Whirlpool WFW94HEXL Support Question
Whirlpool WFW94HEXL Support Question
Find answers below for this question about Whirlpool WFW94HEXL.Need a Whirlpool WFW94HEXL manual? We have 5 online manuals for this item!
Question posted by Kdurkee on April 5th, 2014
Cleaning The Washer
The light is on to clean washer. I know you can use bleach. I can't find the instructions for this. Please help. Thank-you
Current Answers
Answer #1: Posted by Odin on April 5th, 2014 5:35 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
See the instructions at http://www.manualowl.com/m/Whirlpool/WFW94HEXL/Manual/160424?page=13.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WFW94HEXL Manual Pages
Dimension Guide - Page 1
... phone numbers on front page of drain hose should be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub.
or 20-amp, fused electrical supply is recommended that may be provided. IMPORTANT: To avoid siphoning, 4.5" (113 mm) of your Washer User Instructions. Wall standpipe drain system
41/2" (113 mm)
4" (102 mm)
3" (76...
Installation Instructions - Page 3
... to reduce noise transfer. For each arrangement, consider allowing more space for ease of 1" (25 mm) under counter installation:
4" (102 mm)
3" (76 mm)
24 in Washer Use and Care Guide for winterizing information.
51" (1295 mm)
27" (686 mm)
38" (965 mm)
311/2" (800 mm)
All dimensions show recommended spacing allowed, except...
Installation Instructions - Page 4
... Parts". A 1/4" (6 mm) diameter to pump higher than 96" (2.44 m) from bottom of laundry tub must be at least 30" (762 mm) high;
See "Alternative Parts". Select method you have an overhead... be needed . Top of washer. (Additional hoses may be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. IMPORTANT: To avoid siphoning, only 4.5" (113 mm) of...
Installation Instructions - Page 6
...
bolt hole plugs
Remove the yellow shipping strap from the cord. Connect Drain Hose
7. For a laundry tub or standpipe drain, go to drain port
Ribs
Close bolt holes on elbow end of drain ... to avoid suspension and structural damage, a certified technician must properly set up washer for relocation.
6 NOTE: If washer is not already in place on cabinet back with four transport bolt hole plugs...
Installation Instructions - Page 7
...: Make note of laundry tub. Damage can result. IMPORTANT: Only 4.5" (113 mm) of drain hose should run until it is connected to hot water to help in picture) or over each other when attached correctly.
11. IMPORTANT: Do not overtighten or use old hoses. You may need to washer correctly. Place drain hose in...
Installation Instructions - Page 9
... are about 4" (102 mm) with wooden block. q To test and clean your Washer Use and Care
Guide. Repeat as needed. HELPFUL TIP: You may want to see what was skipped. If there is plugged into a grounded 3 prong outlet
Jam nut
When washer is not level, use a 9/16" or 14 mm open -end or adjustable wrench to...
Owners Manual - Page 5
... when the door is preset for each stage, see "Cycle Status Lights". NOTE: Press and hold the EcoBoost button for about one second to turn the washer off the tones that allow the Deep Clean option.
8 FANFRESH™ OPTION With the washer on using the dispenser drawer.
See the "Cycle Guide" for cycles that sound...
Owners Manual - Page 6
...
Light
Warm
No Spin
Cold
Extra Rinse Deep Clean
Presoak EcoBoost FanFresh Delay Start
Uses an...Light
Warm
Low
Cold
No Spin
Extra Rinse Deep Clean
Presoak EcoBoost FanFresh Delay Start
Hot wash temperatures ensure liquid chlorine bleach action. Medium load: Fill the washer drum up to maintain load balance. An Extra Rinse helps remove any bleach...
Owners Manual - Page 7
... NSF International, an independent, third party testing and certification organization. The Clean Washer light will flash every 30 loads to remind you may wish to set to clean the interior of NSF Protocol P172 for that best fits the load being washed.
Uses more water to flush out allergens such as exposed to kill dust...
Owners Manual - Page 8
...Open the washer door. Separate delicate items from lightly soiled. Items need to move freely for best cleaning and to ensure the interior is clean before washing clothes. Washer door should...laundry product instructions. Improper usage may require a service call. Close the washer door by testing stain remover products on load type and cycle, the washer can set stains into washer
Use...
Owners Manual - Page 11
...START/PAUSE
to add 1 or 2 missed garments, you do so while the "Add a Garment" light is lit. Press START/PAUSE to the selected cycle. Overloading, unbalanced loads, or excessive suds may..., such as the EcoBoost™ option, Deep Clean/Deep Clean with Steam, and 12 hours on all cycles.
9. The washer door will unlock once the washer movement has stopped. Select any additional options
Steam...
Owners Manual - Page 12
... used, liquid chlorine bleach is normal. Steam (on some models) This will continue until the correct amount of a cycle. Done Once the cycle is active. Remove the load promptly for proper water removal, based on cycles with your load size.
You may change as the washer rinses and moves the load.
Cycle Status Lights...
Owners Manual - Page 13
... tub and the basket.
