Troy-Bilt TB525 Support Question
Troy-Bilt TB525 Support Question
Find answers below for this question about Troy-Bilt TB525.Need a Troy-Bilt TB525 manual? We have 2 online manuals for this item!
Question posted by Anonymous-138349 on June 16th, 2014
How Do I Put Trimmer Line On?
How do I wire the trimmer wire on the tb6040 4cycle xp weedeater
Current Answers
Related Troy-Bilt TB525 Manual Pages
Operation Manual - Page 1
Operator's Manual
Electric Start Capable 4-Cycle Gas Trimmer
TB525 EC
TABLE OF CONTENTS Service Information 1 Rules for Safe Operation 2 Know Your Unit 4 Assembly Instructions 4 Oil and Fuel Information 5 Starting and Stopping Instructions 6 Operating Instructions 7 ...
Operation Manual - Page 2
...hard or sharp objects such as a trimmer. Do not smoke.
• Always add fuel in a well-ventilated outdoor area. Do not extend the trimming line beyond the length of fire, electric ... precautions to the operator and/or bystanders. Remove all adjustments or repairs before use metal-reinforced line, wire or rope. Forest Land and in the starting . WARNING: Failure to liability or a fine...
Operation Manual - Page 3
... cutting attachment shield.
You may appear on both hands when operating. These parts get burned. Do not touch or try to do not touch the line cutting blade.
3
When turned off , and disconnect the spark plug for maintenance or repair.
• Use only original equipment manufacturer replacement parts and accessories for...
Operation Manual - Page 4
... unit is secure. (Fig. 2)
(15.24 cm) Minimum
Bolt
Fig. 2
EZ-Link™
Line Cutting Blade Cutting Head Shield
Cutting Head
4
TOOLS REQUIRED: • Phillips Screwdriver • 3/8" Socket...INSTALL CUTTING ATTACHMENT SHIELD
WARNING: To prevent serious personal injury, never operate
the trimmer without the cutting attachment shield in place. INSTALLING THE CUTTING HEAD SHIELD
1. Rotate...
Operation Manual - Page 7
... not force the cutting attachment. For best results, tap the Bump Head™ on installation or removal easier.
90˚ Edging Hole (Trimmer Only)
1. Allow the tip of trimming line is dependent upon proper adherence of the EZ-Link™ coupler (Fig. 11). Cutting shorter lengths produces the best results.
• Trim...
Operation Manual - Page 8
...wire to remove the bump cap if the old line gets jammed or an obstruction preventing the new line from
initial use a flashlight if needed. If you are unsure about these required maintenance procedures at a time.
Continue pushing or pulling the line... operate the unit with 3.04 fluid ounce
(90 ml) of line, cut the line from the eyelet.
4. Keep dirt, grass clippings and other debris...
Operation Manual - Page 9
... of engine power
Have the carburetor adjusted by an authorized service dealer. Disconnect the spark plug wire.
3. socket counterclockwise. Valve Stem Fig. 35
7. The feeler gauge should be performed inside...adjusting nut using a torque wrench torque to Starting and Stopping Instructions.
2. Grasp the plug wire firmly and pull the cap from around the spark plug. If you will not idle, ...
Operation Manual - Page 10
... 14 oz (414 ml) Approximate Weight (without fuel 11.5-13.0 lbs (5.2-5.9 kg) Cutting Mechanism SpeedSpool 2® Line Spool Bump Line Releaser Line Spool Diameter 4 inches (101.6 mm) Trimming Line Diameter 0.095 inches (2.41 mm) Cutting Path Diameter, Trimmer Head 17 inches (43.2 cm)
* All specifications are sold separately. If this time. CUTTING ATTACHMENT WILL NOT...
Parts Diagram - Page 2
... TB525EC
4-CYCLE GAS TRIMMER
PPN 41EDT52C966
Item 1...Ring Crankcase Cover Crankcase Cover O-ring Crankcase Assembly (includes 10) Flywheel Assembly Lead Wires Module Assembly Muffler Gasket Muffler Assembly (includes 15 & 17) Muffler Screw Spark ... Cover Assembly (includes 26) Air Filter Screw Fuel Tank Assembly w/Fuel Lines (includes 29) Fuel Cap Fuel Tank Pads Starter Housing Assembly (includes...
Parts Diagram - Page 3
MODEL TB525EC
4-CYCLE GAS TRIMMER
PPN 41EDT52C966
5
1
4
1 26
3
8
Item
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23
Part No.
753-04234 791-182690 753-...
Similar Questions
Proline Frt Tiller Return Spring Assembly
I have replaced the drive belts on my tiller..........I can't figure out where the return spring on ...
I have replaced the drive belts on my tiller..........I can't figure out where the return spring on ...
(Posted by melnichukjohn 2 years ago)
Diagram For Correct Fuel Line Connections For Tb6044xp Trimmer
(Posted by geistys 2 years ago)
What Type Of Oil Is Required For A Troy Bilt Tb 6042xp String Line Trimmer?
(Posted by Stlouboo 3 years ago)
What Direction Are You Suppose To Wind The Line In The Trimmer
(Posted by smellingood56 9 years ago)
How To Remove Cutting Head
How To Remove Cutting Head From Tb525 Ec Trimmer
How To Remove Cutting Head From Tb525 Ec Trimmer
(Posted by godez 10 years ago)