Troy-Bilt TB210 Support Question
Troy-Bilt TB210 Support Question
Find answers below for this question about Troy-Bilt TB210.Need a Troy-Bilt TB210 manual? We have 1 online manual for this item!
Question posted by Anonymous-116914 on July 25th, 2013
Blade Assembly Instructions
I need to know which parts go in in the correct order when changing the blade
Current Answers
Related Troy-Bilt TB210 Manual Pages
Operation Manual - Page 1
Model TB210
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Self Propelled Mower - Printed In USA
TROY-BILT LLC, P.O.
BOX 361131 CLEVELAND, OHIO 44136-0019
Form...
Operation Manual - Page 2
...9674; Visit us directly.
It instructs you have any problems or questions ...NOT return the machine to change product specifications, designs and equipment...Assembly & Set-Up 9 Controls & Features 13 Operation 14 Maintenance & Adjustment 15
Service 17 Troubleshooting 20 Replacement Parts...Thank You
Thank you for purchasing a Lawn Mower manufactured by standing at the operator's ...
Operation Manual - Page 3
... any type of this
and legs and steel-toed shoes are familiar with these instructions may cause discharged material to be used. Wash hands after handling. General Operation
6.
1. by the blade.
Contact with blade can cause serious personal injury. replacement parts.
2. Also, avoid discharging material against a wall or obstruction, which could endanger the personal...
Operation Manual - Page 4
... and understand the instructions and safe operation practices in severe injury. The cutting blade continues to operate this...mower while under 14 years of the mower being pulled over should start to avoid tripping and then follow these steps as part of your footing. Stop the blade...20. Only use the slope gauge included as needed.
15. Slope Operation
Slopes are falling; Watch ...
Operation Manual - Page 5
...replace safety and instruction labels, as on a truck or trailer bed with factory setting of the engine.
11. Improper disposal of parts which could expose moving parts have the ... the engine. Check the blade and engine mounting bolts at least 5 minutes before starting engine.
12. Thoroughly inspect the mower for fuel expansion.
10. Do not change clothes immediately.
2. Environmental ...
Operation Manual - Page 7
... this power machine to assemble and operate. Read, understand, and follow all instructions on slopes. SAVE THESE INSTRUCTIONS! Section 2 - Safety Symbols
This page depicts and describes safety symbols that can be thrown by the blade in any direction. HAND/ FOOT CUT Keep hands and feet away from rotating parts.
WARNING: Your Responsibility-Restrict the use...
Operation Manual - Page 9
... handle up with gasoline and oil as shown in Fig. 3-1.
B
A
Figure 3-2
Figure 3-1
9 While stabilizing mower so it doesn't move, pivot upper handle up as instructed in the engine. Assembly & Set-Up
3
Contents of Carton
• One Lawn Mower
•
• One Lawn Mower Operator's Manual •
One Grass Catcher One Engine Operator's Manual
• One Bottle of...
Operation Manual - Page 10
... steps below to assemble the grass catcher (if needed). Pull upward on... handle, make sure to secure the handle in Fig. 3-5.
Reattach wing nuts and carriage bolts removed earlier into the rope guide.
b.
Place bag over frame so that its black plastic side is turned right side out before assembling (warning label will be on the outside). 2. Hold blade...
Operation Manual - Page 11
... side mulching plug at any time, even when you are not mulching. Release rear discharge door to allow it rests on mulching plug assembly. Slip plastic channel of mower. Place grass catcher into the slots in the handle
brackets as a mulcher.
Section 3 - b. Lower the mulching plug.
On the side of discharge door...
Operation Manual - Page 12
...inset.
3. Secure into position with gasoline as follows:
1.
Assembly & Set-Up Pull the height adjustment lever towards deck....as instructed in one of this manual (Electric Start Units).
12
Section 3 - For rough or uneven lawns, ...change in cutting height.
WARNING: Use extreme care when handling gasoline. Release lever towards wheel (unit will stop scalping of the handle as instructed...
Operation Manual - Page 13
... to be equipped with a water port on the unit. Side Discharge Chute
Your mower is shipped as part of the upper handle.
Stand behind the unit and pull the recoil starter rope...follow the instructions in the "Assembly & Set-Up" section to the "Assembly & Set-Up" Section. Refer to slow down or stop engine and blade. Release it to warning label on its operations. Your mower's deck ...
