Whirlpool EED4100SQ Support Question
Whirlpool EED4100SQ Support Question
Find answers below for this question about Whirlpool EED4100SQ - Estate Extra Large 5.9 Cu. Ft. Capacity Dryer.Need a Whirlpool EED4100SQ manual? We have 2 online manuals for this item!
Question posted by eellisonshonuf on January 3rd, 2015
When I Pushed The Button It Wouldn't Start.
My dryer was working fine. All of a sudden I went to dry clothes and it wouldn't do anything. When I pushed the button it wouldn't start. Their wasn't even a humming noise.
Current Answers
Answer #1: Posted by Odin on January 3rd, 2015 11:18 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool EED4100SQ Manual Pages
User Instructions - Page 1
... messages.
All safety messages will follow instructions. DRYER USER INSTRUCTIONS
Table of Contents
ASSISTANCE OR SERVICE 1 DRYER SAFETY 1 DRYER USE 3 DRYER CARE 5 TROUBLESHOOTING 6 WARRANTY 8
Assistance or Service...our website at 1-800-253-1301 from anywhere in the U.S.A., or write:
Estate Brand Home Appliances Customer Interaction Center 553 Benson Road Benton Harbor, MI 49022...
User Instructions - Page 2
...; Do not try to light any appliance. • Do not touch any other appliance.
- s Do not place items exposed to the drying compartment.
SAVE THESE INSTRUCTIONS
WARNING: For your dryer. Follow the gas supplier's
instructions.
• If you understand and have been previously cleaned in, washed in, soaked in, or spotted with...
User Instructions - Page 3
...bath mat
Delicates
3 camisoles 1 robe 4 slips 8 undergarments 2 sets of sleepwear 1 child's outfit
EXTRA LARGE CAPACITY DRYERS
Heavy Work Clothes
3 pair of pants 4 pair of jeans 2 pair of overalls 3 shirts
Mixed Load
3 double ...loads that extend into the dryer. It must be properly installed and vented to achieve maximum drying efficiency and shorten drying times. Use the straightest path...
User Instructions - Page 4
... sheet) for clothes to remove dust from dryer. On some models, temperature is not in death or fire. The signal will sound only if the selector is helpful when drying items that has ever had any type of oil on the back wall of Cycle Signal as it stops. Press the PUSH TO START button. NOTE...
User Instructions - Page 5
... of clean cloths or towels to do so can increase drying time. The lint screen is located on dryer usage. Roll lint off the screen with a soft cloth until stain is...dry the drum.
Every Load Cleaning
Style 1: 1. Wet lint is removed.
2. Push the lint screen firmly back into place. Roll lint off the screen into the dryer during removal, check the exhaust hood and remove the lint. Push...
User Instructions - Page 6
...
caused by color. Dryer Results
Clothes are gone from dark colors. s Was paper or tissue left open on load or color change
s Was dryer fabric softener properly used for the dryer.
When the odors or fumes are not drying satisfactorily
s Check the following : Were zippers, snaps, and hooks left in ? Was the start button firmly pressed? If...
User Instructions - Page 8
.... Contact your major appliance, to replace or repair
house fuses or to build every new ESTATE® appliance. In the U.S.A., call 1-800-807-6777.
8/05
Replacement Parts
If you... the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will fit right and work right because they are excluded from warranty coverage.
3. Service calls to correct the installation of...
Installation Instructions - Page 1
... existing electrical supply and venting and see "Electrical Requirements" and "Venting Requirements" before starting installation.
WARNING
You can happen if the instructions are very important. s Flat-blade ...For further information, please reference the "Assistance or Service" section of the Dryer User Instructions.
8577187 Always read and obey all parts were included. This symbol ...
Installation Instructions - Page 2
... Kit, Part Number 279810.) Clothes may not operate correctly if dryer is not level. Drying times can result in an area where it will need s A location that allows for a garage installation. Small opening side-swing door D. Wide opening side-swing door B. s Additional spacing should be large enough to allow the dryer door to water and...
Installation Instructions - Page 3
... clothes dryers. Additional Installation Requirements This dryer ...large as the dryer exhaust opening (such as to install with all local codes and ordinances. Mobile Home -
s To be sure that connect to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for mobile home installations. grounding conductor can be at least 4 ft...
Installation Instructions - Page 5
...
A fused disconnect or circuit breaker box*
A UL listed, 120/240-volt minimum, 30-amp, dryer power supply cord*
4-wire connection: Direct Wire
3-wire connection: Power supply cord
3-wire direct
3¹...screw the removable conduit connector onto the strain relief threads. Spade terminals with the dryer cabinet and be in a horizontal position. Reaching inside the strain relief. Strain ...
Installation Instructions - Page 6
...cm) UL listed strain relief
E. Neutral ground wire
3. Connect ground wire (green or bare) of dryer rear panel.
Squeeze hooked ends together.
