Weslo Cadence A 45 Treadmill Support Question
Weslo Cadence A 45 Treadmill Support Question
Find answers below for this question about Weslo Cadence A 45 Treadmill.Need a Weslo Cadence A 45 Treadmill manual? We have 1 online manual for this item!
Question posted by bobdraper88 on May 25th, 2014
No Power To Electric Drive Motor
Where can I get it repaired in Melbourne, Australia
Current Answers
Related Weslo Cadence A 45 Treadmill Manual Pages
English Manual - Page 2
TABLE OF CONTENTS
IMPORTANT PRECAUTIONS 3 BEFORE YOU BEGIN 5 ASSEMBLY 6 OPERATION AND ADJUSTMENT 9 HOW TO FOLD AND MOVE THE TREADMILL 12 MAINTENANCE AND TROUBLESHOOTING 13 CONDITIONING GUIDELINES 15 ORDERING REPLACEMENT PARTS Back Cover Note: A PART IDENTIFICATION CHART, an EXPLODED DRAWING, and a PART LIST are attached ...
English Manual - Page 3
... fuse, an ASTA approved BS1362 type should not be fitted to raise, lower, or move the treadmill.
19. Do not change the incline of high speeds. Do not operate the treadmill if the power cord or plug is damaged, or if the treadmill is capable of the treadmill by persons weighing more than 113 kg (250...
English Manual - Page 4
...been placed on the treadmill.
Inspect and properly ...motor hood unless instructed to do so by an authorized service representative only.
24. WARNING: Before beginning this manual. Always unplug the power...
cord immediately after use of this manual should be performed by an authorized service representative. ICON assumes no responsibility for in this or any exercise...
English Manual - Page 5
... convenience and privacy of this manual carefully before calling.
If you 're not exercising, the unique CADENCE A45 treadmill can be folded up, requiring less than half the floor space of this manual, please see the front cover of other treadmills.
And when you have questions after reading this manual for selecting the WESLO...
English Manual - Page 6
... all packing materials. Attach the Right Handrail to the bottom of the walking belt, simply wipe off the lubricant with high-performance lubricant. Set the treadmill in the position shown. Do not tighten the Handrail Bolts yet.
In addition, do not dispose of the right handrail yet.
Hold the Right Handrail...
English Manual - Page 7
...through the Right Handrail.
The end of the Wire Harness should turn the end of the treadmill.
Tie the wire tie securely to the connector on the left side of the Wire ... a Handrail Star Washer (60). IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
7
6 13
30 10
60 55
Connector 1
22
Plastic
6
Ties
22
Attach the Right ...
English Manual - Page 8
... (87).
Attach the Latch Assembly (41) to the floor. See HOW TO CHANGE THE INCLINE OF THE TREADMILL on the Right Handrail (6) and the Left Handrail (not shown). Note that no wires are pinched.
22... adjust the walking belt (see page 14). To protect the floor or carpet, place a mat under the treadmill.
8
8 12
55
6, 7 64 63
7
87 41 Tighten the three plastic ties around the Wire...
English Manual - Page 9
... whether the product is
properly installed and earthed in accordance with GFCI-equipped
outlets. Important: If the power cord is equipped with a manufacturer-recommended power cord.
1
Socket on the treadmill.
IMPORTANT: Never apply silicone spray or other substances to reduce the risk of electric shock.
OPERATION AND ADJUSTMENT
THE PRE-LUBRICATED WALKING BELT
Your...
English Manual - Page 10
...to move at 1 mph.
Next, locate the on the console, remove the plastic. As you exercise, change the
ETWL1710s5peed of clear plastic
Clip
on /off switch is in the reset position.
2 ... above ) while operating the treadmill. sole, make sure that the on/off switch
Reset
on the foot rails of electric shock, keep the console dry. Make sure
that the
power cord is properly
plugged in ...
English Manual - Page 11
..., and fully reinsert the incline
Incline Leg
pin. The upper half of the treadmill.
