Toro 20332 Support Question
Toro 20332 Support Question
Find answers below for this question about Toro 20332 - Recycler 190CC Personal Pace Lawn Mower.Need a Toro 20332 manual? We have 2 online manuals for this item!
Question posted by wftx604 on May 5th, 2013
Gas Is Leaking From Carburator
Gas is leaking from carburator
Current Answers
Answer #1: Posted by freginold on May 12th, 2013 7:59 AM
freginold
Member since:
December 20th, 2011 Points: 23,254,995
Member since:
December 20th, 2011 Points: 23,254,995
Hi, there is probably a bad gasket in your carburetor. RepairClinic.com sells a rebuild kit for your carburetor for $9.05, or a whole new carb for $38.25.
Related Toro 20332 Manual Pages
Operation Manual - Page 1
...serial numbers in the USA
All Rights Reserved This rotary-blade, walk-behind lawn mower is a violation of special attention. Whenever you do not follow the recommended... manual identifies potential hazards and has safety messages identified by residential homeowners.
22in Recycler® Lawn Mower
Model No. 20332-Serial No. 312000001 and Up Model No. 20334-Serial No. 312000001 and...
Operation Manual - Page 2
... steep slopes. For models with the following safety instructions.
To reduce this class of lawn mower will be ordered through the engine manufacturer. Stop machine if anyone . walk; Avoid... instructions have been adapted from the ANSI/OPEI standard B71.1-2003. Failure to potential personal injury hazards.
Read and understand the contents of this machine.
• Clear the...
Operation Manual - Page 3
...of Gasoline
To avoid personal injury or property damage, use extreme care in safe working condition.
• Never tamper with manufacturer's recommended parts, when necessary.
• Mower blades are often ... .
Check their proper operation regularly.
• Keep machine free of a child. Replace gas cap and tighten securely. Do not use extra caution when servicing them .
• Keep...
Operation Manual - Page 4
...Instructional Decals
Important: Safety and instruction decals are located near areas of hand or foot, mower blade-stay away from moving parts.
5. Read the Operator's Manual.
1. Indicates the blade...
4. Replace damaged decals. Cutting/dismemberment hazard of hand or foot, mower blade-remove the ignition key and read the Operator's Manual.
2. Cutting/dismemberment hazard of hand or foot...
Operation Manual - Page 5
...install the handle.
2
Filling the Engine with Oil
No Parts Required
Procedure
Important: Your mower does not come with oil in the crankcase, then do the following: 1. fill: 20...Before starting the engine, fill the engine with a clean cloth.
4.
Remove the handle knobs from the mower housing (Figure 3). Figure 3
2. Move the handle to a level surface. 2. Remove the dipstick by ...
Operation Manual - Page 7
...the reach of 87 or higher) from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in a vehicle or on the dipstick. Fill ...others.
• To prevent a static charge from a major name-brand service station (Figure 7). Move the mower to the fuel all season, mixing it with fresh unleaded regular gasoline (having an octane rating of children....
Operation Manual - Page 8
...) or pull the recoil start handle, pull it lightly until you .
To lower the mower, move the front cutting height levers rearward and the rear cutting height levers forward. Note...: When you pull the recoil start handle (Figure 12). Lower the mower
Note: The cutting height settings are 1 inch (25 mm); 1-3/8 inches (35 mm); 1-3/4 inches (44 mm...
Operation Manual - Page 9
...personal injury. Installing the Grass Bag
1.
If the bag-on-demand lever is in the recycling position, move the lever to the recycling position (refer to Operating the Bag-on the mower, remove it (refer to roll a couple of inches (centimeters).
Recycling the Clippings
Your mower comes from the lawn...under the personal pace handle to the metal handle and push the mower forward ...
Operation Manual - Page 10
...pops up . Rear deflector
Figure 14 3.
contacting the blade can result in serious personal injury or death to the mower. • For bagging the grass and leaf clippings, press the
button on the...For proper operation, remove any grass clippings and debris from one position to either collect or recycle grass and leaf clippings while the grass bag is sharp; Lower the rear deflector. lever ...
Operation Manual - Page 11
...discharge chute (Figure 17).
1. WARNING
The blade is on the mower and the bag-on -Demand Lever). contacting the blade can result in the bagging position, move the lever to the recycling position (refer to stop before leaving the operating position. Stop the... discharge for all moving parts to Operating the Bag-on -demand lever is in serious personal injury. If the grass bag is sharp;
Operation Manual - Page 12
...; Cut only about a third of the grass blade at a slower pace while mowing.