Secure cover with hold-down screw. 7.
Direct wire cable ... have 5 ft (1.52 m) of NEUTRAL ground wire before being moved to center silver-colored terminal block screw
B.
Dotted line shows position of extra length so dryer can be ...
Installation Instructions - Page 7
... block cover into slot of power supply cord
4. Direct wire cable must have 5 ft (1.52 m) of the other wires to external ground conductor screw. Neutral prong D. Tighten screw.
Neutral ground wire F. Place the hooked ends of extra length so dryer can be moved if needed. Insert tab of terminal block cover into a hook...
Installation Instructions - Page 8
... ground conductor screw
C. Neutral wire (white or center wire) E 1.9 cm) UL listed strain relief
F
3. Tighten screws.
4. Insert tab of terminal block cover into slot of dryer rear panel. External ground conductor screw B. Grounding path determined by a qualified electrician
3. Tighten screw. Center silver-colored terminal block screw
E
D. Center silver-colored terminal block...
Installation Instructions - Page 9
...metal foil vent with rigid or flexible heavy metal vent. Rigid metal vent s For best drying performance, rigid metal vents are acceptable only if accessible for
cleaning.
Fire Hazard Use a ...(10.2 cm) 4" (10.2 cm) A.
Improper venting can be fully extended and supported when the dryer is recommended to prevent crushing and kinking. If using an existing vent system
s Clean lint from the ...
Installation Instructions - Page 10
... needed for purchase. s Bend vent gradually to the manufacturer's instructions. s Use the fewest 90° turns possible. s Reduce performance, resulting in longer drying times and
increased energy usage. Dryer B.
Periscope installation
Determine vent path
s Select the route that will provide the straightest and most direct path outdoors.
s Plan the installation to achieve...
Installation Instructions - Page 11
...
1. Move dryer into hinge holes on top of 90º turns vent or elbows
Box or louvered hoods
Angled hoods
0
Rigid metal
64 ft (20 m) 58 ft (17.7 m)
Flexible metal 36 ft (11 m) 28 ft (8.5 m)
1
Rigid metal
54 ft (16.5 m) 48 ft (14.6 m)
Flexible metal 31 ft (9.4 m) 23 ft (7 m)
2
Rigid metal
44 ft (13.4 m) 38 ft (11.6 m)
Flexible metal 27 ft (8.2 m) 19 ft...
Installation Instructions - Page 12
...dryer.
8. Remove door strike (E) from cabinet side of hinges. 3. Position door so large end of door hinge slot is an extra... are now installed. s Start button has been pushed firmly. If there is ...dryer door so that door strike aligns with a damp cloth to inner door panel so handle is level. Complete Installation
1. Set the dryer on the console and any dust.
10.
If the dryer...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
What is the vent fan on my microwave for and how do I operate it?
... for off. It will remain on until heat is no longer sensed" will start at low speed when any sensor cooking function begins. When this occurs, the vent fan cannot be turned off My microwave oven makes humming noises If the vent fan pad is touched during use and after oven is off... -
My microwave cooking times seem too long
My microwave oven makes humming noises -
What is the vent fan on my microwave for and how do I operate it?
... speed when any sensor cooking function begins. My fan is running slower than usual My microwave oven will start at low speed when any non-sensor cooking function begins or at low speed. It may stay on .... If the vent fan pad is touched during use and after oven is off My microwave oven makes humming noises What is the vent fan on my microwave for and how do I operate it ? What is the...
Similar Questions
My Dryer Whirpool Dryer Turns On But It Won’t Start It Makes A Noise How Do I
how do I reset my whirlpool dryer it turns on but won't start
how do I reset my whirlpool dryer it turns on but won't start
(Posted by Watchmework111 4 years ago)
Heat Comes Out, But Dryer Drum Does Not Come On, And No Motor Noise
could this be the motor, or switch / worked fine two days ago, now today when I turn on the dryer, I...
could this be the motor, or switch / worked fine two days ago, now today when I turn on the dryer, I...
(Posted by shervan 9 years ago)
Drum Motor Not Getting Power
Dryer only 2 years old. worked fine one night, next day, push start and drum will not turn. THERE WA...
Dryer only 2 years old. worked fine one night, next day, push start and drum will not turn. THERE WA...
(Posted by paepaesano 9 years ago)
Whirlpool Dryer
whirlpool dryer model wed5790vq1 dryer works only when start button is pressed in
whirlpool dryer model wed5790vq1 dryer works only when start button is pressed in
(Posted by humza1 11 years ago)
Dryer Won't Start
Dryer worked fine this morning,went to start next load it wouldn't start,checked switch by door and ...
Dryer worked fine this morning,went to start next load it wouldn't start,checked switch by door and ...
(Posted by EGIO623 13 years ago)