Toro 20333 Support Question
Toro 20333 Support Question
Find answers below for this question about Toro 20333 - BBC Personal Pace Walk Power Mower.Need a Toro 20333 manual? We have 2 online manuals for this item!
Question posted by bobbyjamal on August 26th, 2014
How To Change Drive Belt On Toro Mower Model 20333
The person who posted this question about this Toro product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by freginold on September 3rd, 2014 2:46 AM
freginold
Member since:
December 20th, 2011 Points: 23,253,885
Member since:
December 20th, 2011 Points: 23,253,885
Related Toro 20333 Manual Pages
Operation Manual - Page 1
... information, contact an Authorized Service Dealer or Toro Customer Service and have similar laws. This manual identifies potential hazards and has safety messages identified by residential homeowners.
Serial No.
It is a violation of special attention. 22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up Model No. 20333C-Serial No. 312000001 and Up...
Operation Manual - Page 2
...models with SAE J1940.
The safety alert symbol (Figure 2) is used to alert you to observe the following safety instructions could lose your footing; Improperly using or maintaining this potential, comply with the instructions, to a complete stop the engine and check for walk-behind rotary lawn mowers...• Disengage the drive system, if so equipped... caution when changing direction on ...
Operation Manual - Page 3
...that may block your vehicle before filling.
• Remove gas-powered equipment from a gasoline dispenser nozzle.
• Keep the nozzle....
• Mower blades are explosive.
• Extinguish all times until fueling is spilled on clothing, change the engine governor...is not alert to the presence of Gasoline
To avoid personal injury or property damage, use a nozzle lock-open flame...
Operation Manual - Page 4
... machine.
3. Cutting/dismemberment hazard of potential danger. Cutting/dismemberment hazard of hand or foot, mower blade-do not operate up .
108-8117
1.
Lock
112-8867 2. Manufacturer's Mark 1. ...the engine before servicing or performing maintenance.
4. Cutting/dismemberment hazard of hand or foot, mower blade-stay away from moving parts.
5. and look behind you when backing up and ...
Operation Manual - Page 5
... damage the cables when folding or
unfolding the handle. • If a cable is damaged, contact an Authorized
Service Dealer.
5 Remove the handle knobs from the mower housing (Figure 4).
Install and tighten the handle knobs that covers the engine.
1
Installing the Blade Control Bar
No Parts Required
Procedure
Install the blade control...
Operation Manual - Page 6
... 10. Important: Change the engine oil after adding oil to Changing the Engine Oil....
1. Slowly pour oil into the oil fill tube until the oil level reaches the Full line on -demand lever
5.
Dipstick
Figure 5
2. Washout port (not shown) 13. Ignition switch
9. Figure 6
1. 3
Filling the Engine with Oil
Product Overview
No Parts Required
Procedure
Your mower...
Operation Manual - Page 7
... minimum).
Dipstick
Figure 9
2.
Leaded regular gasoline may bring you and others.
• To prevent a static charge from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in an approved fuel container, out of the reach of SF, SG, SH, SJ, SL, or higher.)
3. Important...
Operation Manual - Page 8
... the rear cutting height levers rearward. Using the Self-propel Drive
To operate the self-propel drive, simply walk with your hands on your sides, and the mower will automatically keep pace with both an "I" and a "Stop"), push the switch to the ("I") position. Lower the mower
Note: The cutting height settings are 1 inch (25 mm); 1-3/8 inches...
Operation Manual - Page 9
...the handle (Figure 17). You can also try reaching just under the personal pace handle to the metal handle and push the mower forward a couple of inches (centimeters) forward to roll a couple of... 1.
Note: If the mower does not freely roll backward after self-propelling, stop walking, hold down the switch in place, and allow the mower to disengage the wheel drive. Figure 18
9 Otherwise,...
Operation Manual - Page 10
... grass and leaf clippings back into a ball small enough to go under the mower housing (about 5 inches (13 cm) in a non-windy area.
2. Release the blade control bar.
8.
Take a half sheet of newspaper and crumple it into the lawn.
Install the empty grass bag on -Demand Lever) before recycling the clippings.
Stop...
Operation Manual - Page 11
....
If the bag-on the mower, remove it (refer to collect grass and leaf clippings from the lawn. Bagging the Clippings
Use the ...move it is sharp; WARNING
The blade is damaged, install a new Toro replacement bag.
