ViewSonic NX2232w Support Question
ViewSonic NX2232w Support Question
Find answers below for this question about ViewSonic NX2232w - DiamaniDuo - 22" LCD TV.Need a ViewSonic NX2232w manual? We have 1 online manual for this item!
Current Answers
Related ViewSonic NX2232w Manual Pages
User Guide - Page 2
...LCD TV to the wall 4 Front View of the Product 6 Rear View of the product 7 Remote Control 8 Installation...10 Basic Operation 14
OSD Functions
Picture Menu...16 Sound Menu...17 Setup Menu...17 Channel Menu 18 PC Menu...19
Other Information
Specifications 21 Troubleshooting 22... Customer Support 24 Declaration of RoHS Compliance 24 Limited Warranty 25
ENGLISH
ViewSonic
NX2232w
User Guide - Page 3
...or moisture, or if the unit does not operate normally or has been dropped.
15. If further cleaning is required, see "Cleaning the LCD TV" in any way, such as radiators, heat registers, stoves, or other . If the plug does not fit into the unit, if ..., and the point where if emerges from tip-over.
13. Unplug this equipment near any ventilation openings.
ENGLISH
ViewSonic
NX2232w
User Guide - Page 4
Product Registration
To meet your future needs, and to change without notice.
The lamp in this product.
For Your Records
Product Name:
NX2232w
ViewSonic LCD TV
Model Number:
VS12198-2G
Document Number: NX2232w-G_UG_ENG Rev. 1A 03-25-08
Serial Number: Purchase Date:
Product disposal at end of product life ViewSonic is concerned about proper...
User Guide - Page 5
... unit
Ground clamps
ENGLISH
Grounding conductors Power service grounding electrode system
Cleaning the LCD TV
• Make sure the LCD TV is grounded so as contact with them might be liable for the grounding... detergent
onto a clean, soft, lint-free cloth, then wipe the surface. ViewSonic
NX2232w If still not clean, apply a small amount of time, unplug it can fall into such...
User Guide - Page 6
... guidelines:
• Read the Important Safety Instructions, at the start of a ViewSonic® LCD TV. ENGLISH
ViewSonic
NX2232w
Remove the 4 screws holding the stand to the wall
The LCD TV can be used in a moist or wet environment. Important! Mounting ViewSonic LCD TV to the hinge. 3. Remove the stand.
This equipment is intended for future shipping needs...
User Guide - Page 7
... allow adequate cooling during operation.
• Hang the LCD TV wall mount plate to support the installation. ENGLISH
ViewSonic
NX2232w • Install the wall mount plate to the LCD TV using screws NO LONGER than 10mm, as longer screws found in universal (non-ViewSonic) wall mount kits may damage the power supply causing the unit...
User Guide - Page 9
...to the VGA output of the Product
ENGLISH
A Power (AC input) Connect to LCD TV and AC outlet with component output to the antenna or cable service. F Composite ...for YPbPr Components (left / right).
ViewSonic
NX2232w
D YPbPr / HD Component Video Input Connect the external video devices with the power cord. G RF Antenna / Cable TV Input Connect to these jacks.
Rear View of...
User Guide - Page 12
... TV system without a cable connecter box (See page 18). Preset the TV channels into memory with 75-ohm coaxial cable. ViewSonic
RF Cable or Adapter (not supplied)
10
NX2232w Inserting...extended period, remove the batteries.
2. Connecting RF antenna or Cable TV Wire
Make sure the power is OFF before installing your LCD TV.
This may result in accordance with local laws and regulations. ...
User Guide - Page 13
3. Connecting to DVD / Set Top Box
Connect Video / Audio cables from compatible devices into the back panel of your LCD TV.
1) With AV cable:
ENGLISH
2) With S-Video cable:
RCA A/V Cable (not supplied)
VCD or DVD Player
3) With YPbPr cable:
S-Video Cable (not supplied) Audio in Cable (...
User Guide - Page 14
...
ViewSonic
VGA 15 Pin Cable
12
NX2232w Also, connect the Audio In cable (green) from VGA output of the computer to the audio input terminal (green) of your LCD TV. Connecting to a computer
1) With ...Connect the VGA cable from the audio output of your computer to the VGA terminal input of the LCD TV.
4) With HDMI cable:
ENGLISH
5) With HDMI-DVI cable:
VCD or DVD Player (DVD Player ...
