Toro 20351 Support Question
Toro 20351 Support Question
Find answers below for this question about Toro 20351 - High Wheel CARB Walk Power Mower.Need a Toro 20351 manual? We have 3 online manuals for this item!
Question posted by julie83815 on August 7th, 2012
I Need Instructions On How To Replace The Brake Cable On My Toro Model 20023.
The brake/throttle cable has broken and I have gone to a dealer to get new part. However, the existing cable looks like it was installed improperly. I would like a diagram to show exactly how I should install the new part.
Current Answers
Related Toro 20351 Manual Pages
Operation Manual - Page 1
.... 22in Recycler® Lawn Mower
Model No. 20332-Serial No. 312000001 and Up Model No. 20334-Serial No. 312000001 and Up Model No. 20352-Serial No. 312000001 and Up
Form No. 3371-667 Rev A
Operator's Manual
Replacement parts are responsible for product and accessory information, help finding a dealer, or to highlight information.
Introduction
Model No.
You are available...
Operation Manual - Page 2
... death. Always look down .
Exercise extreme caution when changing direction on slopes.
• Watch for proper operation and installation of accessories. ...walk-behind rotary lawn mowers and the B71.1 specifications of the American National Standards Institute in effect at all safety messages that follow all slopes require extra caution. The following safety instructions. Improperly...
Operation Manual - Page 9
...install a new Toro replacement bag.
Using the Self-propel Drive
To operate the self-propel drive, simply walk with your hands on the upper handle and your elbows at your sides, and the mower... Service Dealer.
Installing the Grass Bag
1. Figure 12
Stopping the Engine
To stop walking, hold up the rear deflector (Figure 14).
9
Note: If the mower does not start models only)....
Operation Manual - Page 12
... objects with a Toro replacement blade. Mow only in dry conditions.
• Be aware of a potential fire hazard in very dry conditions, follow all local fire warnings, and keep the mower free of the lawn shows through the cut the leaves finely enough. Walk at a lower setting for damage.
• For best performance, install a new blade before the...
Operation Manual - Page 16
... 3. 6. Install the new blade and all mounting hardware (Figure 25).
5. While holding the blade with the air filter up. 3. Examine the blade whenever you removed in the battery compartment. 5. Wear gloves when servicing the blade.
1. 1 2 3
1. Tip the mower onto its side with a block of gasoline. Replacing the Blade
Service Interval: Yearly
Important: You will need...
Operation Manual - Page 20
... the 24-hour Toro Dealer locator system.
2. The Toro Total Coverage Guarantee
A 2-Year Full Warranty (45 Day Limited Warranty for Commercial Use)
The Toro GTS Starting Guarantee
A 3-Year Full Warranty (Not Applicable for Commercial Use)
22 in Recycler® 20 in Mulcher/Bagger
Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate, Toro Warranty Company...
Quality Guide - Page 3
... Operator Instruction 2-2
Mower Preparation 2-2 Lawn Preparation 2-2 Safety 2-2 Mowing Tips 2-3
Inspecting and Sharpening the Blade Overview 3-1 Removing the Blade 3-1 Inspecting the Blade 3-2 Sharpening the Blade 3-2 Balancing the Blade 3-2 Installing the Blade 3-3
Checking and Adjusting the Blade Level Overview 4-1 Walk Behind Mower Overview 4-1 Riding Mower Overview 4-2 Checking...
Quality Guide - Page 9
... controls (gear shift, throttle, choke, engine or blade-stop, etc.) to convince a customer that all grease fittings are greased.
4.
When a customer begins to -rear.
Inspect for damage, scratches, dents, and for demonstration of Cut
2 - 1 Make sure the wheels roll true and the control cables are found that an improperly set up mower can be right...
Quality Guide - Page 10
... of cut .
Remind the operator that the instructions for either of these procedures are in the operator's manual.
• Demonstrate for mixing fuel and oil properly. When followed, this is factory-installed, check the blade pitch and deck level. Remind the operator that tipping a walk behind mower the wrong way to check the blade...
Quality Guide - Page 13
... install a new blade before the cutting season begins. Disconnect the wire from the engine. Riding mowers: Remove the mower ... to mower. Blade bolt 2. The blade fasteners differ from mower to stop.
2. Bolt size varies by mower model and ...walk behind mowers: Drain the fuel and oil from the spark plug.
3. Grasp the end of blade.
Blade driver
remove2.TIF
Service Dealer...
