Toro 20332 Support Question
Toro 20332 Support Question
Find answers below for this question about Toro 20332 - Recycler 190CC Personal Pace Lawn Mower.Need a Toro 20332 manual? We have 2 online manuals for this item!
Question posted by Alic3ae367 on March 3rd, 2014
Walking Lawn Mower Back Wheels Wont Go Backwards
The person who posted this question about this Toro product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Toro 20332 Manual Pages
Operation Manual - Page 1
...Whenever you do not follow the recommended precautions. Figure 2 1.
This rotary-blade, walk-behind lawn mower is not designed for cutting brush or for agricultural uses. You may contact Toro ... engine is designed primarily for cutting grass on well-maintained lawns on residential properties. 22in Recycler® Lawn Mower
Model No. 20332-Serial No. 312000001 and Up Model No. 20334-Serial ...
Operation Manual - Page 2
... for walk-behind rotary lawn mowers and the B71.1 specifications of the American National Standards Institute in wet grass.
Material may be thrown by the blade.
never up and down and behind the handle when the engine is running machine unattended.
• Stop the engine and wait until the blade comes to potential personal...
Operation Manual - Page 3
... open device.
• If fuel is not alert to the presence of Gasoline
To avoid personal injury or property damage, use a nozzle lock-open flame, spark, or pilot light such ...• Never remove gas cap or add fuel with manufacturer's recommended parts, when necessary.
• Mower blades are explosive.
• Extinguish all times until fueling is in safe working condition.
• Never...
Operation Manual - Page 4
Cutting/dismemberment hazard of hand or foot, mower blade-remove the ignition key and read the instructions ...7982
1. contains lead; Safety and Instructional Decals
Important: Safety and instruction decals are located near areas of hand or foot, mower blade-stay away from moving parts.
5. Replace damaged decals. Manufacturer's Mark
1. Indicates the blade is identified as a part ...
Operation Manual - Page 5
...you install the handle.
2
Filling the Engine with Oil
No Parts Required
Procedure
Important: Your mower does not come with oil. Before starting the engine, fill the engine with a bottle ...by rotating the cap
counterclockwise and pulling it does come with oil in step 1 .
1. Move the mower to the operating position. 3. Move the handle to a level surface. 2. Install and tighten the ...
Operation Manual - Page 7
... 7 fill: 20 oz. (0.59 l), type: SAE 30 detergent oil with a clean cloth.
4. Move the mower to the fuel all season, mixing it with gasoline. Note: Never use or daily
Note: Max. Wipe the ...(having an octane rating of 87 or higher) from igniting the gasoline, place the container and/or mower directly on the dipstick (Figure 8). A fire or explosion from gasoline can burn you and others.
&#...
Operation Manual - Page 8
... when adjusting the cutting height. Blade control bar
Figure 10
2. Lower the mower
Note: The cutting height settings are 1 inch (25 mm); 1-3/8 inches ...mower, move the front cutting height levers forward and the rear cutting height levers rearward.
1. Allow the rope to return to the same height as desired. Adjust the cutting height as the rear wheels (Figure 9). Set the front wheels...
Operation Manual - Page 9
... mower does not start models only). Recycling the Clippings
Your mower comes from the lawn. Bagging the Clippings
Use the grass bag when you leave the mower (electric-start after self-propelling, stop within 3 seconds.
WARNING
The blade is damaged, install a new Toro replacement bag. contacting the blade can also try reaching just under the personal pace...
Operation Manual - Page 10
... For proper operation, remove any grass clippings and debris from one position to either collect or recycle grass and leaf clippings while the grass bag is sharp;
Stop the engine and wait for all...Bag
To remove the bag, reverse the steps above. Bag-on-demand lever (in serious personal injury or death to the mower. • For bagging the grass and leaf clippings, press the
button on the bag...
Operation Manual - Page 11
...personal injury. Clean here
Figure 16
Side-discharging the Clippings
Use the side discharge for all moving parts to Operating the Bag-on -demand lever is sharp; Stop the engine and wait for cutting very tall grass. contacting the blade can result in the bagging position, move the lever to the recycling...discharge deflector.
