Home » Toro » Lawn Mowers » Toro 20332

Toro 20332 Support Question

Find answers below for this question about Toro 20332 - Recycler 190CC Personal Pace Lawn Mower.
Need a Toro 20332 manual? We have 2 online manuals for this item!

Toro Overview Questions Manuals Reviews Videos Research

Question posted by huelster on July 6th, 2013

I Have A Toro And The Back Wheels Wont Go Backwards At All

I have cleaned the wheels,sprayed lubication on the wheels, greased the gears.and the back wheels will not turn backwards to make it easier to clean the grass out or turn the corners. What else can I do?

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Toro 20332 Manual Pages

Operation Manual - Page 1

.... WARNING CALIFORNIA Proposition 65 Warning The engine exhaust from an Authorized Service Dealer or at www.Toro.com. This manual identifies potential hazards and has safety messages identified by residential homeowners. 22in Recycler® Lawn Mower Model No. 20332-Serial No. 312000001 and Up Model No. 20334-Serial No. 312000001 and Up Model No. 20352...

Operation Manual - Page 2

...backward unless absolutely necessary. Only use accessories approved by the blade. Poor footing could cause a slip and fall accidents, which could result in wet grass. Read and understand the contents of this class of lawn mower... rated by the engine manufacturer in the manual(s) before cleaning the machine, removing grass catcher, or unclogging the discharge guard. • Operate...

Operation Manual - Page 3

...with the rim of a child. Clean up . Do not use a nozzle...Use extra care when approaching blind corners, shrubs, trees, or other..., pipes, and other sources of grass, leaves, or other debris build-up...turn mower off if a child enters the area. • Never allow children to prevent unintended starting . • Never make...Safe Handling of Gasoline To avoid personal injury or property damage, use ...

Operation Manual - Page 8

.... • Do not put your fingers under the housing when adjusting the cutting height. Turn the ignition key (Figure 11) (electric-start models only) or pull the recoil start...(Figure 12). and 4 inches (102 mm). 8 Figure 11 Adjust the cutting height as the rear wheels (Figure 9). Lower the mower Note: The cutting height settings are 1 inch (25 mm); 1-3/8 inches (35 mm); 1-3/4 inches...

Operation Manual - Page 9

... the upper handle and your elbows at your hands in serious personal injury or death to recycle the grass and leaf clippings back into the lawn. contacting the blade can also try reaching just under the personal pace handle to the metal handle and push the mower forward a couple of inches (centimeters) forward to Removing the Side...

Operation Manual - Page 10

..., ensuring that the pins on the bag rest in serious personal injury. WARNING The blade is attached to the mower. • For bagging the grass and leaf clippings, press the button on the bag-on-demand lever and move the • For recycling the grass and leaf clippings, press the button on the lever and...

Operation Manual - Page 11

... up the side deflector and install the side discharge chute (Figure 17). 1. Clean here Figure 16 Side-discharging the Clippings Use the side discharge for all moving parts to Operating the Bag-on-Demand Lever). Stop the engine and wait for cutting very tall grass. WARNING The blade is in serious personal injury.

Operation Manual - Page 12

... a full swath with a Toro replacement blade. Overlap cutting swaths instead of the grass blade at a slower pace while mowing. - Set the cutting height on your mowing speed if the mower does not cut below the 2-1/8-inch (54 mm) setting unless the grass is unsatisfactory, try one pass over the lawn for the best lawn appearance. For example...

Operation Manual - Page 13

... within 3 seconds after releasing the blade control bar. • Clean grass clippings and dirt from the normal operating position. replace it more ...(go to www.toro.com to find the nearest dealer) or at www.shoptoro.com. tip the mower prior to remove.... Gasoline is flammable, explosive and can cause personal injury. Important: Before tipping the mower to change the oil or replace the blade...

Operation Manual - Page 14

...20). Refer to the operating position. 6. Return the mower to Preparing for the oil to open the air filter...fill tube securely. 12. Wipe the dipstick clean with oil and run the engine. Note...Figure 21). Important: Do not overfill the crankcase with a clean cloth. 9. Use a screw driver to settle. 8. Remove...the oil to a level surface. 2. Move the mower to warm it. Read the oil level on ...

