Whirlpool WET3300XQ Support Question
Whirlpool WET3300XQ Support Question
Find answers below for this question about Whirlpool WET3300XQ.Need a Whirlpool WET3300XQ manual? We have 5 online manuals for this item!
Question posted by boyebirdd on August 18th, 2014
What Type Of Power Cord Does A Wet3300xq Take
The person who posted this question about this Whirlpool product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Whirlpool WET3300XQ Manual Pages
Installation Guide - Page 4
...) n Vent clamps n Vent elbows and ductwork
Inlet hoses with washer/dryer)
Your installation may require additional parts.
Optional equipment: (Not supplied with washer/dryer) Refer to 1" (25 mm) diameter Standpipe Adapter Part Number 3363920, Connector Kit Part Number 285835
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available...
Installation Guide - Page 5
...this washer/dryer. n A separate 30-amp circuit.
n If you are required. Do not operate your dryer at the end of the door are using a power supply cord, ...Washer/Dryer Care" in .2 (155 cm2)
3" (76 mm)
The spacing dimensions above are acceptable.
The installation must conform to the washer.
Louvered doors with a door, minimum ventilation openings in a basement, laundry...
Installation Guide - Page 7
...high; IMPORTANT: To avoid siphoning, no higher than 4.5" (113 mm) of wash tub. Top of washer/dryer. Floor drain system
Floor drain system requires a Siphon Break Kit (Part Number 285834), 2 Connector ... no higher than 96" (2.4 m), you need a sump pump system.
Top of washer/dryer. Floor standpipe drain system Minimum diameter for floor standpipe drain system. If you must install higher than 96...
Installation Guide - Page 8
...qualified electrician if you are not sure the washer is not available, it here. The cord should contain:
n A UL listed 30-amp power supply cord, rated 120/240 volt minimum.
U.S.A. If... three 10-gauge copper wires and match a 3-wire receptacle of NEMA Type 14-30R.
ELECTRICAL REQUIREMENTS - or 4-prong, grounding-type outlet, grounded in the neutral or ground circuit. n Do not have...
Installation Guide - Page 9
... recommended.
For further information, please reference service numbers located in conformance with a CSA International Certified Power Cord intended to be sure that you use Power Supply Cord Replacement Part Number 9831317. CANADA
It is your "Use and Care Guide."
9 A time-delay fuse or circuit breaker is 5 ft. (1.52 m) long. Connect to an ...
Installation Guide - Page 11
... "3-wire Direct Wire Connection" section. Hold-down screw (D) and terminal block cover (A). Electrical Connection (U.S.A. Choose electrical connection type
Power supply cord 4-wire receptacle (NEMA Type 14-30R): Go to "3-wire Power Supply Cord Connection" section. External ground conductor screw C. Neutral ground wire F. Remove hold-down screw E.
Then go to "Venting Requirements...
Installation Guide - Page 12
... plug
Spade terminals with the dryer cabinet and be in place. Power supply cord 3-wire receptacle (NEMA Type 10-30R): Go to connect neutral ground wire and neutral wire. Power Supply Cord Connection
Power supply cord strain relief
1. A ttach power supply cord strain relief A B
4-wire Power Supply Cord Connection
IMPORTANT: A 4-wire connection is inside the strain relief. Prepare to...
Installation Guide - Page 13
... conductor to outer terminal block screws. Connect ground wire (F) (green or bare) of power supply cord to outer terminal block screws. Tighten screw.
2. Tighten screw.
3. Secure cover with upturned ends
Ring terminals
13 Connect remaining wires
3-wire receptacle (NEMA type 10-30R)
3-prong plug
Connect remaining wires to neutral wire. Finally, reinsert tab...
Installation Guide - Page 16
... wire) (C) of remaining direct wire cable wires under center terminal block screw (B). Secure cover with hold -down screw. Connect remaining wires
Place hooked ends of power supply cord or cable under outer terminal block screws (hooks facing right).
Connect neutral wire
2.
Installation Guide - Page 18
...at www.applianceaccessories.com. VENTING Plan Vent System
Recommended exhaust installations Typical installations vent the washer/dryer from the right or left side.
D A
Alternate installations for your washer/dryer was previously exhausted from the rear. Select the type best for close -clearance alternate installations are possible. E F
B
G
C
H
A. Dryer B. Rigid metal or flexible...
Installation Guide - Page 21
... valve when attaching to hot water faucet.
Do not use a Y-adapter (not included).
1. Clear water lines
Washer
Coupling
Insert a new flat washer into a laundry tub, drainpipe, or bucket to water faucets with new inlet hoses with flat washers (not provided). n Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found...
Installation Guide - Page 22
... that vent is in dryer. Check for leaks. Connect vent to exhaust outlet
Turn on water faucets to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with a 4" (102 mm) clamp.
2. Move washer/dryer to final location, taking care not to exhaust outlet in place, remove corner posts and cardboard...
Installation Guide - Page 24
..., open the dryer door and feel for use if the washer/dryer should be 2 household fuses or circuit breakers for the dryer. If there is first used. Level Washer/DRYER
In Canada
4. If there is closed.
See "Level Washer/Dryer."
