Whirlpool WFW94HEXW Support Question
Whirlpool WFW94HEXW Support Question
Find answers below for this question about Whirlpool WFW94HEXW.Need a Whirlpool WFW94HEXW manual? We have 5 online manuals for this item!
Question posted by hank79953 on September 26th, 2011
How Do I Release The Control Lock On My Duet Washer?
When I tried to use the washer this morning I found the "control locked" light on, and can't figure out how to make the machine go.
Current Answers
Related Whirlpool WFW94HEXW Manual Pages
Dimension Guide - Page 1
...: 28" (711 mm) from bottom of drain hose should be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. install no higher than 96" (2.44 m) from bottom of washer. Front-Loading Automatic Washer
PRODUCT MODEL NUMBERS
WFW94HEX, WFW95HEX, WFW97HEX
OVERALL DIMENSIONS
Washer dimensions
51" (1295 mm)
27" (686 mm)
Custom under counter installation...
Installation Instructions - Page 2
... pedestal is available for ordering information, or see the Assistance or Service page on the back page of your Use and Care Guide. Beaded tie strap
Inlet hoses (2) with washers
Drain hose with washer)
n 8212656RP 10 ft. (3.0 m) Inlet hose, Black EPDM (2 pack)
n 8212641RP 5 ft. (1.5 m) Inlet hose, Black EPDM (2 pack)
n 8212546RP 4 ft. (1.2 m) Inlet hose...
Installation Instructions - Page 3
..." in door are the minimum required.
If a closet door or louvered door is installed, top and bottom air openings in Washer Use and Care Guide for winterizing information.
51" (1295 mm)
27" (686 mm)
38" (965 mm)
311/2" (800 mm)
All dimensions show recommended spacing allowed, except ...
Installation Instructions - Page 4
... of drain hose should be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. A 1/4" (6 mm) diameter to pump higher than 96 inches, a sump pump and associated hardware are needed .)
See requirements for a standpipe drain: 2" (51 mm).
IMPORTANT: To avoid siphoning, only 4.5" (113 mm) of washer. Select method you have an overhead...
Installation Instructions - Page 5
...n If codes permit and a separate ground wire is used, it will reduce the risk of electrical shock by providing a path of washer.
5 n Do not have a fuse in the neutral... grounding-type outlet, grounded in accordance with local codes and ordinances. For a permanently connected washer:
This washer must be run with the appliance -
n To minimize possible shock hazard, the cord must...
Installation Instructions - Page 6
...Slide each bolt and spacer to avoid suspension and structural damage, a certified technician must properly set up washer for relocation.
6 NOTE: If washer is not already in rear panel and close hole with transport
bolt hole plugs
Remove the yellow shipping strap...back with four transport bolt hole plugs included with separate directions. For a laundry tub or standpipe drain, go to step 9.
Installation Instructions - Page 7
...: Make note of which hose is seated on valve when attaching to faucets or washer. Water should be attached and have water flowing to the washer.
10. Damage can result. Do not use tape or sealants on washer. C onnect inlet hoses to water
faucets
For floor drain installations, you will cross over side of laundry tub...
Installation Instructions - Page 8
Use pliers to tighten couplings an additional two-thirds turn on top edges of washer
place level here
Attach hot water hose to hot water ...LEVEL
Not Level
16. Repeat, rocking washer from beneath washer.
Secure drain hose
Laundry Tub
Standpipe
Wall
4.54".5" (113 mm)
4.5" (113 mm)
4.5" (113 mm)
Grip washer from top and rock back and forth, making sure all four feet are in steps...
Use & Care Guide - Page 4
...on and off. Press to stop/cancel a cycle at any time.
2 WASH CYCLE KNOB Use your Wash Cycle Knob to turn the washer on non-Steam models.
4 See "Cycle Guide" for your washer. Steam models
2
1
3
4
5
8
7
9
C
B
6
D
A HE ...POWER BUTTON Press to select available cycles on all models. CONTROL PANEL AND FEATURES
Not all features and cycles are available on your laundry load.
Use & Care Guide - Page 5
...first rinse after the end of cycle. Drum Light (on some models) Turn this option to...Using the Dispenser" for about one second to turn button sounds on or off . Overloading, unbalanced loads, or excessive suds may affect the time shown in process, as well as load size, wash temperature, and water pressure may cause the washer to activate the EcoBoost™ option.
Control Lock...
Use & Care Guide - Page 8
... bags equally.
n Always read and follow fabric care labels and laundry product instructions. Separate delicate items from towels, rugs, and chenille fabrics. Close the washer door by recommended cycle, water temperature, and colorfastness.
For multiple items, use . USING YOUR WASHER
Choosing the Right Detergent
Use only High Efficiency detergents. The package will pick up of...
Use & Care Guide - Page 9
...in place of HE detergent into the washer too early.
If you may cause ...laundry products as described in the dispensers from the previous wash cycle. This is
completely closed. For liquid detergent, slide the selector to the right.
Use only High Efficiency (HE) detergent.
Make sure it is normal.
3. Do not overfill;
Liquid detergent may remain in steps 3-6. 3.
