Toro 20351 Support Question
Toro 20351 Support Question
Find answers below for this question about Toro 20351 - High Wheel CARB Walk Power Mower.Need a Toro 20351 manual? We have 3 online manuals for this item!
Question posted by deputyh2ocomm on September 26th, 2011
Lawnmower Is 4 Months Old And Will Not Start After It Has Run For A Few Minutes
The person who posted this question about this Toro product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by kcmjr on September 26th, 2011 12:00 PM
kcmjr
Member since:
May 5th, 2011 Points: 4,254,255
Member since:
May 5th, 2011 Points: 4,254,255
Can I assume the warranty has expired? If not take it back.
Sounds like a clogged fuel line. Have you made sure to keep debris out of the gas tank? Therfe should be a filter in the tank to stop grit from getting in. It may need to be cleaned.
Check the spark plug and make sure it isn't fouled, and make sure the air filter isn't clogged
Beyond that you'll probably need to crack open the carburator to clean it out. It might be a good idea to have a repair shop check it over to be sure nothing major is wrong.
Licenses & Certifications: Microsoft, Cisco, VMware, Novell, FCC RF & Amateur Radio licensed.
Related Toro 20351 Manual Pages
Operation Manual - Page 2
... or exceeds the CPSC blade safety requirements for walk-behind rotary lawn mowers and the B71.1 specifications of the American National Standards Institute in...you start to vibrate abnormally, stop before starting the engine.
• If the machine should start the engine. Material may be sure of objects such as rocks, wire, toys, etc., which can result in injury or death. never run.
&#...
Operation Manual - Page 3
...filling.
• Remove gas-powered equipment from a gasoline dispenser...unintended starting .
• Never make any fuel-soaked debris. Clean up . Allow machine to the machine and the mowing activity. Do not run the... engine indoors or in safe working condition.
• Never tamper with manufacturer's recommended parts, when necessary.
• Mower blades are explosive...
Operation Manual - Page 5
...of the handle knobs as you
removed in step 1 .
1. Move the mower to the operating position. 3. Remove the handle knobs from the mower housing (Figure 3).
fill: 20 oz. (0.59 l), type: SAE 30 ...oil fill tube, wait 3 minutes, and repeat steps 3 through 5 until the oil level is empty, pour about 3/4 of the crankcase capacity of oil. Figure 3
2. Before starting the engine, fill the engine ...
Operation Manual - Page 6
...
models only)
4. Bag-on the dipstick reads Full.
6. Handle knob (2)
6. Recoil start models only)
6 Battery charger (electric-start handle
7. Figure 5
1. Ignition key (electric-start models only Refer to Changing the Engine Oil. Oil fill/dipstick
12. Important: Change the...(not shown) 13. Important: Do not overfill the crankcase with oil and run the engine. Grass bag 2.
Operation Manual - Page 7
... of 87 or higher) from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in an approved fuel container, out of the reach of oil into the oil fill tube, wait 3 minutes, and repeat steps 3 through 5 until the oil level on the dipstick.
Wipe the...
Operation Manual - Page 8
Starting the Engine
1. Adjust the cutting height as the rear wheels (Figure 9).
CAUTION
If the engine has been running, the muffler will be hot and can severely...Cutting Height
WARNING
Adjusting the cutting height may bring you . Set the front wheels to the handle slowly.
1.
To lower the mower, move the front cutting height levers rearward and the rear cutting height levers ...
Operation Manual - Page 9
... the recycling position (refer to disengage the wheel drive.
Installing the Grass Bag
1. If ...the self-propel drive, simply walk with your hands on the mower, remove it to the ...mower does not start models only). Recycling the Clippings
Your mower comes from the lawn. Figure 13
WARNING
A worn grass bag could allow the mower to roll a couple of inches (centimeters). Note: If the mower...
Operation Manual - Page 13
...it more frequently in dusty operating conditions. • Charge the battery for 24 hours (electric-start models only).
• Empty the fuel tank before repairs as directed and before performing any ...Before each use a hand fuel pump to remove the fuel.
tip the mower prior to running out of the machine from the normal operating position. After performing the maintenance procedure(s), connect...
Operation Manual - Page 14
Tip the mower onto its side with the air filter up to warm it. Figure 19
Changing the Engine Oil
Service Interval: After the first 5 hours Yearly
Run the engine a few minutes before changing the oil to drain the used oil properly at the Full mark on the dipstick, slowly pour a small amount of...
Operation Manual - Page 15
... of the lead-acid battery according to the mower wire harness
located below the ignition key (Figure... This state lasts only a few minutes until the battery is charging the
battery.
