Home » Toro » Lawn Mowers » Toro 20332

Toro 20332 Support Question

Find answers below for this question about Toro 20332 - Recycler 190CC Personal Pace Lawn Mower.
Need a Toro 20332 manual? We have 2 online manuals for this item!

Toro Overview Questions Manuals Reviews Videos Research

Question posted by chuckesloon on October 30th, 2014

Blade Engagement

After replacing spring torsion on handle blade won't engage

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by waelsaidani1 on October 30th, 2014 10:43 PM

This answer was accepted by the poster of the original question.

waelsaidani1

Member since:
May 12th, 2013

Points: 19,501,797

1,100
points

If the blades don't rotate the electric PTO clutch might not be engaging. The PTO - or Power Take Off clutch provides a non-mechanical way to disconnect the engine from the blades. When electricity is applied to the clutch solenoid the clutch engages. Attached to the clutch is a pulley, a belt from the engine crankshaft pulley to the PTO provides the rotation of the blades. If power doesn't reach the PTO, or if the solenoid is defective, or if the clutch is worn out, the blades will not engage. The PTO clutch is not repairable, if defective or worn out it will need to be replaced.

Related Toro 20332 Manual Pages

Operation Manual - Page 1

... for cutting brush or for operating the product properly and safely. This rotary-blade, walk-behind lawn mower is a violation of the model and serial numbers on any forest-covered, ...Recycler® Lawn Mower Model No. 20332-Serial No. 312000001 and Up Model No. 20334-Serial No. 312000001 and Up Model No. 20352-Serial No. 312000001 and Up Form No. 3371-667 Rev A Operator's Manual Replacement...

Operation Manual - Page 2

...lawn mower will be sure of the engine was laboratory rated by the engine manufacturer in wet grass. As configured to potential personal... of accessories. Safety This lawn mower meets or exceeds the CPSC blade safety requirements for walk-behind the handle when the engine is running...by the blade. Replacements may ricochet back toward anyone enters the area. • ...

Operation Manual - Page 3

...replace with the engine running . Service Safe Handling of ignition. • Use only an approved gasoline container. • Never remove gas cap or add fuel with manufacturer's recommended parts, when necessary. • Mower blades...Never fill containers inside a vehicle or on other sources of Gasoline To avoid personal injury or property damage, use a nozzle lock-open flame, spark, or ...

Operation Manual - Page 4

... 114-7982 1. Warning-read the Operator's Manual for information on slopes; Replace damaged decals. operate side to side on charging the battery; Cutting/dismemberment hazard of hand or foot, mower blade-do not discard. 2. Cutting/dismemberment hazard of hand or foot, mower blade-remove the ignition key and read the instructions before leaving the operating...

Operation Manual - Page 6

... only) 4. Grass bag 2. Product Overview 3 Charging the Battery No Parts Required Procedure Electric-start 10. Blade control bar 9. Install the dipstick into the oil fill tube securely. Important: Change the engine oil after the first 5 operating hours; Handle 8. Cutting height lever (4) 2. Bag-on the dipstick reads Full. 6. Recoil start models only) 6 Battery...

Operation Manual - Page 8

... the engine and wait for all moving parts to the handle slowly. 1. and 4 inches (102 mm). 8 Figure 11 To lower the mower, move the front cutting height levers rearward and the rear cutting height levers forward. Hold the blade control bar against the handle (Figure 10). Adjusting the Cutting Height WARNING Adjusting the cutting...

Operation Manual - Page 9

... the wheel drive. contacting the blade can also try reaching just under the personal pace handle to the metal handle and push the mower forward a couple of inches (centimeters) forward to roll a couple of inches (centimeters). Stop the engine and wait for all moving parts to Removing the Side Discharge Chute) before recycling the clippings. Note: Remove...

Operation Manual - Page 10

.... WARNING The blade is attached to either collect or recycle grass and leaf clippings while the grass bag is sharp; Grass bag pin (2) 2. Also, an open rear discharge area could allow small stones and other similar debris to be thrown in the operator's or bystander's direction and result in serious personal injury or...

Operation Manual - Page 11

... mower and the bag-on-demand lever is sharp; contacting the blade can result in the bagging position, move the lever to the recycling ...position (refer to stop before leaving the operating position. Clean here Figure 16 Side-discharging the Clippings Use the side discharge for all moving parts to Operating the Bag-on-Demand Lever). WARNING The blade is in serious personal...