Use...
Use & Care Guide - Page 11
...time.
2. The delay countdown has started when the START/PAUSE light stops blinking.
12. Press and hold again to set the .... Once you press and hold the START/PAUSE button to start
Door Locked Sensing
FanFresh
G
Estimated Time Remaining S
W
W
Delay Set
Delay Start...available on non-Steam models. This may also cause the washer to begin wash cycle
Steam model shown
The display will ...
Use & Care Guide - Page 12
... the load. Once the door has locked the second time, the washer will light on .
Steam (on the door lock mechanism. This sensing process will light to the wash cycle as the washer goes through the washer.
Cycle Status Lights
Steam model shown
The Cycle Status Lights show that the cycle is using a Steam boost for added cleaning power. At...
Use & Care Guide - Page 13
...It may remain in the washer, "rL" will be displayed, and the WASH and CONTROL LOCK lights will determine whether clothing or...lock again, and then the cycle will unlock. The cycle will light. The door will continue. If you will be opened and then closed before it to finish. To clean exterior:
1. If the FanFresh™ option is complete. Make sure laundry drum is normal. Close washer...
Use & Care Guide - Page 14
... with a dry cloth and let the
washer interior air dry with a
clean towel, slide cover panel back onto posts on the release tab and pull straight out to
remove the...gal. (3.8 L) of dispenser with warm water. 6.
WASHER MAINTENANCE
CLEANING THE DISPENSER
You may find laundry product residue leftover in warm, soapy water, using the procedure that follows. Pull dispenser drawer out until ...
Use & Care Guide - Page 16
...
hose installation.
Inlet valve screens on .
F5E2 (door will not lock) Washer door not locking. Door has not been opened and closed for proper water supply.
error) appears in display
Washer making error beeps. Press POWER once to clear the display.
Use only HE detergent. Make sure that may be attached and have been removed.
Then press...
Use & Care Guide - Page 17
...normal to hear the pump making a humming sound with floor, and washer must be level.
Tighten ...locking or unlocking.
Gurgling or humming
Washer may not be unbalanced or too large. Avoid washing single items. Balance a single item such as a rug or jeans jacket with the floor and locked. Item or load not suitable for leaks (laundry tubs, drain pipe, water pipes, and faucets.) Only use...
Use & Care Guide - Page 19
... be out of wash cycle. Door locked at end of balance. Both hoses ...Washer not draining/ spinning, loads are available with tape. Use drain hose form and securely attach to No Spin.
FanFresh™ option not selectable
Desired setting or option does not light...use garment bags for your load.
Make sure hot and cold inlet hoses are not clogged. Not using HE detergent or using...
Use & Care Guide - Page 22
...or Normal washer operation.
Load may be increased. This ensures a gentle wash for proper flushing of lightly soiled garments... some models). This extends the cycle time.
First try the solutions suggested here or visit our website at ...laundry products dispensing too soon. The washer will start to the original cycle. The Quick Wash cycle is designed for load type.
When using...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer will not fill - Front-load Duet washer
... for proper fill. Duet Sport washer Washer is at the lowest 6 o'clock position. washer Can I use an extension cord. If...are designed to the washer and turned on. Find Manuals & Check to side. Make sure to operate....washer stops filling, press the Pause/Cancel button. Is Control Locked status light on water and check for each load. This will be removed from the washer. Your washer... -
How to get the best performance from my washer - Cabrio® HE washer with Dispensers in Corners
...not be changed . Quick Wash Use this cycle to wash lightly soiled garments indicating "Machine Washable Silks" or "Gentle" cycle...Garment light is not cleaning laundry - Warm water also helps reduce wrinkling. HE washer. For the best results, wash them alone using ... performance from fading and protect delicate fabrics. Try mixing different load items to reduce wrinkling. Whitest... -
Washer will not fill - Duet Sport washer
... a household fuse blown, or has a circuit breaker tripped? Turn off the Control Lock feature. Allow the cycle to occur, call an electrician. Each unit is shipped from the washer. Is the Delay Wash status light on ? If the door is a low-water-usage washer. Some models will fill from the top, while other models will...
Similar Questions
How To Turn Off The Annoying Beep Sound On Whirlpool Duet Washer And Dryer?
How to turn off the annoying beep sound on whirlpool duet washer and dryer?
How to turn off the annoying beep sound on whirlpool duet washer and dryer?
(Posted by Linval1974 3 years ago)
Hi, Having Multiple Issues With My Whirlpool Duet Washer.
Hi, having multiple issues with my Whirlpool Duet washer. First ran a cleaning cycle but stopped it ...
Hi, having multiple issues with my Whirlpool Duet washer. First ran a cleaning cycle but stopped it ...
(Posted by deandesimone1 9 years ago)
Whirlpool Duet Washer Wont Unlock Error E02 And F06
(Posted by eeapri 9 years ago)
Whirlpool Duet Washer Model Wfw94hexw Will Not Fill With Water
(Posted by jimbocmjud 10 years ago)
How Do I Change The Intake Filter For Whirlpool Wfw94hexw 1 Duet Washer
(Posted by nikkeith 10 years ago)