Operation Manual - Page 14
... to engine manual for the blade to close the rear opening of four inches, mulching is standing near the lawn mower while starting engine or operating mower. See Figure 5-1
2. Repeat until engine cranks. Let the rope rewind each time slowly.
WARNING: The operation of damage. Attach grass catcher following instructions in bag as Mulcher
For...
Operation Manual - Page 15
Lubricate pivot points on the blade and drive controls at the factory and does not require lubrication.
3. These controls must maintain the lawn mower as instructed here.
• Changing of the mower deck after each season.
• Periodically check all fasteners and make sure to remove it rests on the housing. Follow the accompanying engine manual for...
Operation Manual - Page 16
... performance and flooding usually indicates that the air cleaner should be equipped with a water port on its surface as part of your deck, restart the mower. Check engine manual for a detailed list and instructions.
• Maintain oil level as described in engine manual.
• Service air cleaner every 25 hours under extremely dusty...
Operation Manual - Page 17
...an authorized Service Dealer to have your mower, periodically check the blade bolt for correct torque. See Fig. 7-1 inset.
6. lbs.
Grind each cutting edge equally to change the mower's belt. Slide the blade adapter onto the engine crankshaft. Align notches on the blade. lbs. See Fig. 7-1.
17
Blade Adapter
Blade
4. Remove metal from the adapter for sharpening...
Operation Manual - Page 18
...7-4.
2 1
Figure 7-2
3. See Fig. 7-3. The battery should only need to remove.
Unhinge the cover seal and plug the battery charger into the... action every time you frequently stop and restart the mower during charging or discharging. NOTE: The special designed ... plug into 120 volt standard household outlet. Follow this order of ignition. Use in any reason other extended periods...
Operation Manual - Page 19
...parts of a discharged battery will not operate. If the fuse burns out, the electric starter will reduce life and capacity of power equipment in a poorly
ventilated or metal storage shed, care should be taken to prepare your lawn
mower... the lubrication instructions.
• Coat mower's cutting blade with standard ... of your lawn mower for correct engine storage instructions.
•...
Operation Manual - Page 20
... gasoline. 4. Refer to .030" or replace spark plug.
2. Balance blade.
2. Fuel valve (if equipped) closed. 9. Engage blade control. 2. Open fuel valve. fill tank with choke). 10. Clean ...
1. Prime engine as instructed in gas cap plugged. 4. Mow once at a high cutting height, then mow again at high speed Idles poorly Excessive Vibration Mower will not mulch grass...
Operation Manual - Page 21
... boot, and clean out debris.
3. Inspect and replace belt. Wheels not positioned correctly. 2. Belt not installed properly. 2. Debris clogging drive operation. 3.
Section 8 - Place front and rear wheels in same height position.
2. Damaged or worn belt. Check belt for proper pulley installation and movement.
2. Problem
Uneven cut
Mower will not self propel
Cause
1.
Operation Manual - Page 24
...set forth below ) against defects in Canada and/ or its Normal Wear Parts and Attachments as : batteries, belts, blades, blade adapters, tines, grass bags, wheels, rider deck wheels, seats, snow ...does not extend any part found to be liable for incidental or consequential loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for ...
Similar Questions
Is Plain Unleaded Gasoline The Correct Fuel For My New Tb 210?
(Posted by rebeccabmccune 11 months ago)
Troybilt Tb210 Fuel Filter Location?
Does the Troybilt self-propelled TB210 walk behind lawnmower have a fuel filter and is so where does...
Does the Troybilt self-propelled TB210 walk behind lawnmower have a fuel filter and is so where does...
(Posted by mistyfss 11 months ago)
Need New Motor Engine For Troy Bitl Riding Lawn Mower 15.5
(Posted by janicesutton60 2 years ago)
Lawn Mower
What kind of oil do I use in my troy bilt 140cc 110b push behind mower is it ok to use 10w30
What kind of oil do I use in my troy bilt 140cc 110b push behind mower is it ok to use 10w30
(Posted by sgilbert491974 9 years ago)
2013 Troy-bilt-tb210, Sitting For 5 Months, Clean Fuel And New Oil. How Can A Pr
engine will not start. been sitting for 5 mths. Put clean fuel in and ck oil. How can i prime or cho...
engine will not start. been sitting for 5 mths. Put clean fuel in and ck oil. How can i prime or cho...
(Posted by no1dallasfan 10 years ago)