Whirlpool WGT3300XQ Support Question
Whirlpool WGT3300XQ Support Question
Find answers below for this question about Whirlpool WGT3300XQ.Need a Whirlpool WGT3300XQ manual? We have 5 online manuals for this item!
Question posted by dlhenny on January 26th, 2013
Capacity?
What is the Cubic Ft. load capacity for the WGT3300SQ1/2 washer and dryer?
Current Answers
Answer #1: Posted by bengirlxD on January 26th, 2013 8:29 PM
bengirlxD
Member since:
November 5th, 2012 Points: 6,395,085
Member since:
November 5th, 2012 Points: 6,395,085
Product Features
- 2.5 cu. ft. Washer
- 5.9 cu. ft. Dryer
Feel free to resubmit the question if you didn't find it useful.
Related Whirlpool WGT3300XQ Manual Pages
Use & Care Guide - Page 2
WASHER/DRYER SAFETY
2
Use & Care Guide - Page 14
..., if needed. Tumble a load of replacement on the label with the liquid fabric softener dispenser removed. Removing accumulated lint
From Inside the Dryer Cabinet Lint should be removed ...is empty.
2. This includes clearing piles of laundry in the Cycle knob.
Rinse dispenser under warm water, then replace it. WASHER/DRYER MAINTENANCE
WATER INLET HOSES
Replace inlet hoses after ...
Use & Care Guide - Page 15
... using your load is completely dry. Push the lint screen firmly back into the dryer during removal, check the exhaust hood and remove the lint. As needed cleaning Laundry detergent and... of the dryer. Cap the open fuel supply line. 5. Reinstalling the Washer/Dryer
Follow the "Installation Instructions" to a residue buildup. Clean lint screen. Cleaning the lint screen
Every load cleaning The ...
Use & Care Guide - Page 16
... off both water faucets.
2. Locate the light bulb cover on RINSE cycle for a medium-size load. Replace the bulb with the screw.
4.
Remove the cover.
3.
In Canada
REINSTALLING/USING WASHER/DRYER AGAIN
To reinstall washer/dryer after non-use washer/dryer again:
1.
Unplug dryer or disconnect power. 2. Put 1 qt. (1 L) of detergent for about 30 seconds to locate, level...
Use & Care Guide - Page 17
... in firm contact with floor, and washer/dryer must be level to operate properly.
Both hot and cold water faucets must be out of the cabinet.
Check floor for loading instructions.
Improper loading can restrict water flow.
17
Check for leaks (laundry tubs, drain pipe,
water pipes, and faucets.)
Washer not loaded as metal snaps, buckles, or...
Use & Care Guide - Page 20
... to improve cleaning. Always follow garment manufacturer's care label instructions. Not using correct cycle for fabric type.
Incorrect dispenser operation
Clogged dispenser.
Load garments in "Washer/Dryer Maintenance."
Undiluted bleach will damage fabrics. Monthly maintenance not done as cycle is started. Always read and follow the manufacturer's directions.
See "Cleaning...
Use & Care Guide - Page 21
... your hand under the outside exhaust hood clogged with temperature below 45ºF (7ºC).
Make sure the dryer door is a gas dryer.
Clean out pockets before each load. See "Installation Instructions." Use a time-delay fuse. Load too large and heavy to possibly avoid the cost of airspace, and, for small objects. Long venting will...
Installation Guide - Page 2
Washer/DRYER Safety
2
Installation Guide - Page 5
... with washer/dryer)
Your installation may require additional parts. For further information, please reference the "Assistance or Service" section of fill hoses
2 longer water fill hoses: 6 ft (1.8 m) Part Number 76314, 10 ft (3.0 m) Part Number 350008
5 To order, please refer to 1" (25 mm) diameter Standpipe Adapter Part Number 3363920, Connector Kit Part Number 285835
Laundry tub...
Installation Guide - Page 6
... installations.
n A water heater set to deliver 120°F (49°C) water to support the washer/dryer weight (washer/ dryer, water, and load) of installation and servicing. The washer/dryer must conform to introduce outside air into the dryer. Some water can remain in the washer and can cause damage in an area where it will need:
n A location that allows...
Installation Guide - Page 8
... should be at least 39" (990 mm) high; If you must be purchased separately. Laundry tub drain system
Minimum capacity: 20 gal. (76 L).
Minimum siphon break: 28" (710 mm) from bottom of washer/dryer. install no higher than 4.5" (113 mm) of washer/dryer. (Additional hoses may be at least 39" (990 mm) above floor;
DRAIN SYSTEM...
Installation Guide - Page 9
...the correct burner for use with appropriate conversion.
■■ Your washer/dryer must be provided. GAS TYPE
Natural Gas:
This washer/dryer is design-certified by CSA International for LP (propane or butane) ...gases with a different gas without consulting your Use and Care Guide. If this washer/dryer be made to convert the appliance from the gas specified on the rating plate in...
Installation Guide - Page 10
... pipe, as needed to the gas supply line. Do not use at altitudes up to 10,000 ft (3,048 m) above 10,000 ft. (3,048 m) a 4% reduction of the washer/dryer. The location should be installed within six (6) ft. (1.8 m) of the burner Btu rating shown on the model/serial number plate.
