquid fabric softener to pause the washer.... Do not use more than the recommended amount. 3. Load laundry into dispenser; Try mixing different sized items to start the washer. Add liquid chlorine bleach
to reduce wrinkling and tangling.
4....
Owners Manual - Page 8
... knob to your load.
Select options
Select the load size setting most amount of the spin prior to move freely. Select the desired cycle options. Press START/Pause/Unlock
to begin...cold water will be cooler than what your hot water heater setting. Delay in soil removal and help dissolve detergents. This is very cold, warm water may be cooler than your previous washer provided....
Owners Manual - Page 9
... not use abrasive products.
9 NOTE: For best results, do not wash clothes with the liquid fabric softener dispenser removed.
Make sure the washer is empty. 2. NON-USE AND VACATION CARE
Operate your clothes. disconnect and drain water
inlet hoses.
2. Select Normal Heavy cycle, hot Temperature, and large Load Size.
5. If cycle must be interrupted...
Owners Manual - Page 10
... into a pan or bucket. Plug in new location. Disconnect drain from drain system and drain any remaining water into basket opening. REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use washer again:
1. Flush water pipes and hoses. Run washer through the following recommended procedure:
To use , vacation, winter storage, or moving .
3. Close lid and place...
Owners Manual - Page 11
... sound.
Do not place tape over drain opening. Water can back up out of the sensing spins after you experience
Possible Causes
Solution
Vibration or Off-Balance
Check the following for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Improper loading can restrict water flow.
11 Washer not performing as recommended. Jam nuts must be...
Owners Manual - Page 12
.... Small items may hear the hum of the load in basket, and add detergent. To remove extra water in pump or between basket and tub, which can slow draining. See "Using Your Washer" for balanced spinning. Drain hose extends into a grounded 3 prong outlet.
Too much detergent causing suds to drainpipe or tub. This...
Owners Manual - Page 13
..., oxi products, and color-safe bleach to develop dry spots during the final spin can keep washer from operating correctly. The high spin speeds combined with air flow during the final spin. Incorrect or wrong wash or rinse temperatures
Check for proper water supply.
Both hoses must be wetter than your load with a slower wash...
Owners Manual - Page 14
... dispensers. Incorrect dispenser operation
Clogged dispenser. Use only liquid chlorine bleach in Washer Maintenance.
Fabric damage can keep washer from operating correctly.
Undiluted bleach will not unlock until the basket has stopped spinning.
See "Cleaning Your Washer" in the bleach dispenser. Unload washer as soon as cycle is tightly packed. Lid locked light is flashing...
Owners Manual - Page 15
... major appliances with electrical or plumbing codes, or use or when it . WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase.
6. YOUR SOLE AND EXCLUSIVE...your major appliance to repair or replace appliance light bulbs, air filters or water filters.
Write down the following information about your major appliance, unless such damage results ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer continues to fill or continues to drain - Top-load washer
... drainpipe (standpipe) less than 8" (20.3 cm) into the drainpipe or laundry tub. Top-load washer Not draining, not spinning out water, wet loads - Do not seal the drain hose into the washer if the drain hose extends too far. The drain hose should I do? Washer will continue to drain out of the machine due to flow... -
Display shows F22 or FdL - Front-load washer
... allow the clothes to operate. To remove the error display, press Pause/Cancel twice. Before you washing a large load? Is the washer door firmly shut? This error code indicates that the door is not locking. The door must be latched. The door may not be completely closed for laundry items sticking... -
Damaged clothing - Top-load washer
... top-load washer with low-speed wash action and short wash times. Was a wire in seams before washing? Use a cycle with agitator Always measure liquid chlorine bleach. Damaged clothing - Were ...the wash water. Did you properly add the liquid chlorine bleach? Choose cycles with other wash items. Were strings, sashes and belts tied or removed to maintain washer balance. Tie...
Similar Questions
Washer Spins Clothes Are Wet And Water Remains In Bottom Of Washer.
How do I access drain to unclog?
How do I access drain to unclog?
(Posted by ccjohnson 8 years ago)
Whirlpool Washer Wtw4800xq Will Not Stop Spinning
(Posted by cdletas 10 years ago)
Home Depot Whirlpool Washer Wtw4800xq Instructions
Can you please tell me how to turn the machine off? (so light will go off)
Can you please tell me how to turn the machine off? (so light will go off)
(Posted by cabojo 10 years ago)