My Front Load Washer Flashes F35 And Doesn't Complete The Cycle.

About two weeks ago, my front loading washing machine doesn't dispense water into the tub and flashes F35 code. If I happen to notice and press "Pause/Cancel" sometimes it completes the cylce, other times it stops as if it completed the cycle. Please help!

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on June 9th, 2010 2:38 PM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,710

1,100
points

If this failure is displayed, there is a malfunction of the steamer component detected by the Steamer Electronic Board.

Possible Causes/Procedure

1. Check if pressure hose is fixed correctly.
2. Check if the airtrap is not blocked.
3. Check if the hose is not blocked.

(From this webpage)

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Whirlpool Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

How to remove odors from a front-load washer without a Clean Washer cycle
.... The oxygenated bubbling action helps to complete. Pressing Pause/Cancel twice will turn off the washer. Leave the door slightly open to remove odors from a front-load washer without a Clean Washer cycle. See list of models . Close the washer door and dispenser drawer. If your Affresh washer cleaner If your washing machine unless the fabric you have...
Display shows Sud or Sd - Front-load washer
... the Cycle Complete light is in the window: There are necessary and may occur several times to use in the washer or reconnect the power. Long Cycle Times and Excessive Suds Error Codes IMPORTANT: Use only HE High Efficiency detergent. To remove the error display, press Pause/Cancel twice. Plug in my washer? Display shows an error code - Let the cycle continue...
Loads are damp; dryer does not dry
There are many reasons why your loads may change the preset Dryness level settings to increase the dryness. This change will become your satisfaction. Check the following links for all Sensor Dry cycles. Dryer Dryer does not heat - Press Pause/Cancel at any time to your new preset drying setting for possible causes and...