2. ...hours
Electric-start models only
If the battery does not charge or the engine does not run with ... the battery for 24 hours initially, then monthly (every 25 starts) or as needed. Raise the rear deflector...
Operation Manual - Page 17
... garden hose from under the mower housing.
7. Start the engine and run it from the housing to its lowest cutting height setting. Pull down the cable jacket (toward the mower) until there are no slack...27). 2. Tighten the nut on the mower housing (Figure 28). Lower the mower to the grass bag. Figure 27 This figure is simplified for a few minutes to dry the housing to prevent it until...
Operation Manual - Page 18
... fuel as you must charge the battery every 90 days (electric-start the engine, it .
1.
Disconnect the wire from Storage
1. WARNING
Folding or unfolding the handle improperly can move the
upper handle freely. 3. On the last refueling of fuel.
4. Run the mower until it in the fuel tank is the leading cause of...
Operation Manual - Page 20
... not cover the following the maintenance procedures described in Mulcher/Bagger
Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate, Toro...Start) Engine Battery
Warranty Period 2 -
To locate a dealer convenient to you, refer to you may not apply to the Yellow Pages of repairs under "Lawn Mowers") or access our web site at more than one
month old...
Quality Guide - Page 10
... for either of these procedures are safe, the mower operates properly, and the lawn is starting to bog down.
• Show the operator ...lawn preparation.
Refer the operator to the operator that tipping a walk behind mower the wrong way to check the blade could be removed without also removing the paint. Explain that the operator's manual contains safety information about the mower, lawn...
Quality Guide - Page 13
... the proper size wrench to avoid future starting problems.
1. Always use a bolt and a lock washer; An adjustable wrench can easily open and slip.
5. Curved washer
Figure 3
remove1.TIF
3. Spindle shaft
1. Lock washer 3.
A dull blade tears and shreds grass, producing a poor quality of Cut
3 - 1 Walk behind mowers, while the blade is a key factor in...
Quality Guide - Page 42
... have been sharpened numerous times, making the turn to remedy this .
4. Adjust gage wheels on straight runs.
7. Change cutting pattern. Sometimes approaching a high spot from the lawn or improve the grass stand in direct relation to side.
4. If the mower attachment scalps only on the inside of grass can cause the side of this manual...
Quality Guide - Page 45
... hook up a garden hose and clean the cutting chamber after mowing, the accumulated grass can run into the cutting chamber and not hit a kicker or other object. Many models currently have ...the blade while the water is running.
However, it is not cleaned after each use. Note: These kits do not fit Vacu-Power, Landscaper, or commercial walk behind mowers. Kits to Improve Quality of ...
Quality Guide - Page 47
...scalping when a mower encounters a high spot or crest in the lawn. Glossary
These terms apply to the blade on a bagging mower.
Accelerator-a fan...mower blade. Appendices
This section includes three subsections:
• Glossary-a list of terms used in this manual
• Quality of Cut Checklist-a form to copy and use when troubleshooting quality of cut problems
Anti-scalp wheel-a wheel...
Quality Guide - Page 49
...mowers that are actually semi-floating. Engine RPM (revolutions per minute)-a measurement of clippings dropped by a mower, usually when a mower is used in conjunction with density, as in contact with a high water content. The gage wheel... small pieces and deposit it back into the lawn.
Mulching-using the mower to the cutting edge of gage wheels.
halo.TIF
Height of cut (HOC)-the ...
Quality Guide - Page 55
... adjustable pitch, raise the front to side with each other? On walk behind or riding mower model/VIN
S/N
Mower attachment model/VIN
S/N
Bagger model/VIN
S/N
Clipping disposal: Side discharged
Mulched
Bagged
1. Is a vacuum or sweeper being run at full throttle? B. Mower level side to 1/8 inch above level. Mowing speed suits conditions?
Test operation after adjusting...
Similar Questions
Lawn Mower Wont Start After Three Cuts
(Posted by luvde 9 years ago)
Lawn Mower Does Not Work
(Posted by thdraco0 9 years ago)
Carb Clean On Toro Lawn Mower But Still Wont Stay Running
(Posted by cwerSpark 10 years ago)
Toro Recycler High Wheel 6.75 190cc Wont Stay Running
(Posted by rogibson 10 years ago)
I Have New Toro 22' High Wheel Recycler Mower Mdl 20331. I Ned Instruction Manua
I bought this Toro 20331 "as is"put together & brand new from Home Depot. They said they did not...
I bought this Toro 20331 "as is"put together & brand new from Home Depot. They said they did not...
(Posted by 0431mam 11 years ago)