User Guide - Page 15
AC wall socket
Power Cord
ENGLISH
ViewSonic
13
NX2232w
Connecting with the power cord
Connect the power cord to the AC inlet at the back of your computer to the HDMI terminal input of the LCD TV. PC
Audio in Cable (not supplied)
HDMI-DVI Cable (not supplied)
5.
Also, connect the Audio In cable...
User Guide - Page 16
...the required input source between PC, HDMI,TV,AV, S-Video, and YPbPr. There are several times for Hong Kong area)
ViewSonic
14
NX2232w
Channel Select
Press number keys, CH▲... press 8 only.
Turning on the screen. Volume Adjusting
Press VOL +/- to turn the LCD TV on/off the LCD TV after a few seconds' idleness.
Switch Sound Mode
Repeatedly press MPX button on /off timer...
User Guide - Page 17
ENGLISH
ViewSonic
15
NX2232w
t Press MENU to finish adjustment and press MENU again to cycle through the menus. t Press ◄► ...to enter the menu you select. t Use ▲▼ to appoint your remote
control or menu buttons on the front panel of the LCD TV. Using OSD Menu
You are able to use OSD menus to adjust various settings by using your desired optional item.
The ...
User Guide - Page 18
..., and Cool. • Aspect Ratio: Press ◄► to its proper proportions.
16
NX2232w
anything toward the center of the screen. Panorama : A nonlinear stretch mode for letterbox DVDs to... picture quality
When input source is TV:
When input source is useful for panorama.The conventional 4:3 image will stretch to fill the screen, but the image will still show more wide black ...
User Guide - Page 21
...- To adjust for PC
It is HDMI(PC mode):
• Auto Adjust: To process auto image adjustment by pressing "4" . 4. When input source is PC:
When input source is only active in PC... and HDMI (support PC mode). ENGLISH
ViewSonic
19
NX2232w Move your cursor to channel 1 and press "1" (Select A) to select channel 1. 2.
To exchange one ...
User Guide - Page 23
... Hz) Warning: Do not set the graphics card in permanent damage to exceed these refresh rates; doing so may result in your computer to the LCD TV.
Note: Product Specifications are subject to change without notice. ViewSonic
21
NX2232w
User Guide - Page 24
... the remote control. Strange color, • Ensure that the outlet is supplying the proper voltage.
ViewSonic
22
NX2232w ENGLISH
Troubleshooting
Problem
Possible Solution
No power
• Make sure the power cord is properly connected to the LCD TV AC power socket.
• Make sure the AC power cord is properly connected to the wall...
User Guide - Page 25
...image positioned correctly? • Are screen mode adjustments such as picture size set in advance? • Is there no signal in PC mode or HDMI mode? • The internal temperature of the LCD TV...check all the CATV connections.
• The cable TV service is connected improperly or not connected; ENGLISH
ViewSonic
23
NX2232w Remove any objects
blocking the vent or clean as ...
User Guide - Page 26
...22-900
[email protected]
Declaration of RoHS Compliance
The toxic and hazardous substances or elements of the component.
ViewSonic
24
NX2232w...
×
○
○
○
× ○ External Signal
Cable
○
○
○
○
LCD Panel
××
×
○
○
○
× Remote Control
(battery included)
○
×
○...
User Guide - Page 27
...of damages: ViewSonic's liability is effective: ViewSonic LCD TV are no warranties, express or implied, which results when a static image is mounted on ViewSonic products sold outside the ...Support/Warranty Information.
4.3: ViewSonic LCD TV Warranty
LTV_LW01 Rev. 1C 06-25-07
ViewSonic
25
NX2232w
ENGLISH
Limited Warranty
VIEWSONIC® LCD TV
What the warranty covers:
ViewSonic...
Similar Questions
Je Ne Peux Pas Programmer Mon Tv Avec Un Remote Rca System Link 4
(Posted by bygaelgedeon0 1 year ago)
What Is The Correct Remote Control For A Viewsonic N3235w Lcd Tv
(Posted by Easteddie 10 years ago)
Viewsonic N4280p Lcd Tv Problem With Side Panel Button Control
Cannot adjust volume or channels or input using buttons on side or remote control. Volume is stuck a...
Cannot adjust volume or channels or input using buttons on side or remote control. Volume is stuck a...
(Posted by robinsca 11 years ago)
Tv Always Restarts / No Signal
I recently came into my room to watch some TV I turned it on and it displayed my channel then it wen...
I recently came into my room to watch some TV I turned it on and it displayed my channel then it wen...
(Posted by dchannah 12 years ago)