This is empty.
2. To keep washer interior odor-free, follow this recommended cleaning procedure at least once a month:
1. Using recommended AFFRESH® washer cleaner, add one tablet to washer basket
OR If using liquid chlorine bleach, add 1 cup (250 mL) to CLEAN WASHER cycle. The washer will add some water, and the basket will continue. If...
Owners Manual - Page 14
... find laundry product residue leftover in washer, then slide dispenser back into slot. Pull back the seal to inspect all areas under the seal and to
remove the dispenser. Wash dispenser and cover panel in warm, soapy water, using a damp cloth.
b) W ipe the seal area with warm water. 6.
Refer to the bleach manufacturer's instructions for...
Owners Manual - Page 15
... for relocation by a certified technician.
If storing or moving , or not using again, run
washer on both water faucets.
2. IMPORTANT: Call for a medium-size load.
15 Unplug or disconnect power to clean washer and remove antifreeze, if used. Unplug washer or disconnect power. If washer will not freeze. Bundle power cord with a permanent marker. Turn on RINSE...
Owners Manual - Page 16
... leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Only use HE detergent.
Objects caught in this Use and Care Guide. Gurgling or humming
Washer may not be tight against the stainless steel basket. It is uneven, a 3/4" (19 mm) piece of the cabinet.
Check all four fill hose flat washers properly seated? Periodically clean the the...
Owners Manual - Page 17
...
Possible Causes
Solution
Washer not performing as recommended. To remove suds, cancel cycle. Do not add more detergent.
Select RINSE/DRAIN & SPIN.
First try the solutions suggested here or visit our website at www.whirlpool.com/help for proper water supply. Check proper electrical supply.
Not using HE detergent or using too much HE...
Owners Manual - Page 19
... cycle for tough cleaning. If using correct cycle for fabric type.
Use a higher soil level cycle option and warmer wash temperature to move freely for best cleaning. First try the solutions suggested here or visit our website at www.whirlpool.com/help for assistance and to load. If you experience
Possible Causes
Washer not performing as...
Owners Manual - Page 20
... detergent for proper flushing of Oxi products from whites and lights. Mend rips and broken threads in cold or hard water.
Use cycle designed for the load.
Wipe up bleach spills. Undiluted bleach will damage fabrics. Do not use powdered or liquid laundry boosters in dispenser after washer is adequate to avoid snags and tears.
Sort dark...
Owners Manual - Page 21
... the door is flashing, reselect your desired cycle using a cold wash temperature, and press START/PAUSE.
Press POWER once to restart washer. Then press POWER again to clear the code.... restart Clean Washer cycle. Press START/PAUSE once to restart washer. Press POWER to clear the display.
Open and close the door to cancel the cycle. Follow detergent manufacturer's instructions. Do...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How to remove odors from a front-load washer without a Clean Washer cycle
...more times. Maintenance procedures for washers without a Clean Washer cycle Affresh washer cleaner method (recommended) NOTE: Completely read these instructions before using the correct amount of the washer interior. This residue is soil that is complete, leave the door slightly open after each cycle to complete. Clean the door seal of visible residue... -
How do I remove odors from my Top-loading HE washer?
... that all remaining washer cleaner or bleach is damp, use in your washer. Find Manuals & here . How do I remove odors from the washer. 1. Using the Affresh washer cleaner (recommended): the lid will lock, and the cycle will dispense in combination with Clean Washer cycle NOTES: Read these instructions completely before beginning the cleaning process. See your... -
Removing odors from a front-load washer with the Clean Washer cycle (on control panel)
... # How to remove odors from a front-load washer without a Clean Washer cycle How to allow for washers with Clean Washer cycle Affresh washer cleaner method (recommended) NOTE: Completely read these instructions before using the correct amount of liquid chlorine bleach to maintain washer freshness. This procedure helps keep odors from developing in your Affresh...
Similar Questions
How To Use I He Clean Washer With Affresh?
on my washer whirlpool cabrio wtw5500xw0 when and how do I use the cycle clean washer with affresh?
on my washer whirlpool cabrio wtw5500xw0 when and how do I use the cycle clean washer with affresh?
(Posted by yazzmoon3 7 years ago)
How To Clean Drain Pump On Wfw95hexlo Front Load Washer
Unlike most washers this model has no lower access panel to remove. How do I access, where is the dr...
Unlike most washers this model has no lower access panel to remove. How do I access, where is the dr...
(Posted by Anonymous-143938 9 years ago)
Washer Model Wtw57esvh1. The Extra Rinse Cycle Comes On When It Shouldn't
When washer in regular cycle and Extra rinse cycle off the washer will go to extra rinse at the end ...
When washer in regular cycle and Extra rinse cycle off the washer will go to extra rinse at the end ...
(Posted by ttngl 11 years ago)
Washer Front Loading
It sounds like there is some thing metal caught under the drum of my rv washer. Just started
It sounds like there is some thing metal caught under the drum of my rv washer. Just started
(Posted by Kmsathoff 11 years ago)