Operation Manual - Page 15

...pull out the battery, and locate the fuse (Figure 24. 15 Connect the charger to the mower wire harness located below the ignition key (Figure 22). • A green light indicates that... and locate the battery compartment (Figure 23). 1. Note: When the battery no longer holds a charge, recycle or dispose of charging: • A red light indicates that the charger is fully charged. Replace it ...

Operation Manual - Page 16

... spare fuse in step 3. 6. Install the covering over the battery compartment. 7. Tip the mower onto its side with a block of the blade to hold the blade steady (Figure 25... sharp; contacting the blade can result in the fuse holder (Figure 24). Replace the fuse in serious personal injury. Remove the blade, saving all mounting hardware (Figure 26). 1 2 3 1. Fuse holder ...

Operation Manual - Page 18

Recycle it according to the outside of the handle knobs as you fold the handle. Run the mower until the engine stops from Storage 1. When you must charge the battery every 90... the handle knobs until it is damaged, contact an Authorized Service Dealer. 1. Note: Old fuel in a cool, clean, dry place. Disconnect the wire from the spark plug. 7. On the last refueling of the year, add fuel ...

Operation Manual - Page 20

... fail, you , refer to the Yellow Pages of repairs under "Lawn Mowers") or access our web site at www.Toro.com. failure to drain the fuel system prior to any period of... Recycler® 20 in Mulcher/Bagger Walk Power Mowers Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly promise to repair the Toro Product...

Parts Catalog - Page 1

Form No. 3371-846 Rev A 22in Recycler® Lawn Mower Model No. 20332-Serial No. 312000001 and Up Parts Catalog Register at www.Toro.com. Original Instructions (EN)

Parts Catalog - Page 2

... the part. The reference number for a part also appears in an illustration has a reference number. For example, a wheel assembly might be identified by reference number 6, the tire by 6:1, the valve by 6:2, and the wheel by reference number 6, you may also order any part individually. Reference Numbers Indicating Quantity In an illustration, if...

Parts Catalog - Page 3

... Chute and Rear Door Assembly 4 Rear Bag Assembly 5 Engine and Blade Assembly 6 Front Wheel and Height-of-Cut Assembly 7 Transmission and Rear Wheel Drive Assembly 8 Handle Assembly 9 Attachments and Accessories 10 © 2011-The Toro® Company Contact us at www.Toro.com. 8111 Lyndale Avenue South Bloomington, MN 55420 3 Printed in the USA.

Parts Catalog - Page 4

... 2 114-7963-01 1 Baffle-Front 5 114-7961 1 Baffle-Rear 6 115-4677 1 Chute-Recycle 7 46-8091 9 Screw-HWH 8 112-6416 1 Bracket-Cover 9 99-8445 2 Screw-HWH,...13 115-8447 1 Chute-Discharge, Side 14 114-7960 1 Deflector-Recycle 15 114-7958 1 Knob-Recycle Ref. Part Number Qty. Description 16 114-7959 1 Latch-Recycle 17 117-1031 1 Spring-Compression 18 32104-120 2 Screw-PPH ...

Parts Catalog - Page 7

Part Number Qty. Front Wheel and Height-of-Cut Assembly Ref. Description 1 115-1956-03 2 Plate-HOC, Front 2 322-3 4 Screw-HH 3 3296-29 6 Nut-Lock, NI 4 105-1818 2 Bushing-Mount, ... 2 Arm-Spring 7 110-0549 2 Knob-HOC 8 105-3048 2 Washer-Flat 9 322-6 2 Screw-HH 10 40-1940 2 Washer 11 614650 2 Bolt-Shoulder 12 115-2894 2 8 Inch Wheel ASM C2 7 3371-846A

Parts Catalog - Page 8

... 14 108-7476 3 Screw-Plastite 15 110-7191 2 Washer-Thrust 16 115-4668 2 Gear-Pinion, 12T 17 32151-61 2 Ring-Retaining 18 110-1792 2 Wheel Cover ASM 18:2 614426 1 Washer-Stepped 19 614650 2 Bolt-Shoulder 20 115-4695 2 8 Inch Wheel Gear ASM 21 115-8406 2 Anchor-Bag 22 105-9437 2 Screw-PPH 23 115...