Whirlpool RF263LXTT Support Question
Whirlpool RF263LXTT Support Question
Find answers below for this question about Whirlpool RF263LXTT.Need a Whirlpool RF263LXTT manual? We have 4 online manuals for this item!
Question posted by cophiez on September 8th, 2014
What Is Error Code F9eo?
We have an error code F9EO on the screen? What does that mean? Every button can not work.
Current Answers
Answer #1: Posted by Odin on September 8th, 2014 12:29 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Oven Door Lock Failure - Check door lock switches and wiring. Check for stuck lock switch.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool RF263LXTT Manual Pages
Dimension Guide - Page 1
... local codes do not permit ground through flexible or nonmetallic sheathed, copper or aluminum cable. Model/serial rating plate (located on the left side frame behind
storage drawer panel)
*Range can be... supply cord rated at 250 volts, 40 or 50 amps and investigated for use with ranges. For minimum clearance to top of cooktop, see Installation Instructions packed with leveling legs screwed...
Installation Instructions - Page 1
...REQUIREMENTS 3
Tools and Parts 3 Location Requirements 3 Electrical Requirements - Only 4 INSTALLATION INSTRUCTIONS 6 Unpack Range 6 Install Anti-Tip Bracket 6 Electrical Connection - Only 7 Verify Anti-Tip Bracket Location 12 Level Range 12 Storage Drawer 12 Complete Installation 13 Moving the Range 14 ANTI-TIP BRACKET TEMPLATE 15
IMPORTANT:
Save for local electrical inspector's use...
Installation Instructions - Page 2
..., if the range is the safety alert symbol. This symbol alerts you to potential hazards that can be killed or seriously injured if you and others are not followed. These words mean:
DANGER
You ... you how to follow the safety alert symbol and either the word "DANGER" or "WARNING." RANGE SAFETY
Your safety and the safety of injury, and tell you don't follow instructions. Always read...
Installation Instructions - Page 3
...transit. See "Electrical Requirements" section. Mobile home installations require:
■ When this range must be revised. The appliance wiring will not discolor, delaminate or sustain other damage.
...for use with ranges. When such standard is installed in a mobile home, it conforms to make sure that are shown must be avoided. Check local codes. Additional Installation ...
Installation Instructions - Page 4
... electrical installer determine that the electrical connection and wire size are in accordance with the National Electrical Code, ANSI/ NFPA 70-latest edition and all local codes and ordinances. Product Dimensions
A
C
B
A F
B C
D
E F
E
D
A. 27 69.9 cm) max. A freestanding range may be installed next to top of the above the cooktop surface. D. 30¹⁄₈...
Installation Instructions - Page 5
... is less than the total connected load listed on the oven frame behind the storage drawer panel. If connecting to a 4-wire system: This range is connected to a 3-wire system: Local codes may permit the use a 4-wire power supply cord rated at the junction box).
■ Wire sizes and connections must conform with...
Installation Instructions - Page 6
... flush with a warming drawer, the rear legs cannot be centered in cabinet opening so that specified in cabinet opening . Front leveling leg
On Ranges Equipped with Warming Drawers:
On ranges equipped with cabinet opening is wider than that the left
edge is against rear wall, molding or cabinet. 3. AB C
If cabinet opening...
Installation Instructions - Page 7
... - A B
C
A. Hex-head screws
7
Use a new 40 amp power supply cord. Electrically ground range. Pull cover down and toward you to follow these instructions can result in death, fire, or electrical shock.... Remove plastic tag holding three 10-32 hex nuts from the middle post of the range. Terminal block cover C. Remove template from your flooring, longer screws may be necessary to ...
Installation Instructions - Page 8
...3-wire receptacle (NEMA type 10-50R)
A UL listed, 250-volt minimum, 40-amp, range power supply cord
3-wire connection: Power supply cord
Style 2: Direct wire strain relief ■... (1996 NEC) ■ Mobile homes ■ Recreational vehicles ■ In an area where local codes prohibit grounding through the
neutral 1.
Part of electrical connection: 4-wire (recommended)
3-wire (if 4-wire...
Installation Instructions - Page 9
...connection: Power Supply Cord
Use this method only if local codes permit connecting chassis ground conductor to the terminal block.
Ground-...
UL listed strain relief D. Line 2 (red)
D
D. Connect line 2 (red) and line 1 (black) wires to the range with 10-32 hex nuts.
7.
Replace terminal block access cover. Tighten strain relief screws.
6. Replace terminal block access cover.
9...
Installation Instructions - Page 10
...1996 NEC) ■ Mobile homes ■ Recreational vehicles ■ In an area where local codes prohibit grounding through bottom of metal ground strap must not contact any other terminal.
10
Complete electrical ... box.
Metal ground strap B. Save the ground-link screw and the end of range.
The ground wire must be attached first and must be connected directly to torque as shown...
Installation Instructions - Page 11
...block. Replace terminal block access cover.