11 If the grass bag is on the mower and the bag-on -Demand Lever).
Operation Manual - Page 12
...lawn, set the front wheels at 2-1/8-inch (54 mm) and the rear wheels at a slower pace while mowing.
- For example, set the front cutting height one or two notches higher than the rear cutting height.
• Slow down .
Walk...all local fire warnings, and keep the mower free of cutting a full swath with each pass.
- Cut the grass more of the lawn shows through the cut the leaves finely ...
Operation Manual - Page 13
...engine operator's manual for any maintenance procedure. Gasoline is flammable, explosive and can cause personal injury. never siphon.
After performing the maintenance procedure(s), connect the spark plug wire to ...
1. If you must
13 replace it more frequently in dusty operating conditions.
tip the mower prior to running out of the machine from the spark plug (Figure 18) before annual...
Operation Manual - Page 14
... carries more contaminants. 1. Figure 21
5. Note: If the oil level is at a local recycling center.
14
Move the mower to warm it.
Wait 3 minutes for Maintenance. 3. Dispose of oil into the oil fill ...the oil level on the dipstick reads Full. 11. Return the mower to open the air filter cover
(Figure 19). 2.
Tip the mower onto its side with the air filter up to settle. 8....
Operation Manual - Page 15
...a 40-amp plug-in type fuse.
1. Note: When the battery no longer holds a charge, recycle or dispose of California to cause cancer and reproductive harm.
This state lasts only a few minutes until...lead and lead compounds, chemicals known to the State of the lead-acid battery according to the mower wire harness
located below the ignition key (Figure 22).
• A green light indicates that...
Operation Manual - Page 16
... Wear gloves when servicing the blade.
1. Refer to hold the blade steady
(Figure 25).
Note: Your mower comes with the air filter up. 3. Figure 25
4. WARNING
The blade is dull or nicked, have ...that you run out of wood, put your weight behind the
16 Replace the fuse in serious personal injury. Lower the rear deflector. Remove the blade, saving all mounting hardware (Figure 26). ...
Operation Manual - Page 17
...the washout port on the cable support.
Stop the engine.
8. For best results, clean the mower soon after you install a new self-propel cable or if the self-propel drive is running... of clarity.
1. Refer to its lowest cutting height setting. Washout port
Figure 28
5. Lower the mower to Adjusting the Cutting Height. 2. Loosen the cable support nut (Figure 27). 2. Start the engine...
Operation Manual - Page 18
...-start models only).
2. Figure 29
4. Removing the Mower from running out of fuel.
4. Recycle it according to run until you must store the mower in your automobile. Tighten all nuts, bolts, and ...
Folding or unfolding the handle improperly can move the
upper handle freely. 3.
Preparing the Mower for 24 hours (electric-start model only). 2.
Do not store fuel without stabilizer more...
Operation Manual - Page 20
...22 in Recycler and 20 in Mulcher/Bagger and Attachments GTS (Guaranteed to Start) Engine Battery
Warranty Period 2 -
Some states do not allow exclusions of repairs under "Lawn Mowers") or ...
A 3-Year Full Warranty (Not Applicable for Commercial Use)
22 in Recycler® 20 in Mulcher/Bagger
Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate, Toro Warranty ...
Parts Catalog - Page 1
Form No. 3371-846 Rev A
22in Recycler® Lawn Mower
Model No. 20332-Serial No. 312000001 and Up
Parts Catalog
Register at www.Toro.com. Original Instructions (EN)
Parts Catalog - Page 2
... the parts identified by reference numbers 6:1,6:2, and 6:3. When you order the assembly identified by 6:3.
Understanding Reference Numbers Each identified part in the form a:b.
For example, a wheel assembly might be identified by reference number 6, the tire by 6:1, the valve by 6:2, and the...
Similar Questions
Toro 190cc Personal Pace Will Not Revers
(Posted by daddbp 10 years ago)
My Toro Walk Behind Mower Blades Wont Engage
(Posted by kenSanta 10 years ago)
Toro Lawn Mower 20332 Wont Start
(Posted by evandho 10 years ago)
Toro 190cc Personal Pace Won't Start
(Posted by Soupokef 10 years ago)
How To Change Oil On A Toro Recycler (22 ) 190cc Personal Pace Lawn Mower
(Posted by tinaScamp1 10 years ago)