Toro 38025 Support Question
Toro 38025 Support Question
Find answers below for this question about Toro 38025 - 18" Power Curve Electric Snow Thrower.Need a Toro 38025 manual? We have 2 online manuals for this item!
Question posted by yebos on February 27th, 2016
Small Belt On 1800 Power Curve Snowthrower Model 38025 Keeps Shredding
The small belt on the small pulley on my Toro 1800 Power curve snowthrower model 38025 shreds after a few passes of less than 50 feet on a small deck with only a couple inches of snow. What could cause a brand new belt to shred with practically no use and no heavy load?
Current Answers
Answer #1: Posted by freginold on February 28th, 2016 5:52 AM
freginold
Member since:
December 20th, 2011 Points: 23,253,885
Member since:
December 20th, 2011 Points: 23,253,885
Hello, there are many things that could be causing the belt to shred. One possibility is something not aligned correctly, causing the belt to not sit the way the it's supposed to. You can find several possible solutions in this forum thread.
Related Toro 38025 Manual Pages
Operation Manual - Page 1
... other reproductive harm.
It is not designed for cutting brush or for cutting grass on well-maintained lawns on the product. Introduction
Model No. It is not equipped with Canadian ICES-002.
© 2011-The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420
Register at www.shoptoro.com. Figure 1 identifies the...
Operation Manual - Page 2
...starting .
• Do not put hands or feet near drop-offs, ditches, or embankments. Improperly ...lose your footing; You could be sure of lawn mower will be ordered through the engine manufacturer...horsepower, the gross horsepower of production.
Keep clear of the discharge opening at the...use accessories approved by the blade. For models with the following instructions have been adapted...
Operation Manual - Page 3
...there is extremely flammable and the vapors are sharp. Check their proper operation regularly.
• Keep machine free of grass, leaves, or other sources of a child. Clean up .
Allow ...be sure the equipment is complete. Repair, if necessary, before filling.
• Remove gas-powered equipment from your view of ignition.
• Use only an approved gasoline container.
• ...
Operation Manual - Page 4
... blade-remove the ignition key and read the instructions before leaving the operating position; stop the engine before servicing or performing maintenance.
4. Thrown object hazard-keep bystanders a safe distance from the original machine manufacturer.
94-8072
104-7953
1. Unlock
114-7982
1. Warning-read the Operator's Manual.
2. Replace damaged decals. Manufacturer's Mark...
Operation Manual - Page 5
... of oil into the oil fill tube, then remove the dipstick.
5.
Note: When the crankcase is below the Add mark on the dipstick, slowly pour a small amount of oil in the crankcase, then do the following: 1. Read the oil level on the dipstick (Figure 4).
5
Move the mower to the operating position...
Operation Manual - Page 6
...: Change the engine oil after the first 5 operating hours; Product Overview
3
Charging the Battery
No Parts Required
Procedure
Electric-start 10. Blade control bar
9. Handle knob (2)
6. Spark plug
Figure 6
1. Ignition key (electric-start models only Refer to Changing the Engine Oil. Grass bag 2. Important: Do not overfill the crankcase with oil and run...
Operation Manual - Page 7
... the dipstick into the oil fill tube securely. Operation
Filling the Fuel Tank
DANGER
Gasoline is below the Add mark on the dipstick, slowly pour a small amount of oil into the oil fill tube, then remove the dipstick.
5. A fire or explosion from gasoline can burn you and others.
• To prevent...
Operation Manual - Page 8
Keep away from the hot muffler.
Note: When you pull the recoil start handle...
Note: The cutting height settings are 1 inch (25 mm); 1-3/8 inches (35 mm); 1-3/4 inches (44 mm); 2-1/8 inches (54 mm); 2-1/2 inches (64 mm); 2-7/8 inches (73 mm); 3-1/4 inches (83 mm); 3-5/8 inches (92 mm);
Turn the ignition key (Figure 11) (electric-start models only) or pull the recoil start handle,...
Operation Manual - Page 9
... and the mower will automatically keep pace with your hands on...: When you leave the mower (electric-start after self-propelling, stop before... is damaged, install a new Toro replacement bag. Stop the engine and...from the lawn. You can result in place, and allow small stones ...couple of inches (centimeters) forward to roll a couple of inches (centimeters). Raise and hold your ...
Operation Manual - Page 10
.... lever forward until the button on the lever pops up (Figure 15)
Figure 15 1. Grass bag pin (2)
2. Also, an open rear discharge area could allow small stones and other similar debris to be thrown in the operator's or bystander's direction and result in serious personal injury.
Important: For proper operation, remove...
Operation Manual - Page 12
... follow all local fire warnings, and keep the mower free of cutting a full swath with each pass.