3-wire connection: Direct Wire
Use this method only if local codes permit connecting ground conductor to line 2 (red), bare (green) ground, and line 1 (... on cord/conduit plate on the front of the terminal lug and insert exposed wire end through bottom of range. A B
C
2. Attach terminal lugs to neutral supply wire.
1. Line 2 (red) wire D. ...
Installation Instructions - Page 12
...Use a ¼" drive ratchet, wrench or pliers to back.
3. If range is not level, pull range forward until the range is level. On Ranges Equipped with a warming drawer, the rear leg cannot be level for the ... check that the storage drawer is removed from the anti-tip bracket. NOTE: Range must be seen by pressing the screwdriver handle toward the side of the storage drawer and remove...
Installation Instructions - Page 13
... Use and Care Guide for specific instruction on for 5 minutes, check for heat. If there is cold, turn off the range and contact a qualified technician.
13 For more information, read the "Range Care" section of /recycle all parts are removing and replacing the storage drawer, a slight push may be needed to see...
Installation Instructions - Page 14
... necessary for the anti-tip bracket securely attached to floor. ■ Slide range back so rear range foot is under anti-tip
bracket. Complete cleaning or maintenance. 4. Slide range forward. 3. When moving range, slide range onto cardboard or hardboard to children and adults. Slide range forward. 2. Unplug the power supply cord. 3. Connect anti-tip bracket to...
Owners Manual - Page 1
... 8 General Cleaning 9 Oven Light 10 TROUBLESHOOTING 10 ACCESSORIES 11 WARRANTY 12
W10200356B ®
ELECTRIC RANGE
USER INSTRUCTIONS
THANK YOU for additional information.
Puede encontrar su número de modelo y de .... If you still need your model and serial number located on some models 7 RANGE CARE 8 Self-Cleaning Cycle (on the oven frame behind the storage drawer panel....
Owners Manual - Page 2
...or serious burns to potential hazards that can tip if you and others are not followed.
RANGE SAFETY
Your safety and the safety of others . This symbol alerts you to children and ....
Always read and obey all safety messages.
These words mean:
DANGER
You can happen if the instructions are very important.
However, the range can kill or hurt you apply too much force or ...
Owners Manual - Page 3
.... Surface units may subject wiring or components underneath to damage.
■ Protective Liners - The range is equipped with the utensil, the handle of a utensil should not be referred to a qualified....
■ Proper Installation - among these openings, oven doors, and windows of the range unless specifically recommended in or around any part of oven doors. Remove broiler pan and ...
Owners Manual - Page 12
... purchase, when this major appliance is required to instruct you on the oven frame behind the storage drawer panel. Major appliances with electrical or plumbing codes, or use of consumables or cleaning products not approved by a Whirlpool designated service company. IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE...
Warranty - Page 1
... year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with electrical or plumbing codes, or use of consumables or cleaning products not approved by Whirlpool. 5. ITEMS EXCLUDED FROM WARRANTY This limited warranty does not cover: 1. Service calls to the...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The self-cleaning cycle on my gas range will not operate
...heavy soil are some models) - Electric Oven Control Press PreciseClean button. The clean time can be set at one touch" step... Electric oven control Press Auto Clean. Self-cleaning issues Error code on the range display What are between 3 hours 30 minutes and 4 ...remove ash with a damp cloth. The oven will not work during self-cleaning to help get hot enough during the ... -
What is the Display feature on my gas range, and how do I use it?
..., a power failure has occurred. When performing a timed cook function, the display will appear on the range display Press Off/Cancel to the appliance, a flashing time will show either hours and minutes, or minutes and seconds. Error code on the display. Display When power is not in use, the display shows the time... -
How do I select functions and change displays on my microwave oven?
... functions are on my microwave oven? Error code on or off Clock Scroll speed Change speed (slow, normal or fast) Weight Change to scroll through the functions, then follow directions on the display. Function Option Sound Turn on the range display How does combination cooking work in oven control panel? Repeatedly...
Similar Questions
My Whirlpool Oven Popped While In Use, Then It Stopped Working. Model#rf263lxt
whirlpool RF263LXTT pop noise and stopped working while baking a dish. What are the possible causes?...
whirlpool RF263LXTT pop noise and stopped working while baking a dish. What are the possible causes?...
(Posted by mmshill 6 years ago)
Whirlpool Model Xfc31050ab Shows F9eo Status Stove Top Works...oven Doesn't.
How to remove F9eo status on whirlpool oven. Oven never been used? stove model Xfc31050ab
How to remove F9eo status on whirlpool oven. Oven never been used? stove model Xfc31050ab
(Posted by Katrinabyrd11 9 years ago)
My Whirlpool Xfe381lvs Range Gives Me An Error Code F9e0
the oven take s along time to heat up and the stove top doesnt get real hot
the oven take s along time to heat up and the stove top doesnt get real hot
(Posted by mwbbrown 10 years ago)
F2 Error Code Appears In Gas Range And Make A Continuing Beeping Sound
Is a wire loose or the Electronic over control bad?
Is a wire loose or the Electronic over control bad?
(Posted by gpmiller1210 11 years ago)