See illustration below.
■■ 1/2" IPS...
Installation Guide - Page 11
... each of the 2 rear legs in an up the front of the foot base.
2. Prepare to within 1" (25 mm) of the washer/dryer about 16" (406 mm) from the plug end. Move washer/dryer close to its final location.
1. Remove strap, hang tag, and pin
1. Discard end with a wood block or similar object that...
Installation Guide - Page 13
... many varieties. Venting Kits
For more information, call 1-800-807-6777 or visit us at www.whirlpoolparts.ca. white
W10186596 4-way vent kit - If your washer/dryer was previously exhausted from the right or left side. universal grey
4396028
Sure Connect™ venting kit (over-the-top installation)
4396009RP 5' Universal connect vent...
Installation Guide - Page 15
...CLAMP." Open clamp. Continue until hose contacts the ribbed stops on the side of the washer/dryer. Squeeze ears of the silver double-wire clamp with pliers to see whether it must be...floor drain installations, you will need additional parts with tap water. Place clamp over side of laundry tub. IMPORTANT: Do not use any lubricant other than water.
To keep the drain hose ...
Installation Guide - Page 17
... shipping strap removed earlier. Remove the access panel by removing 3 Phillips-head screws and one bumper, located at the top of washer/dryer installation.
6. Check for leaks
Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for leaks. Turn on water faucets to final location
7. Complete hookup of water may...
Installation Guide - Page 18
...Install the adapter on an approved noncorrosive leak-detection solution. If connecting to gas pipe. After washer/dryer is clean. Remove the 1/2" NPT adapter from flexible gas connector. NOTE: For LP gas ... compound for this connection. Connect vent
1. Dupont De Nemours and Company.
18
Move washer/dryer to final location, taking care not to exhaust outlet in the flexible gas connector. ...
Installation Guide - Page 19
... -end or adjustable wrench to turn the leveling foot clockwise to lower the washer/dryer or counterclockwise to prop up front of washer/dryer about 1/2" (13 mm) from the washer/dryer cabinet.
Level Washer/DRYER
IMPORTANT: Level washer/dryer properly to floor
(if needed . Check levelness of washer/dryer and repeat as needed )
Not Level
LEVEL
2. HELPFUL TIP: You may want to...
Dimension Guide - Page 2
...laundry tub.
Floor standpipe drain system Minimum diameter for ordering details.
DRAIN SYSTEM
Drain system can be inside the dryer. install no more than 96" (2.4 m) from bottom of washer/dryer...
Angled hoods
0
Rigid metal 37 ft. (11.3 m) 35 ft. (10.7 m)
1
Rigid metal 32 ft. (9.7 m) 27 ft. (8.2 m)
2
Rigid metal 24 ft. (7.3 m) 19 ft. (5.8 m)
NOTE: Side exhaust ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Product Registrations
...willing to take a moment to mail in Oven Combo Washer Dryer Compactor Cooktop Custom Laundry Option Dehumidifier Dishwasher Disposer Dryer - I register my product online? Gas Drying Cabinet ...card if you be improved? here . Compact Dryer - Gas Refrigerator Room Air Conditioner Warming Drawer Washer Front-Loading Washer Top-Loading Washer Top-Loading HE All Subs and have a: ... -
There are stains on the dryer drum
... dyes inside of the dryer? Thoroughly wipe drum with powdered laundry detergent and very warm water. Dryer Tumble a load of clothes. To avoid dye transfer, dry fabrics with the soft cloth until all excess dye and stains are stains on the dryer drum. Dryer My dryer makes sounds or vibrations My dryer or load has an odor My... -
Loads are wrinkled - Dryer
...load have the Wrinkle Shield feature (on the benefits of the cycle, wrinkles can cause wrinkling, too. Were the laundry items removed from the dryer before removing the laundry items from the dryer.... For best drying and wrinkle results, untangle items from the washer to the dryer? Allow the load to dry and are wrinkled. Was fabric softener used ? Find...
Similar Questions
Find A Pedestal That Fits The Whirlpool Duet Model Wfw9470wl01 Washer /dryer
Which Model Number Pedestal Fits The Whirlpool Duet Model Wfw9470wl01 Washer /dryer
Which Model Number Pedestal Fits The Whirlpool Duet Model Wfw9470wl01 Washer /dryer
(Posted by tom63524 6 years ago)
Washer - Dryer Purchased At Lowes
I have a Whirlpool Cabrio Platinum Washer-Dryer set purchased there and am trying to verify approxim...
I have a Whirlpool Cabrio Platinum Washer-Dryer set purchased there and am trying to verify approxim...
(Posted by tmurphy223 7 years ago)
Whirlpool Lp Conversion Kit
Which conversion kit do I use for the Whirlpool Washer/Dryer combo number WGT3300XQ. Where can I fin...
Which conversion kit do I use for the Whirlpool Washer/Dryer combo number WGT3300XQ. Where can I fin...
(Posted by jimfam 9 years ago)
Compare Washing Machine Models
What is the difference between model WGT3300X and WGT3300XQ
What is the difference between model WGT3300X and WGT3300XQ
(Posted by luluhodges 10 years ago)