Quality Guide - Page 15
... replaced every third time it for proper blade bolt/nut torque. Inspecting and Sharpening the Blade
Installing the Blade
1. Some common Toro, Toro Wheel Horse, and Lawn-Boy torque values are shown in 2002
Model
Lawn-Boy 21-inch walk behind
mowers
Toro 21-inch and 22-inch walk behind mowers with split
washer on blade bolt
Toro 21-inch and 22-inch walk
behind mowers...
Quality Guide - Page 17
...-rear pitch depends on the height of cut system on the mower. Cast deck models (Toro Super Recycler and Lawn-Boy Gold Series) use notches cast into the mower housing (Figure 10) and spring arms and pins to engage those notches.
If you have a walk behind mower, see the subsection that discusses the height of cut , side...
Quality Guide - Page 20
...difference between the
Adjusting Blade Level
Walk Behind Mowers
Specifications and Tolerances
On walk behind mowers the blade should stay close ...mower, see the subsection in these instructions that was on the floor and the tape against the cutting edge of the blade are working . The mower is acceptable.
4 - 4
Service Dealer's Guide to the mark you made in everything including wheels...
Quality Guide - Page 21
... (Figure 19).
However, there are the same for all walk behind mowers, the type of suspension or height of cut on a given mower determine the procedures to determine the height of Cut Lever on Each Wheel
Mechanism Descriptions
Toro and Lawn-Boy have similar systems for individual wheel adjusters.
Models with a pin to engage a notch is molded in...
Quality Guide - Page 22
...less above the ground, you reinstall the wheel, use the extra clearance to raise it is best to replace the mower housing.
4 - 6
Figure 23
MVC-718X.JPG
Service Dealer's Guide to be shimmed. For instance, ...Side-to be shimmed. Slip a washer or other front wheel. If the blade is within 1/8 inch (3.1mm) side to side, the engine will need to -Side Level
If the blade is rarely necessary....
Quality Guide - Page 41
...replaced with a tachometer. Note: A new lawn can exhibit several factors working together. Keep the engine at least one mowing.
2. Move over previously-cut problem, look for the problem and its possible solution(s) in other types of mowers...Service Dealer's Guide to bagging for the model.
If...grass build-up .
3. Sharpen as instructed in the Appendices. Check for example, or...
Quality Guide - Page 42
... to cut cleanly, leaving a poor looking lawn. Stair Step or Sawtooth Cut
Check mower for the correct blade-a bagging blade used on some bagging mowers. Check the blade pitch. Check the blade pitch. Sometimes approaching a high spot from a different angle resolves the problem.
8. Troubleshooting Quality of cut to avoid high spots.
2. Install a higher lift blade if available...
Quality Guide - Page 43
Troubleshooting Quality of the mower will be grass that the tires or gage wheels did not hit. The grass may be level. The rear tires and rollers or gage wheels on the rear of Cut
7. Some models have different blades for this, brush the grass with your hand to see if it .
8. Replace worn blades.
10...
Quality Guide - Page 45
...factory installed....Power, Landscaper, or commercial walk behind mowers. This prevents grass buildup under the deck while adding an additional deflector. Many models currently have this happens, the hard material must be used to the deck. Service Dealer's Guide to avoid replacing the deck. Toro Recycler Mulch Plug
Model 59134 fits Toro 21-inch Recycler Steel Decks Model 59135 fits Toro...
Quality Guide - Page 55
...on all tires? (Riders usually 12 PSI.) F. Unusual terrain causing a problem? Yes No
7. On walk behind or riding mower model/VIN
S/N
Mower attachment model/VIN
S/N
Bagger model/VIN
S/N
Clipping disposal: Side discharged
Mulched
Bagged
1. Results: Complaint: Streaking Clumping
2. B. Mower level front to specification? Cutting height of problem:
Ragged cut is wet or extremely lush...
Similar Questions
Lawn Mower Wont Start After Three Cuts
(Posted by luvde 9 years ago)
How To Replace Brake-cable(115-8439) On Toro Lawn Mower
(Posted by liddltw 9 years ago)
Lawn Mower Does Not Work
(Posted by thdraco0 9 years ago)
How To Replace Brake Cable Part No 115-8439 Toro Lawn Mowers
(Posted by LAKSHcec 10 years ago)
How Do I Replace The Grass Bad On A Toro 20023 Recyclerpower Mower?
(Posted by tadillon 11 years ago)