Whirlpool WFC7500VW Support Question
Whirlpool WFC7500VW Support Question
Find answers below for this question about Whirlpool WFC7500VW.Need a Whirlpool WFC7500VW manual? We have 4 online manuals for this item!
Question posted by Mattfleming11 on August 24th, 2013
I Need A Control Knob For Whirlpool Washer Model Wfc7500vw
The control knob for our new washer broke clean off, and there is a spindle-type setup still attached to the metal shaft coming from the control panel. Can you help me find the proper part number for a replacement, and is it even possible to simply buy a new one and put it on myself? Thank you in advance...
Current Answers
Related Whirlpool WFC7500VW Manual Pages
Owners Manual - Page 3
... exposed to potential hazards that have been previously cleaned in, washed in, soaked in the washer. HYDROGEN GAS IS EXPLOSIVE.
any servicing unless specifically recommended in this manual and on or in , or spotted with controls.
■ Do not repair or replace any part of the washer or attempt any accumulated hydrogen gas. Always read...
Owners Manual - Page 4
... have the option of the washer. Location Requirements
Selecting the proper location for Part Number W10178021. Proper installation is attached to the back of fill 6 ft (1.8 m) Part Number 76314
hoses
10 ft (3.0 m) Part Number 350008
4
Optional pedestal
Pedestal Height
11.8" (30.0 cm)
Approximate Height with Washer
44.7" (113.5 cm)
Color White
Model Number
LAB0050PQ
Stack Kit
Are you...
Owners Manual - Page 6
... standpipe drain requires a minimum diameter standpipe of the washer.
30" min. (76.2 cm)
†
1" (2.5 cm)
23.4" (59.5 cm)
†
1" (2.5 cm)
*Min. Recommended installation spacing for cabinet installation
The dimensions shown are required.
7" (17.8 cm) 7" (17.8 cm)
A
B
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. Additional hoses might...
Owners Manual - Page 7
...a qualified electrician if you are not sure the washer is properly grounded.
■ Do not have a fuse in accordance with local codes and...washer is equipped with a power supply cord having an equipment-grounding conductor and a grounding plug. For a permanently connected washer: This washer must be grounded.
Failure to follow these instructions can result in doubt as to a grounded metal...
Owners Manual - Page 8
...properly set up for relocation by
hand until the bolts are removed, discard the bolts and spacers. Connect the Inlet Hoses
Insert new flat washers (supplied) into each of the hole and completely pull out the bolt, including the plastic spacer covering the bolt.
3. Attach... the rear panel.
Once all...laundry tub, drainpipe or bucket, to the valves can result in the couplings.
Owners Manual - Page 9
... coupling can result.
4. NOTE: Do not overtighten. NOTE: Replace inlet hoses after 5 years of the drain hose in the laundry tub or standpipe as shown.
B.
Read and follow these instructions.
See illustration C. Attach the cold water hose to its final location.
3.
A
B
C
4.
Floor drain You may need additional parts. See Floor drain under "Tools and...
Owners Manual - Page 11
..., it redistributes the clothes so that clothes coming out of the washer will be greater for this feature allows the washer to use whether you can handle slow speeds needed for highperformance cleaning. Use only HE High Efficiency detergent.
11 Electronic Controls
Flexible electronic controls are easy to do their cleaning. The products will have had a chance to...
Owners Manual - Page 12
...and run it without clothes. Using the Proper Detergent
Use only High Efficiency detergents.
NOTE: There is clean before washing clothes. See "Cycles."
5....WASHER USE
Starting Your Washer
WARNING
Fire Hazard Never place items in the washer that has ever had any type of oil on it (including cooking oils). Sort laundry according to produce the right amount of suds for this washer...
Owners Manual - Page 13
... hold START (for your laundry products-one is for detergent, one is for liquid chlorine bleach, and one is displayed. Fabric softener compartment (Letter D in hours) is for proper use the proper dispensers when adding laundry products.
Pull out the dispenser drawer. 2.
NOTE: Overfilling could cause an oversudsing condition.
6. The washer goes into the wash...
Owners Manual - Page 15
...Laundry Guide" section for an overview of possible options for each Wash Cycle selection.
■ If an option is locked or unlocked, and during the wash and rinse cycles. See "Cleaning Your Washer... water level. Rinse & Spin is useful for that need rinsing only. ■ Adding fabric softener to a load... unavailable with any new product, you are part of normal washer operation. This cycle...
Owners Manual - Page 16
...Control ATC (Auto Temp Control...10004;
Gentle Spin
✔ ✔
✔
Clean Washer
No clothes, use AFFRESH™ washer cleaner or chlorine bleach
Drain/Spin All loads
✔...washer cycles. To change the water temperature, select the WASH TEMP button until the desired setting is selected. The water temperature for suggested load types and their corresponding cycles.
Laundry...
Owners Manual - Page 19
... cycle. Once the cycle has begun, allow for the door to the bleach compartment.
WASHER CARE
Cleaning Your Washer
Cleaning the Door Seal/Bellow
1.
a) If no items are in combination with AFFRESH™ washer cleaner or liquid chlorine bleach to thoroughly clean the inside of liquid chlorine bleach to unlock. It will take approximately 1 minute for...
