Whirlpool WFW9150WW Support Question
Whirlpool WFW9150WW Support Question
Find answers below for this question about Whirlpool WFW9150WW.Need a Whirlpool WFW9150WW manual? We have 4 online manuals for this item!
Question posted by CHEVMAN on December 29th, 2011
Why Does A New Washer Wfw9150w Dance All Over The Floor When Spinning
The person who posted this question about this Whirlpool product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Whirlpool WFW9150WW Manual Pages
Energy Guide - Page 1
... this label before consumer purchase. Government
Federal law prohibits removal of $1.218 per therm.
• For more information, visit www.ftc.gov/appliances. (P/N W10252712)
Clothes Washer Capacity: Standard
Whirlpool Corporation Models: WFW9150W*, WFW9250W*
Cat. U.S.
Owners Manual - Page 4
...fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).
■ A level floor with Washer
Color Model Number
10" (254 mm) 46" (1168 mm) White WHP1000SQ
15.5" (394 mm...the washer with foam backing, is your washer improves performance and minimizes noise and possible washer "walk." Do not operate your washer and dryer? Inlet hose washer (4) D. You will add to Buy
Laundry tub ...
Owners Manual - Page 5
... dimensions shown are for the recommended spacing. Recessed area B. Washer on all sides of installation and servicing. Custom undercounter installation - The door opens more than 90°, and it is not reversible.
■ Additional clearances might be required for wall, door, and floor moldings.
■ Additional spacing of 1" (25 mm) on pedestal...
Owners Manual - Page 6
... (view D) The floor drain system requires a siphon break that may require additional spacing. The siphon break must be purchased separately.
For cabinet installation, with stacked washer and dryer
The dimensions shown are for the recommended spacing.
48 in.2* (310 cm2) 24 in the top are required.
7" (178 mm) 7"
(178 mm)
A
B
Laundry tub drain...
Owners Manual - Page 8
... hole with the attached cap.
4. Then pull the power cord through both faucets and inlet hoses, into a laundry tub, drainpipe or bucket, to get rid of particles in back or other injury.
Connect the Inlet Hoses
Insert new flat washers (supplied) into hose couplings. Failure to do so can result. IMPORTANT: Position the...
Owners Manual - Page 9
... under "Tools and Parts." Secure the Drain Hose
Drain hose must be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Connect the inlet hoses to the washer IMPORTANT: Make sure that the flat washers have been placed into standpipe. Once drain hose is seated on the hoses for leaks. Attach the cold...
Owners Manual - Page 10
... the levelness of the drain hose into a grounded 3 prong outlet. If the washer faucets and the drain standpipe are in firm contact with the floor.
3. Check that you have all packaging materials. 5. Check that all parts are in the laundry tub or standpipe as shown. IMPORTANT: All four locknuts on . 6.
If there is...
Owners Manual - Page 11
... bear. FEATURES AND BENEFITS
Your new front-loading high efficiency washer, was designed to conserve resources and lower your new washer combines: ■ 2 Springs to isolate vibration
■ 3 Shock absorbers at the washer base to minimize movement
Stainless Steel Drum The stainless steel drum eliminates corrosion and enables higher spin speeds for more clothes at one...
Owners Manual - Page 12
...information. Turn on the washer by pulling on the top surface of this type of detergent will illuminate. When selecting a Wash Cycle, the preset Temp and Spin Speed for the selected cycle...washer door by turning the cycle selector. The door can be opened and then closed before a new cycle can cause poor cleaning.
■ Always empty pockets. Open the dispenser drawer and add laundry ...
Owners Manual - Page 13
... hear the door locking, unlocking, and locking again. Using the Dispenser
Your new washer has a dispenser drawer with less water, will likely result in hours) is... detergents are diluted and dispensed automatically at the best time during the desired time selected. Add the desired laundry products to avoid a spill). A C
B D
Dispenser A. Main Wash detergent compartment C. Fabric softener...
Owners Manual - Page 14
... Each cycle has a preset cycle time, TEMP, SPIN SPEED, and may have this feature except Rinse/Drain & Spin, and Clean Washer with all Options are disabled except for approximately 1 second...
Changing Cycles and Options
Not all Cycles. The washer powers down, the door unlocks, and clothes can be canceled, the items added, and a new wash cycle started
1.
To change Options after the...
Owners Manual - Page 15
... cycle provides a soak time with all Options (TEMP, SPIN SPEED) are needed in stains on your washing machine.
Not all Cycles.
Small Load
Use this cycle with AFFRESH® washer cleaner tablet or chlorine bleach to wash small loads of your laundry. Deslect Extra Rinse option.
This cycle uses a higher water level in...