In the U.S.A.:
q For power supply cord installation, plug into a grounded outlet.
• Electrical supply is...
Use & Care Guide - Page 4
... side swing or hamper door
Drying rack - white All-purpose appliance cleaner
Laundry supply storage cart
This washer does not include inlet water hoses. As a result, water levels will ...cleaning performance while using less water and energy compared to older traditional washers. ft (0.18 cu. m) -
Traditional washer
Reduced water washer
4 For more high-quality items or to . In Canada call...
Use & Care Guide - Page 6
... KNOB Use your Dryer Cycle knob to select available cycles on the type of cycles.
Turn the knob to select a cycle for your load size.
Appearance may select a Wash Temperature based on your laundry load. It ensures that of pre-2011 washers.
4 FABRIC SOFTENER This option must be selected if using fabric softener...
Use & Care Guide - Page 15
...to remove residue buildup.
4. See "Venting Requirements." As needed cleaning Laundry detergent and fabric softener residue can increase drying time. To wash: 1....Close shut-off water supply to washer, to avoid flooding due
to gas supply
line. 4. Clean lint screen. Moving Care
For power supply cord-connected washer/dryers: 1. Use tape to secure washer/dryer doors. Roll lint off ...
Use & Care Guide - Page 16
... and remaining water.
3. Replace the bulb with the screw.
4. To winterize washer/dryer:
1. Drape power cord over doors and down front of washer.
4. Remove the cover.
3. In the U.S.A. If washer/dryer will not freeze. In Canada
REINSTALLING/USING WASHER/DRYER AGAIN
To reinstall washer/dryer after non-use washer/dryer again:
1. Place inlet hoses and drain hose inside...
Use & Care Guide - Page 18
... pockets and use an extension cord. Cycles with lower spin speeds remove less water than cycles with a low spin speed. Washer not loaded as expected (cont.)
Solution
Washer won't run . opening.
... to run or fill, washer stops working (cont.)
Check proper electrical supply.
Use the recommended cycle/speed spin for washer to determine if load is power to slow or stop draining...
Use & Care Guide - Page 21
...material. Proper operation of the door.
Closet doors must have heat.
PUSH to vibrate.
Incorrect power supply.
The drum may be turning, but you do not feel air movement, clean exhaust...breaker. If the problem continues, call ...In U.S.A. Electric dryers require 240-volt power supply.
Unusual sounds
Wrong type of non-use. Dryer had a period of fuse. A coin, button, or...
Dimension Guide - Page 2
...113 mm) of washer/dryer. If you will help achieve best drying performance.
IMPORTANT: To avoid siphoning, no more than 96" (2.4 m), you must be inside the dryer.
Laundry tub drain system
...of the line. Number of 90° turns or elbows
Vent System Chart
Type
Box/louvered
of washer/dryer. (Additional hoses may be purchased separately. Rigid or flexible metal exhaust...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
My electric range is not working.
... . Make sure that the power cord is plugged in . Find a local service provider: Product Category Washer or Dryer Refrigerator or Freezer Dishwasher Electric Range, Oven or Cooktop Gas Range, Oven or Cooktop Microwave Trash Compactor Window Air Conditioner Hot Water Dispenser Vent Hood Ice Machine Commercial Laundry Vacuum Cleaner Central Vac Dehumidifier Nothing... -
Washer will not fill - Front-load Duet washer
...);return false;" href="#"> Lookup Model # Answers others found helpful Washer will not fill - Front-load washer Display shows an error code - Plug power cord into a grounded 3 prong outlet? Has a household fuse blown... deep fill washer. The amount of the shipping bolts, and the four plastic spacers that the washer is not cleaning laundry - If the washer is on this washer should seem low... -
How do I open the lid?- Top-Load HE with Dispenser Drawer
... unlock lid: Plug in Corners The door will not open - This will unlock once washer movement has has stopped. Front-load washer Display shows dU - Top-Load HE with Dispensers in the power cord. Are you installing the washer? Open lid Display shows "lid" - Under certain conditions, the lid may take several...
Similar Questions
Power Cord
My dog bite up the coad. Can i replace it on my own. Is it easy to do?
My dog bite up the coad. Can i replace it on my own. Is it easy to do?
(Posted by anuhea03 10 years ago)
Why Does Wet3300xq Washer Rinses In Hot Instead Of Cold
(Posted by smoamand 10 years ago)
There Is No Power Going To Machine
outlet is good but no power to machine
outlet is good but no power to machine
(Posted by skydoghannon 11 years ago)
Wet3300xq Need Schematic
have this unit, dryer dead, checked fuses, door switch, push to start switch, 2 thermal fuses ok
have this unit, dryer dead, checked fuses, door switch, push to start switch, 2 thermal fuses ok
(Posted by gator904 11 years ago)
Dryer Rack For Model Wet3300xq
What is sthe correct part number for the dryer rack for model WET3300XQ ?
What is sthe correct part number for the dryer rack for model WET3300XQ ?
(Posted by brianmbradley 11 years ago)