To see page 14).
3 Monitor your exercise, you can change the incline of the display is selected, remove the key... foot rails, press the Stop button, and remove the key from the console and unplug the power cord. Adjust the incline leg to
hold down the Stop button for metric kilometers will begin to...
English Manual - Page 12
...knob
2
to the left and hold the treadmill firmly. HOW TO FOLD AND MOVE THE TREADMILL
HOW TO FOLD THE TREADMILL FOR STORAGE
1
Unplug the power cord. Using your back.
To reduce ...must be able to safely lift 20 kg (45 lbs.) to the vertical position. CAUTION: To decrease the possibility of the wheels, and carefully lower the treadmill until it is aligned with your right hand...
English Manual - Page 13
... 49 Make sure that is in the on " position.
Reattach the Hood (not shown), and run , see c. Check the circuit breaker located on the treadmill frame near the power cord.
d On
Position
PROBLEM: The power turns off during use only a 3-conductor, 1 mm2 (14-gauge) cord that the on/off switch located on the...
English Manual - Page 14
...the
walking belt. b 5-7 cm
Rear Roller Bolts
c. Then, plug in the power cord, insert the key, and walk on the treadmill for a few minutes. PROBLEM: The walking belt slows when walked on , ...belt is correctly tightened,
you should be able to 3 in the power cord, insert the key, and carefully walk
on the treadmill for a few minutes. Repeat until
the walking belt is off ...
English Manual - Page 15
... your heart rate is to warm up prepares the body for energy. Aerobic exercise
A Warm-up-Warming up . A Cool-down . After a few minutes of the treadmill until your "training zone." CONDITIONING GUIDELINES
WARNING: Before beginning
this or any exercise program, consult your heart rate as a guide. This increases the demand on the heart...
English Manual - Page 17
...
32
1
33
1
34
1
35
1
36
1
37
1
38
2
39
1
40
2
41
1
42
6
43
1
44
1
45
6
46
1
47
2
48
1
49
1
50
1
51
2
52
10
53
1
Description
Console Round Endcap Key/Clip Console Back Electronics ...Bolt Controller Motor Bolt Left Foot Rail Motor Tension Nut Motor Star Washer Outlet Plate Screw Storage Latch Assembly Base Pad Screw Drive Motor Assembly Power Cord Bracket...
English Manual - Page 18
WETL17105.0
94
52
47 11 93 45 24 86 51 67 75 83
85
64 63
52 37
69
78
76
20 21
52
59 9
58
39
43 38
52
74
79
9
...
77
50 49
27
31
36
52 34
53
26
52
33
68
54
31
93
5
35 92
32
45
82 74
80
45 93
82
5
52
20
91
56
69
77
93 45 85 72
11 47
75
51
75
67 16
85
86
75
57
85 83
64
63
29 28...
English Manual - Page 19
... where you , be prepared to provide the following information: • the MODEL NUMBER of the product (WETL17105.0) • the NAME of the product (WESLO CADENCE A45 treadmill) • the SERIAL NUMBER of the product (see the front cover of this manual) • the KEY NUMBER and DESCRIPTION of this product. To help...
Similar Questions
No Power? Can't Reset Trip Switch? On The Treadmill?
heya my treadmill has no power? It won't start the display won't come on?! Slightly confused I've ch...
heya my treadmill has no power? It won't start the display won't come on?! Slightly confused I've ch...
(Posted by Caryscarter 6 years ago)
Drive Motor Tripping Electrics
weslo cadence c8. Driv motor appears faulty. Everything else works until you select start or speed b...
weslo cadence c8. Driv motor appears faulty. Everything else works until you select start or speed b...
(Posted by mickchristie63 7 years ago)
No Power . Won't Come On. Weslo Cadence G40 Treadmill
(Posted by Farristina 9 years ago)
How To Istall Drive Belt On Weslo Cadence R.5.2. Treadmill
(Posted by Anonymous-142138 9 years ago)