Owners Manual - Page 16
... are part of normal washer operation. Spin Speed
Each cycle has a preset spin speed. You will not illuminate when selected. See "Troubleshooting." Not all cycles.
■ See the "Laundry Guide" section for an...garments. Normal Sounds
As with any new product, you will hear sounds that you are washing. Between changes in the normal rinse. These new sounds and pauses are sensed and ...
Owners Manual - Page 17
... fabrics labeled as machine washable
✔
✔
✔
✔
Rinse/ Drain & Spin
All loads
✔
✔
✔
✔
Soak
Fabrics made of
✔
&#...loads of cotton, linen, polyester, or nylon
✔
✔
Clean Washer
No clothes, use AFFRESH® washer cleaner tablet or chlorine
with AFFRESH™ bleach
17 Delicate
Curtains and delicate ...
Owners Manual - Page 21
... when you are found.
Shut off both water faucets. 5. Reconnect water inlet hoses to clean the washer and remove the antifreeze, if used . WARNING
5. If washer will be on a Rinse/Drain & Spin cycle. 3. Disconnect the drain hose from the drain system and attach to provide ventilation. Electrical Shock Hazard Plug into a grounded 3 prong...
Owners Manual - Page 22
... can drip off -balance
■ Is the washer level? Check both washer and dryer to keep them at the front of the washer.
■ Are the fill hoses tight?
■ Are the fill hose gaskets properly seated? Check household plumbing (laundry tubs, faucets, drainpipe, water pipes) for flooring requirements.
To determine your Error Code. pause...
Owners Manual - Page 23
... (on the touch-pad twice.
Select RINSE/DRAIN & SPIN to confirm the touch-pad/LED assembly is responding. The...Are the laundry products in the correct dispenser compartment?
Washer cycle won 't unlock
■ Did all High Efficiency washers. Press ... to allow the washer to the washer basket. Door won 't start a new cycle.
■ Is the door locked? Washer won 't shut off...
Owners Manual - Page 24
...down while holding outer tub steady and check for looseness (more than 96" (2.4 m) above the floor. A single or bulky item may decrease for smaller load sizes (2-3 items) of lightly soiled garments....■ Are you washing a single item or bulky load? This washer uses very little water to the washer. The top of the spin basket. Check if the valve is not clogged with additional tumbling.
...
Owners Manual - Page 25
... cycle for washing heavy soils in cold or hard water.
■ Is your wet laundry in the drum, and start a Rinse/Drain & Spin cycle. If the laundry is still wet, take half of the load out of dye, unload the washer as soon as it stops.
■ Did you use the right cycle for...
Dimension Guide - Page 1
Front-Loading Automatic Washer
PRODUCT MODEL NUMBERS WFW9150W
Electrical: A 120 volt, 60 Hz., AC only, 15- Drain System Options
Standpipe drain system - wall or floor (views A & B) The standpipe drain requires a minimum diameter standpipe of the laundry tub must be at least 30" (762 mm) high and no less than 96" (2.4 m) from the bottom of the...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Loads are wrinkled - Cabrio® washer with Dispensers in Corners
...and reduce setting of the cycle, wrinkles can result in the washer is connected to relax the wrinkles? The washer high spin speeds range from 900 to 1000 rpm to the faucets. Make...washer with Dispenser Drawer Cabrio® If safe for an extended period of the cycle. Reversed inlet hoses can set in the washer for too long after the end of new wrinkles when the load spins.... -
Loads are wrinkled - Top-load washer
... soon as Super Wash or Heavy Duty? Reduce load size if needed. washer with Dispenser Drawer Loads are wrinkled - Did the wrinkling occur while washing a large load? Large loads increase the likelihood of new wrinkles when the load spins. Cabrio® Load items need room to move in Corners Loads are wrinkled... -
Loads are wrinkled - Top-load HE washer with Dispenser Drawer
... another cycle with Dispenser Drawer - Large loads increase the likelihood of new wrinkles when the load spins. Cabrio® Loads are wrinkled - Check your water inlet hoses for details. Did the wrinkling occur while washing a large load? The washer high spin speeds range from 700 to 800 rpm to promptly remove loads...
Similar Questions
Wfw97hex Brand New Washer Has No Water And Say Wash Is Completed After Only 2 Mi
NEW Whirlpool washer can not fill water once.
NEW Whirlpool washer can not fill water once.
(Posted by andylo123 9 years ago)
Whirlpool Front Load Washer Wfw9150ww Will Not Spin
(Posted by rgalnaria 10 years ago)
New Washer Purchased Today
used the new washer today seems to work fine but when we move the tub around by hand ,it sounds like...
used the new washer today seems to work fine but when we move the tub around by hand ,it sounds like...
(Posted by meyersks 11 years ago)