Troy-Bilt TB146 Support Question
Troy-Bilt TB146 Support Question
Find answers below for this question about Troy-Bilt TB146.Need a Troy-Bilt TB146 manual? We have 1 online manual for this item!
Question posted by cameronbrown5076 on June 18th, 2014
My Tb146 Times Won't Spin
I have a relatively new tb146, it might be 2 years old. I went to plow my garden this year and the times will not spin. What's the problem?
Current Answers
Related Troy-Bilt TB146 Manual Pages
Operation Manual - Page 1
...and troubleshooting information.
Call 1-800-828-5500
Español - CALL 1-800-828-5500 IN U.S. TB146 EC
4-Cycle
Electric Start Capable
Cultivator
Operator's Manual
English - Starting the Unit
Primer Bulb
6
Set... ENGINE IS HOT
Go back to use than 30 days old).
8
DO NOT Squeeze the throttle control.
10 X 19
Press primer bulb 10 times, or until unit starts.
This unit has an alternate ...
Operation Manual - Page 2
...can explode if ignited.
SPARK ARRESTOR NOTE NOTE: For users on our website at the time of printing. Check with a spark arrestor, maintained in effective working order, or the ...following precautions:
• Store fuel only in containers specifically designed and approved for a short time.
• GARDEN CULTIVATORS - SAFETY
• Never start or run the engine at high
speed when you ...
Operation Manual - Page 3
...Cultivating sod and light to medium soil • Cultivating in garden areas, around trees, etc. • Edging
NO ASSEMBLY... using a blended fuel: • Always use clean oil of old fuel according to secure the handlebars in a clean, well ventilated...the fuel tank and fill the tank. Reinstall the top of performance problems. Use only fresh, clean unleaded gasoline. Funnel Spout
Oil Fill ...
Operation Manual - Page 4
...speed. 4. With the engine running .
2. ADJUSTING THE TINE DEPTH
The tines should penetrate most garden soils approximately 5 to idle. 2. Release the throttle control and allow it along on wheel when...control for proper use of the unit.
Slowly press and release the primer bulb 10 times (Fig. 7).
Raise the wheel height for shallower tine penetration or lower the wheel ...
Operation Manual - Page 5
... the unit. Clevis Pin
6. The importance of the old oil according to prevent debris from the rocker arm cover...These procedures should solve most engine problems. If not, and any oil that may be replaced at a time (as necessary.
10. NOTE... clearance.
Secure the new tines to dry.
4. Look into the oil fill hole;
It may spin during idle speed adjustments...
Operation Manual - Page 6
...)
9.
Do not over 30 days) The spark plug is old (over tighten. 8. Reattach the spark plug boot.
0.025 in the engine
could damage the cylinder.
5. Reinstall the engine cover. Check the alignment of any time without notice. Tighten the screws. Fig. 23
TROUBLESHOOTING
PROBLEM THE ENGINE WILL NOT START, IDLE OR ACCELERATE
SOLUTION...
Similar Questions
What Would Cause My Pull Cord To Not Catch Anything?
(Posted by adamhawkins265 1 year ago)
Gear Box
does the gear box require gear lube maintenance/replace TB146 EC if so 80-90W? where do i fill?
does the gear box require gear lube maintenance/replace TB146 EC if so 80-90W? where do i fill?
(Posted by thenut72 6 years ago)
Unable To Start Tb146 D.c. Tiller
tries new gas, cleaned filter & plug. Still cannot get tiller to start
tries new gas, cleaned filter & plug. Still cannot get tiller to start
(Posted by Bigdanno9 6 years ago)
It Runs Great But When I Pull The Trigger, The Head Won't Spin.
The head quit spinning, the engine starts and runs great but when I pull the trigger , the head won'...
The head quit spinning, the engine starts and runs great but when I pull the trigger , the head won'...
(Posted by Rjkaplan7 8 years ago)
Should The Times Turn Freely When It's Not Running?
(Posted by Samiam6940437 10 years ago)