Whirlpool WET3300SQ Support Question
Whirlpool WET3300SQ Support Question
Find answers below for this question about Whirlpool WET3300SQ - 27" Stack Washer.Need a Whirlpool WET3300SQ manual? We have 2 online manuals for this item!
Question posted by emmersonalleyne on June 22nd, 2011
Whirlpool Wet3300sq1 Washer/dryer
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt broke switch has a blue lead on one end that is connected to the spare terminal of the over load protector.The second lead to the belt broken switch has no lead and I don't know where to connect it.The manual that came with the motor bullet 7 says to connect the yellow (BK2) wire lead from the main harness to the vacant terminal on the broken belt switch.There is no yellow wire in the main harness............help!!!!!Read more: http://forum.appliancepartspros.com/dryer-repair/254098-emmerson.html#post470730#ixzz1Q3ZFB5ac http://forum.appliancepartspros.com
Current Answers
Related Whirlpool WET3300SQ Manual Pages
User Instructions - Page 1
... Interaction Centre
1901 Minnesota Court Mississauga, Ontario L5N 3A7
In Canada, visit www.whirlpool.ca.
You will need it. Write down the following information about your appliance to know your sales slip together for future reference. ®
WASHER/DRYER USER INSTRUCTIONS
INSTRUCCIONES PARA EL USUARIO DE LA LAVADORA/SECADORA
INSTRUCTIONS D'UTILISATION DE LA...
User Instructions - Page 2
... and on your gas supplier from a neighbor's phone.
Do not store or use any electrical switch; This is , tell you cannot reach your gas supplier, call your appliance. This symbol alerts... WARNING
You can kill or hurt you what the potential hazard is the safety alert symbol. WASHER/DRYER SAFETY
Your safety and the safety of fire or explosion, or to prevent property damage, personal...
User Instructions - Page 3
... the washer/dryer is used near children.
■ Before the washer/dryer is removed from each load.
■ Under certain conditions, hydrogen gas may contribute to a chemical reaction that could cause a load to ... an open flame during this time.
■ Do not repair or replace any part of the washer/dryer or attempt any accumulated hydrogen gas. Failure to follow basic
precautions, including...
User Instructions - Page 4
... through the wash water.
Pour bleach around the agitator, not directly onto the load.
■ Follow directions on wool, silk, spandex, acetates, or some flameretardant fabrics.
Drop a sorted load of clothes loosely into your dryer in the rinse cycle.
NOTE: Your washer/dryer does not come with a pouring spout to avoid spilling. Clean exhaust vent...
User Instructions - Page 5
...with a damp cloth to follow these instructions can retain wear wrinkles and have an END OF CYCLE SIGNAL.
The signal will not agitate or spin with warm water. ...
■ To restart the washer, close the door. Turn the WATER LEVEL selector to start the washer.
This booklet covers several different models. Your dryer may change the load size or water level selection ...
User Instructions - Page 6
... squeezing the screen
and pulling on some models): 1. Water Inlet Hoses
Replace inlet hoses after 5 years of your washer interior by lint can build up . 2. Style 2: 1. Wipe drum thoroughly with your load is probably clogged if lint falls off the screen into your dryer and will not stain future loads of hose failure. These stains are...
User Instructions - Page 7
.... 4. If storing or moving your washer/dryer. If you will be on vacation or not using your washer/dryer only when you are away. Flush water pipes and hoses. 2.
Unplug washer/dryer or disconnect power. Use masking tape to locate, level and
connect the washer/dryer. 2.
Do not use an adapter.
Non-use washer/dryer again 1. This helps avoid
accidental flooding...
User Instructions - Page 8
...Turn on some models)? Straighten the ...washer.
See the Installation Instructions.
■ Is the washer/dryer level? Evenly distribute the load in the washer basket and make sure the height of the load...washer stops
■ Is the indicator on water and check for about 2 minutes during wash? Replace the fuse, or reset the circuit breaker. Allow the cycle to the drainpipe or laundry...
User Instructions - Page 1
...Legs 12 Connect the Drain Hose 12 Connect the Inlet Hoses 13 Secure the Drain Hose 14 Plan Vent System 14 Install Vent System 15 Level Washer/Dryer 15 Connect Vent ... - 27" (69 CM) ELECTRIC WASHER/DRYER INSTALLATION INSTRUCTIONS
INSTRUCCIONES DE INSTALACIÓN DE LA LAVADORA/ SECADORA ELÉCTRICA DE 27" (69 CM)
INSTRUCTIONS D'INSTALLATION LAVEUSE/SÉCHEUSE ÉLECTRIQUE DE 27" (...
User Instructions - Page 2
...Number 285442
Lint clogged drain
Drain protector, Part Number 367031
Water faucets beyond reach of the Washer/Dryer User Instructions.
INSTALLATION INSTRUCTIONS
Tools ... Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)
1" (2.5 cm) diameter standpipe
2" (5 cm) diameter to 1" (2.5 cm) or open-end wrench (for adjusting washer/dryer feet)...
User Instructions - Page 3
...49°C) water to support the washer/dryer weight (washer/ dryer, water and load) of an automatic cycle. Some codes limit, or do...end of 500 lbs (226.8 kg).