Stop the engine and wait for all moving parts to...can result in the notches on the bag rest in serious personal injury. WARNING
A worn grass bag could allow small stones ...
Operation Manual - Page 13
...pace while mowing.
- Walk at a time. Operating Tips
General Mowing Tips
• Clear the area of the following:
- Never deliberately mow over any object.
• If the mower... mower for the best lawn appearance. then mow again at the highest cutting height setting and walk slower...with a Toro replacement blade. For example,
13
WARNING
Wet grass or leaves can cause the mower to plug ...
Operation Manual - Page 15
... usage. Important: Before tipping the mower to change the oil or replace the blade,... allow the fuel tank to remove the fuel. Important: Refer to open the air filter cover
(Figure 24). Replacing the Air Filter
Service Interval: Every 25 hours 1. If you must tip the mower prior to the spark plug.
Gasoline is flammable, explosive and can cause personal...
Operation Manual - Page 16
...Self-propel Drive Cable
Whenever you install a new self-propel cable or if the self-propel drive is simplified for Maintenance. 2. Pull down the cable jacket (toward the mower) until the... Changing the Engine Oil
Service Interval: After the first 5 hours Yearly
Run the engine a few minutes before changing the oil to Preparing for the purpose of adjustment, adjust the self-propel drive cable...
Operation Manual - Page 19
...Remove the ignition key (electric-start the engine, it in Figure 33. Start the engine again. 5.
Preparing the Mower for Storage
WARNING
Gasoline vapors can damage the cables, causing an unsafe operating condition.
• Do not damage the...plug. Tighten all nuts, bolts, and screws.
1. When you can no longer start models only). 2. Storage
Store the mower in a cool, clean, dry place.
Operation Manual - Page 20
...starts such as filters, fuel,
lubricants, oil changes, spark plugs, air filters blade sharpening or...Authorized Toro Service Dealer is covered under "Lawn Mowers") or access our web site at their Toro Distributor ...Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly promise to repair the Toro...
Parts Catalog - Page 1
Original Instructions (EN)
Form No. 3371-848 Rev A
22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up
Parts Catalog
Register at www.Toro.com.
Parts Catalog - Page 3
... Assembly 5 Engine and Blade Assembly 6 Front Wheel and Height-of-Cut Assembly 7 Transmission and Rear Wheel Drive Assembly 8 Upper Handle Assembly 9 Upper Handle Component Assembly 10 Attachments and Accessories 11
© 2011-The Toro® Company
Contact us at www.Toro.com.
8111 Lyndale Avenue South Bloomington, MN 55420
3
Printed in the USA.
Parts Catalog - Page 6
... ASM 2 Nut 3 Screw-HWH 1 Spacer-Bearing
14 100-1048
3 Bearing-Ball
15 108-3790
1 Retainer-Belt
16 605256
1 Washer-Plain
17 107-7471 18 3231-25
1 Plate-Guide 1 Screw-CARR
Ref. Part Number...-Tension, Brake
20 117-5970
1 Pulley-BBC
21 110-1790
1 Belt-BBC
22 107-0754
1 Drum
23 3211-42
2 Screw-HH
24 108-9342
1 Nut-Hex
25 115-2892
1 Cover-BBC
26 2412-72
1 Clip-Closed, Insulated...
Parts Catalog - Page 8
...
9 108-9780
2 Arm-Spring
10 110-0549
2 Knob-HOC
11 115-4652
1 Transmission
12 115-4669
1 Belt-V
13 114-7977-03 1 Bracket-Transmission
Ref. Part Number Qty. Part Number Qty. Transmission and Rear Wheel Drive Assembly
Ref. Description
14 108-7476
3 Screw-Plastite
15 110-7191
2 Washer-Thrust
16 115-4668
2 Gear...
Similar Questions
How To Change Drive Belt For Toro 20330 Lawn Mower
(Posted by randyasouvi 9 years ago)
How To Start A Toro Recycler 22 Cut Mower Model 20333
(Posted by nagTreen 9 years ago)
How To Change Drive Belt On Toro Personal Pace Mower Model # 20333
(Posted by sewPhila5 10 years ago)
Toro Lawn Mower Model 20333 Wont Start
(Posted by dfwhary 10 years ago)
How Do I Rout The Drive Belt On Model 72043. I Need A Diagram
(Posted by pemvr 11 years ago)