How Do I Route The Belt On The Tb516ec Edger

1. Ensure the edger is powered off and remove the spark plug wire to prevent accidental starts.

2. Locate the belt cover on the side of the edger. It is usually held in place by a few screws. Use a screwdriver or appropriate tool to remove the screws and take off the belt cover.

3. Examine the condition of the existing belt. If it's worn or damaged, it's advisable to replace it with a new one to avoid future issues.

4. Now, identify the pulleys on the edger. There should be a main drive pulley and an idler pulley. The main drive pulley is typically larger and closer to the engine, while the idler pulley is smaller and is used to apply tension to the belt.

5. Begin by wrapping the new belt around the main drive pulley. Make sure the belt is properly seated and aligned on the pulley.

6. Next, route the belt around the idler pulley. The idler pulley is typically spring-loaded and can be moved to provide tension on the belt. Move the idler pulley using an appropriate tool or by hand to create slack in the belt.

7. Once the belt is routed around both pulleys, release the tension on the idler pulley to allow it to apply tension to the belt. Ensure the belt is properly seated in the grooves of both pulleys.

8. Double-check that the belt is correctly aligned and properly tensioned. It should not be too loose or too tight. Adjust the tension if needed by moving the idler pulley slightly until the correct tension is achieved.

9. Place the belt cover back onto the edger and secure it in place using the screws you removed earlier.

10. Reconnect the spark plug wire and start the edger. Observe the belt during operation to ensure it is running smoothly and not slipping or making any unusual noises.

If you encounter any difficulties or have further questions specific to your Troy-Bilt TB516EC edger model, I recommend consulting the user manual or reaching out to Troy-Bilt customer support for detailed instructions and assistance.