- Cut the grass more of ...lawn, ensure that half of sticks, stones, wire, branches, and other debris that the blade could hit.
• Avoid striking solid objects with a Toro...frequently.
12 Raise the cutting height on the lawn, set the front wheels at 2-1/8-inch (54 mm) and the rear wheels at ...
Operation Manual - Page 13
...to your engine operator's manual for 24 hours (electric-start models only).
• Empty the fuel tank before ... the machine from an Authorized Service Dealer (go to www.toro.com to find the nearest dealer) or at www.shoptoro.com. WARNING...control bar. • Clean grass clippings and dirt from the spark plug (Figure 18) before annual storage.
• Change the engine oil. • Replace the ...
Operation Manual - Page 14
... surface. 2. Remove the dipstick (Figure 20). Wipe the dipstick clean with oil and run the engine. Read the oil level on the dipstick, slowly pour a small amount of oil into the oil fill tube and repeat steps 8 through the oil fill tube (Figure 21). Install the dipstick into the oil fill...
Operation Manual - Page 15
... charging the
battery.
2. Rear deflector 2. Charging the Battery
Service Interval: Every 25 hours
Electric-start models only
If the battery does not charge or the engine does not run with a 40...is nearly fully charged. Connect the charger to local codes. Replacing the Fuse
Electric-start models only
WARNING
CALIFORNIA Proposition 65 Warning Battery posts, terminals, and related accessories ...
Operation Manual - Page 16
... the mower onto its side with the screw that you run out of the blade to 60 ft-lb (82 N-m). Figure 26
Important: Position the curved ends of gasoline. Install the battery compartment with the air filter up. 3. Remove the blade, saving all mounting hardware (Figure 26). If the blade edge...
Operation Manual - Page 18
..., contact an Authorized
Service Dealer. 1. Start the engine again.
5. Remove the ignition key (electric-start models only).
2.
Do not store fuel without stabilizer more than 30 days, and do not store ... in an enclosure near an open flame.
• Allow the engine to the spark plug.
18 To unfold the handle, reverse the steps above. If you can move the
upper handle freely...
Operation Manual - Page 20
...your sole remedy under warranty.
3.
The Toro GTS (Guaranteed to the failure of repairs under "Lawn Mowers") or access our web site at Toro Warranty Company.
*Residential purposes means use...Limited Warranty for Commercial Use*
Gas-powered Toro Products used commercially*. Bring the product and your Distributor's service or have purchased Toro products exported from the United States ...
Parts Catalog - Page 1
Original Instructions (EN)
Form No. 3362-566 Rev A
1800 Power Curve® Snowthrower
Model No. 38025-Serial No. 310000001 and Up
Parts Catalog
Register at www.Toro.com.
Parts Catalog - Page 2
...head PPHTF: phillips pan head thread forming PRH: phillips round head PTH: phillips truss head
PTO: power-take-off RH: right hand ROPS: roll-over protection system SFH: slotted fillister head SHH: ...head STD: standard TAP: self tapping TTH: torx truss head
© 2009-The Toro® Company
Contact us at www.Toro.com.
8111 Lyndale Avenue South Bloomington, MN 55420
2
Printed in the USA. The...
Parts Catalog - Page 4
...-Lower Handle
15 73-3630
1 Wire Harness
17 73-1800
1 Filter-Foam
18 32144-88
4 Screw-Pan Head
19 73-0120
1 ...Strap-Motor
20 73-3520
1 Motor
21 73-8680
1 Motor Plate ASM
23 32144-100
2 Screw-Hex Washer Hd.
24 73-3660
1 Pulley-Driver
25 73-0160
1 Belt-Timing
26 73-3580
1 Washer
27
2 Bearing-Needle ●
28 73-3570
1 Idler Pulley...
Similar Questions
I Need An On -off Power Switch For The Toro Model # 51599
(Posted by olinm 10 years ago)
Motor Brushes-toro Power Shovel Plus Model 38361
where do i find replacement brushes for the motor of my Toro Power Shovel Plus? thanks.
where do i find replacement brushes for the motor of my Toro Power Shovel Plus? thanks.
(Posted by morell 11 years ago)
15 Amp Circuit Breaker Blowing
I have one of the early Power Curve 1800’s. It has run flawlessly until this week. Yesterday, ...
I have one of the early Power Curve 1800’s. It has run flawlessly until this week. Yesterday, ...
(Posted by edabar 13 years ago)
Circuit Breaker Blowing (15 Amp)
I have one of the first Power Curve 1800's. This year, for the first time, after 30-60 minutes of us...
I have one of the first Power Curve 1800's. This year, for the first time, after 30-60 minutes of us...
(Posted by edabar 13 years ago)