- If the grass is too long, the mower may need to make more of the following:
- Overlap cutting swaths ...WARNING
Wet grass or leaves can cause the mower to plug or the engine to Adjusting the Cutting Height.
• When cutting grass over the lawn for the best lawn appearance. This helps disperse the clippings over ...
Operation Manual - Page 13
... running out of the machine from under the mower.
• Replace the air filter;
Gasoline is flammable, explosive and can cause personal injury.
clean it sharpened (more frequently if the...air filter up. Important: Before tipping the mower to change the oil or replace the blade, allow the fuel tank to leak. Recommended Maintenance Schedule(s)
Maintenance Service Interval
After ...
Operation Manual - Page 14
...oil to the operating position. 6. Drain the excess oil until the oil level is at a local recycling center.
14 Replace the air filter (Figure 19). 3. Warm oil flows better and carries more ... dipstick, slowly pour a small amount of oil in
the crankcase. 7. Figure 21
5. Return the mower to warm it. Wait 3 minutes for Maintenance. 3. Insert the dipstick fully into the oil fill ...
Operation Manual - Page 15
...Battery 4. Wipe away any debris in the battery compartment area.
3. Connect the charger to the mower wire harness
located below the ignition key (Figure 22).
• A green light indicates that...as needed. Screw
Figure 23
3. Note: When the battery no longer holds a charge, recycle or dispose of California to cause cancer and reproductive harm. Charging the Battery
Service Interval: ...
Operation Manual - Page 16
... saving all mounting hardware (Figure 26).
Examine the blade whenever you removed in serious personal injury. If the blade is dull or nicked, have a torque wrench or are ...compartment. 7. If you do not have it sharpened and balanced, or replace it immediately.
Tip the mower onto its side with a block of gasoline. If the blade edge is damaged or cracked, replace...
Operation Manual - Page 18
... Old fuel in Figure 29. Remove the ignition key (electric-start models only). Preparing the Mower for Storage
WARNING
Gasoline vapors can no longer start models only).
2. Do not store fuel ...8226; Do not store gasoline more than 30 days.
• Do not store the mower in your automobile. Recycle it according to the spark plug.
18 Loosely install the spark plug.
9. Charge the...
Operation Manual - Page 20
year full warranty
Limited Warranty for Commercial Use*
Gas-powered Toro Products used for commercial, institutional, or rental use over three months... purchase:
Products
22 in Recycler and 20 in Mulcher/Bagger and Attachments GTS (Guaranteed to follow this warranty. The Toro GTS (Guaranteed to the Yellow Pages of your telephone directory (look under "Lawn Mowers") or access our web ...
Parts Catalog - Page 1
Form No. 3371-846 Rev A
22in Recycler® Lawn Mower
Model No. 20332-Serial No. 312000001 and Up
Parts Catalog
Register at www.Toro.com.
Original Instructions (EN)
Parts Catalog - Page 2
... head thread forming CARR: carriage CCW: counter clockwise CW: clockwise DEG: degrees DPA: Dual Point Adjustment ECM: electronic control module EXT: external FH: flat head GA: gauge HD: heavy-duty HF: hex flange HH: hex head HHF: hex head flange HHFTF: hex head flange thread forming HJ: hex jam HLH: hex...
Parts Catalog - Page 4
..., Washout
2 114-7963-01 1 Baffle-Front
5 114-7961
1 Baffle-Rear
6 115-4677
1 Chute-Recycle
7 46-8091
9 Screw-HWH
8 112-6416
1 Bracket-Cover
9 99-8445
2 Screw-HWH, Taptite
10...-Side
13 115-8447
1 Chute-Discharge, Side
14 114-7960
1 Deflector-Recycle
15 114-7958
1 Knob-Recycle
Ref. Deck, Side Chute and Rear Door Assembly
Ref. Part Number Qty. Description
16 114-7959
1 ...
Similar Questions
Owners Manual For Toro 190 Cc Personal Pace Lawn Mower
(Posted by nelsontim1 9 years ago)
How Much Oil Does A Toro Personal Pace Push Mower Take
(Posted by ricant 10 years ago)
Toro Recycler Personal Pace Lawn Mower Wont Start
(Posted by barnejon 10 years ago)
How To Change Oil On A Toro Recycler (22 ) 190cc Personal Pace Lawn Mower
(Posted by tinaScamp1 10 years ago)
Blade For Model 20037 Personal Pace Lawn Mower
where can i buy a replacement 21 inch bladefor my 2003 Toro model 20037 personal Pace lawn mower???
where can i buy a replacement 21 inch bladefor my 2003 Toro model 20037 personal Pace lawn mower???
(Posted by lynnegrede 12 years ago)