Operation Manual - Page 12

...and leaves tend to clump on the lawn, set the front wheels at 2-1/8-inch (54 mm) and the rear wheels at a slower pace while mowing. - Mow only in dry...mower for damage. • For best performance, install a new blade before the cutting season begins. • Replace the blade when necessary with a Toro replacement blade. Overlap cutting swaths instead of cutting a full swath with the blade...

Operation Manual - Page 13

... operator's manual for all moving parts to run dry through normal usage. Gasoline is flammable, explosive and can cause personal injury. Figure 18 3. Important: Before tipping the mower to change the oil or replace the blade, allow the fuel tank to stop. 2. Stop the engine and wait for additional maintenance procedures. Disconnect the spark...

Operation Manual - Page 14

... steps 8 through the oil fill tube (Figure 21). Drain the excess oil until the oil level is at a local recycling center. 14 Replace the air filter (Figure 19). 3. Dipstick Figure 20 4. Return the mower to settle. 8. Wait 3 minutes for Maintenance. 3. Wipe the dipstick clean with oil and run the engine. Dispose of oil...

Operation Manual - Page 15

...Replace it with the electric starter, the fuse may have a two-color LED display that indicates the following states of charging: • A red light indicates that the charger is nearly fully charged. Screw Figure 23 3. Note: When the battery no longer holds a charge, recycle... Wash hands after handling. Replacing the Fuse Electric-... according to the mower wire harness located below...

Operation Manual - Page 16

... all mounting hardware (Figure 25). 5. Examine the blade whenever you do not have it sharpened and balanced, or replace it immediately. Note: Your mower comes with the screw that you removed in the battery compartment. 5. If the blade edge is sharp; WARNING The blade is dull or nicked, have a torque wrench or are uncomfortable performing...

Operation Manual - Page 18

Recycle it according to local codes, or use it in the fuel tank is the leading cause of the year, add fuel stabilizer to prevent cylinder corrosion during the off-season. 8. Run the mower... fuel properly. When you fold the handle. Charge the battery for 24 hours, then unplug the battery charger an store the mower in Figure 29. Preparing the Mower for 24 hours (electric-start models ...

Operation Manual - Page 20

... and requires replacement or repair due... Products 22 in Recycler and 20 in ...spring and late autumn - Items and Conditions Not Covered There is no longer start on the first or second pull, provided the routine maintenance required in the Operator's Manual have purchased Toro products exported from the date of repairs under "Lawn Mowers... dealership. rotary mower blade striking an object...

Parts Catalog - Page 1

Original Instructions (EN) Form No. 3371-846 Rev A 22in Recycler® Lawn Mower Model No. 20332-Serial No. 312000001 and Up Parts Catalog Register at www.Toro.com.

Parts Catalog - Page 3

Contents Deck, Side Chute and Rear Door Assembly 4 Rear Bag Assembly 5 Engine and Blade Assembly 6 Front Wheel and Height-of-Cut Assembly 7 Transmission and Rear Wheel Drive Assembly 8 Handle Assembly 9 Attachments and Accessories 10 © 2011-The Toro® Company Contact us at www.Toro.com. 8111 Lyndale Avenue South Bloomington, MN 55420...

Parts Catalog - Page 4

... 1 Chute-Discharge, Side 14 114-7960 1 Deflector-Recycle 15 114-7958 1 Knob-Recycle Ref. Description 16 114-7959 1 Latch-Recycle 17 117-1031 1 Spring-Compression 18 32104-120 2 Screw-PPH 19 121-5776 1 Rear Door ASM 19:2 114-7982 1 Decal-Warning 20 115-2859 1 Spring-Torsion 21 114-7924 1 Spring-Torsion 22 112-6400 1 Port-Washout 23 112...

Parts Catalog - Page 6

...-3425-B1 ● ■ 2 104-7577-03 1 Shield-Muffler 3 32144-1 3 Screw-Taptite 5 106-3999 1 Spacer-Driver 6 106-3987 1 Blade Driver ASM 7 108-9764-03 1 Blade-22 Inch 8 108-3766-03 1 Support-Blade 9 105-8579 1 Bolt-Blade 10 105-3030-03 1 Guide-Belt 11 95-1726 3 Screw-Taptite 12 114-7937 1 Cover-Belt 13 46...