■ A level floor with vents
*Required spacing
**Rear clearance may not operate correctly if washer/dryer is lined up directly with a door, minimum ventilation openings in .2 (155 cm2)
1" 27...
User Instructions - Page 4
... "Alternate Parts." When the neutral ground wire is secured under the neutral terminal (center or white wire) of the terminal block. If using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. Electrical Connection
To properly install your washer/dryer, you must be used , it here.
■ This...
User Instructions - Page 5
... terminal or lead on the washer/dryer....Replacement Part Number 9831317.
This washer/dryer uses a cord having an equipment-grounding conductor and a grounding plug.
WARNING: Improper connection...connected washer/dryer: This washer/dryer must be grounded. If your outlet looks like this :
4-wire receptacle (14-30R)
Then choose a 4-wire power supply cord with ring or spade terminals...
User Instructions - Page 8
...) of power supply cord under the screw of extra length so washer/dryer can be moved if needed. Strip 5" (12.7 cm) of the wire under center, silvercolored terminal block screw. Connect ground wire (green or bare) of power supply cord to the terminal block, place the hooked end of outer covering from external ground conductor screw...
User Instructions - Page 9
... together and tighten screw, as shown.
9 Shape ends of extra length so washer/dryer can be moved if needed. Tighten screws.
4. 3. Tighten screw. CD B
1. Loosen or remove center, silver-colored terminal block screw. 2. External ground conductor screw B.
Ring terminals G. Center silver-colored terminal block screw D. Connect the other power supply cable wires under the...
User Instructions - Page 11
...Whirlpool...dryer is recommended to avoid sagging and kinking that extend into any plastic or metal foil vent with screws or other fastening devices that may result in enclosed walls, ceilings or floors.
WARNING: To reduce the risk of fire, this is not plugged with lint.
■ Replace...Exhaust vent must be connected into the interior of the Washer/Dryer User Instructions. Venting...
User Instructions - Page 12
... the correct holes at least 12" (30.5 cm) from the end.
¼" (6.4 mm)
4. Connect the Drain Hose
Proper connection of the washer/dryer until hose contacts the ribbed stops on the cabinet.
2. Squeeze ears of the washer/dryer. Tilt the washer/dryer forward. Pull yellow strap firmly, until the washer/dryer is required for proper leveling. To keep rodents and insects...
User Instructions - Page 13
...laundry tub, drainpipe or bucket to get rid of particles in a closet or recessed area Move the washer/dryer into its final location and remove cardboard from going back into the washer: ■ Do not force excess drain hose into each end of washer/dryer... make sure that the hot water hose is connected to reduce the risk of the laundry tub. NOTE: Replace inlet hoses after 5 years of use tape ...
User Instructions - Page 14
Optional exhaust installations
This washer/dryer can be converted to rear exhaust by using standard offset connections. To cover the hole in the shipping strap (see illustration above). A
B
C
If the water faucets and the drain standpipe are recessed, put the hooked end of shipping strap. Push fastener into the nearest hole in the side, one...
User Instructions - Page 15
... to exhaust hood. Determine vent length and elbows needed for free movement as shown above. Connect vent to use an adjustable or open-end wrench to exhaust outlet in the "Install Leveling Legs" section. Level Washer/Dryer
Properly leveling your washer/dryer avoids excessive noise and vibration. 1. Check the levelness of Vent 90º turns or...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Detergent is on the load - Front-load washer
... HE High Efficiency detergent. Powdered detergent may need to use only HE High Efficiency detergent. Detergent remains in my washer? Front-load washer Detergent dispenser is not opening Detergent is on the load - Laundry detergents are formulated to extend the shelf life. Was a low-speed wash cycle used , it will be difficult to use... -
The water temperature is not correct - Top-load HE washer with Dispenser Drawers - video
... correct - Are you have hot water, and then begin a load of the inlet hose connections. The water temperature is normal. washer with Dispensers in each of laundry. Check that there are in Corners You may be cooler than I expect - Top-load HE washer with Dispenser Drawers - Top-load washer Display shows LF - See the Installation Instructions for details... -
Not draining, not spinning out water, wet loads - Top-load HE washer with Dispenser Drawer - video
.... My Cabrio High Efficiency washer isn't draining or spinning out enough water. The lid must be closed during operation. The washer will not be able to run at the end of drainhose is in very wet loads. Find Manuals & Top-load washer Not draining - Was a Low Spin or No Spin...
Similar Questions
Stackable Washer Dryer 27'
Does the dryer vent from the back or the top?
Does the dryer vent from the back or the top?
(Posted by ChrisMRadke 8 years ago)
How To Replace Lid Switch On Whirlpool Stacked Washer Dryer, Wet3300sq1
(Posted by highgary 9 years ago)
Which Way Do Wires Plug Back Into Heating Element On Dryer
Which way do wires plug back into heating element of washer dryer combi model num wet3300sq1
Which way do wires plug back into heating element of washer dryer combi model num wet3300sq1
(Posted by Johnstoncav 10 years ago)
Whirlpool Wet3300sq1 Washer/dryer Combo
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
(Posted by emmersonalleyne 12 years ago)