Owners Manual - Page 21
...knob or press and hold CANCEL/DRAIN to cancel the cycle. The four feet should be properly installed, and the nuts should be secured to the drainpipe or laundry tub. As with the floor. Between changes in washer... the door is on display (Drain Problem) Unplug washer or disconnect power. You may be in firm contact with metal snaps, buckles or zippers? WARNING
Electrical Shock Hazard ...
Owners Manual - Page 22
... hold START to exit, then wait for details.
■ Are the laundry products in odor.
■ Did you using an extension cord? Dispenser operation
■ Did you using AFFRESH™ washer cleaner on the water.
■ Is the water inlet hose kinked? After the CLEAN WASHER cycle is normal. Wipe up all High Efficiency...
Owners Manual - Page 23
... results, add detergent to provide good cleaning results. Transfer of dye can reduce spin speed. Do not overload the washer. The washer can be balanced. The hose needs an air gap. When excessive suds are...the load is normal.
■ Are you using the Quick Wash or Delicate cycles, you sort properly? When using HE detergent? Add items or try again.
■ Did you washing a single...
Owners Manual - Page 25
... in the United States.
Accessories
Enhance your washer with any questions or concerns at 1-800-253-1301, or your nearest designated service center.
To locate the Whirlpool designated service company in your area, you still need help us to better respond to order replacement parts, we recommend that you need further assistance, you the cost of...
Owners Manual - Page 26
... other than normal, single-family household use of purchase or installation date for repairs.
WHIRLPOOL SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. Major appliances with original model/serial numbers that is operated and maintained according to instructions attached to or furnished with electrical or plumbing codes, or use or when it was...
Dimension Guide - Page 1
...Washer
PRODUCT MODEL NUMBERS
WFC7500V
Electrical: 120-volt, 60 Hz, AC-only, 15- Recessed area B. wall or floor (view A & B) The standpipe drain requires a minimum diameter standpipe of the laundry...Min. The top of the standpipe must be needed.
30" min. (76.2 cm)
30" min. (76.2 cm)
26" min. (66 cm)
A
B
Because Whirlpool Corporation policy includes a continuous commitment to improve ...
Energy Guide - Page 1
... Washer Capacity: Standard
Whirlpool Corporation Model: WFC7500V* Cat. H8NB6A0A(3B)
Estimated Yearly Operating Cost
(when used with an electric water heater)
$16 ▼
$10
$71
Cost Range of Similar Models
...depend on your utility rates and use.
• Cost range based only on standard capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national...
Warranty - Page 1
... and is reported to correct defects in accordance with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will need it. If you may find this warranty.
8.
Write down the following information about your sales slip together for in accordance with original model/serial numbers that is not available.
10. This limited warranty is valid...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Nothing operates on my microwave oven
...the electronic oven control correctly set . The only control that will rotate (if set On). If any controls are in the Learning Mode, the oven light will come on the control panel. The Learning ...activation is possible only when the oven is in the lower, left command area with real displays and tones, without actually turning on some models): Touch and hold Cancel control for learning... -
Why won't my SpeedCook microwave oven with convection operate?
...properly? If water does not heat, call the Whirlpool Customer eXperience Center toll-free: 1-866-698-2538 Child Lock: The Child Lock disables all controls to use of the oven. The only control that will function while the Child Lock is active is in your product model number...control panel....possible...some models) attached to...controls are operating in the Learning Mode, the oven light will come... -
How do I clean the Control Panel/Interactive Touch Display on my SpeedCook microwave oven with convection?
.... Child Lock (on cleaning products. Damage may occur. Oven door is in standby mode. See "Child Lock" section below. Child Lock activation is possible only when the oven ... I clean the Control Panel/Interactive Touch Display on my SpeedCook microwave oven with convection, and how does it work? Always follow label instructions on some models): The Child Lock disables all controls are ...
Similar Questions
Can The Front Access Panel Be Removed Without Removing The Control Panel Above I
I have a dryer stacked on the Whirlpool WF7500vw2 and can not remove the Control panel.Can the front...
I have a dryer stacked on the Whirlpool WF7500vw2 and can not remove the Control panel.Can the front...
(Posted by tf22 1 year ago)
I Need A Bellow For Model No W10275729c Bellow Is Torn Along Edge
i need a bellow for front loader model number W10275729C
i need a bellow for front loader model number W10275729C
(Posted by Drjulietchester 7 years ago)
I Need To Know The Procedures For Removing The Control Panel Wfc7500 Whirlpool
What is the specific procedure for removing the control panel from a Whirlpool WFC7500VW washing mac...
What is the specific procedure for removing the control panel from a Whirlpool WFC7500VW washing mac...
(Posted by lenalton 9 years ago)
Warranty Period Of The Newly Replaced Control Panel For Washing Machine
what is the warranty period of the newly replaced control panel for the whirlpool washing machine fu...
what is the warranty period of the newly replaced control panel for the whirlpool washing machine fu...
(Posted by radhasujana 12 years ago)