Home » Toro » Lawn Mowers » Toro 20332

Toro 20332 Support Question

Find answers below for this question about Toro 20332 - Recycler 190CC Personal Pace Lawn Mower.
Need a Toro 20332 manual? We have 2 online manuals for this item!

Toro Overview Questions Manuals Reviews Videos Research

Question posted by tommparjo on September 19th, 2014

What Type Of Oil Does A Personal Pace Use

The person who posted this question about this Toro product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by freginold on October 3rd, 2014 3:27 AM

freginold

Member since:
December 20th, 2011

Points: 23,253,885

100
points

Hi, this model uses type SAE 30 engine oil (20 ounces).

Please rate this answer using the "Helpful" button below if it was helpful to you. If your question wasn’t answered to your satisfaction, feel free to resubmit your question with more information. Thank you for using HelpOwl!

https://configpages.blogspot.com

Related Toro 20332 Manual Pages

Operation Manual - Page 1

...blade, walk-behind lawn mower is not equipped...uses. Figure 1 identifies the location of California Public Resource Code Section 4442 to avoid injury and product damage. Model and serial number plate Write the product model and serial numbers in the USA All Rights Reserved Important calls attention to register your product ready. 22in Recycler® Lawn Mower Model No. 20332...

Operation Manual - Page 2

.... Safety This lawn mower meets or exceeds the CPSC blade safety requirements for walk-behind rotary lawn mowers and the B71... the engine and check for the cause immediately. Improperly using or maintaining this symbol to slip and fall accident. Always... backward unless absolutely necessary. If you start to potential personal injury hazards. Read and understand the contents of this ...

Operation Manual - Page 3

... rim of Gasoline To avoid personal injury or property damage, use extreme care in contact with the engine running . Wrap the blade or wear gloves, and use a nozzle lock-open flame,...responsible adult other debris build-up oil or fuel spillage and remove any adjustments or repairs with manufacturer's recommended parts, when necessary. • Mower blades are explosive. • Extinguish...

Operation Manual - Page 5

...type: SAE 30 detergent oil with a clean cloth. 4. Dipstick Figure 4 3. Insert the dipstick fully into the oil fill tube, wait 3 minutes, and repeat steps 3 through 5 until the oil level is below the Add mark on the dipstick, slowly pour a small amount of oil into the oil...the Engine with Oil No Parts Required Procedure Important: Your mower does not come with oil. Install and ...

Operation Manual - Page 6

... Charging the Battery in the Maintenance section. Figure 5 1. Bag-on the dipstick reads Full. 6. Spark plug Figure 6 1. Side discharge chute 3. Install the dipstick into the oil fill tube securely. Product Overview 3 Charging the Battery No Parts Required Procedure Electric-start 10. Side-discharge deflector models only) 4. Important: Do not overfill the...

Operation Manual - Page 7

.... • To prevent a static charge from a major name-brand service station (Figure 7). Checking the Engine Oil Level Service Interval: Before each use methanol, gasoline containing methanol, or gasoline containing more than 30 days old. 1. Move the mower to the fuel all season, mixing it with fresh unleaded regular gasoline (having an octane rating...

Operation Manual - Page 9

... -Demand Lever) before recycling the clippings. You can result in the bagging position, move it is sharp; If the side discharge chute is on the mower, remove it (refer to stop walking, hold up the rear deflector (Figure 14). 9 contacting the blade can also try reaching just under the personal pace handle to Removing...

Operation Manual - Page 10

... blade is attached to the mower. • For bagging the grass and leaf clippings, press the button on the bag-on-demand lever and move the • For recycling the grass and leaf clippings,...bagging position) 1. Install the grass bag, ensuring that the pins on the bag rest in serious personal injury. contacting the blade can result in the notches on the handle (Figure 14). 3. Notches 2....

Operation Manual - Page 11

...here Figure 16 Side-discharging the Clippings Use the side discharge for all moving ... the engine and wait for cutting very tall grass. If the grass bag is on the mower and the bag-on -Demand Lever). Installing the Side Discharge Chute Lift up the side deflector..., move the lever to the recycling position (refer to stop before leaving the operating position. WARNING The blade is in serious...

Operation Manual - Page 12

...8226; If the mower strikes an object or starts to stall. - Set the cutting height on the lawn, set the front wheels at 2-1/8-inch (54 mm) and the rear wheels at a slower pace while mowing. -..., disconnect the wire from the spark plug, and examine the mower for the best lawn appearance. Cutting Leaves • After cutting the lawn, ensure that the blade could hit. • Avoid striking ...

Operation Manual - Page 13

...normal operating position. Gasoline is flammable, explosive and can cause personal injury. Important: Before tipping the mower to change the oil or replace the blade, allow the fuel tank to the ...Schedule(s) Maintenance Service Interval After the first 5 hours Before each use a hand fuel pump to remove the fuel. Always tip the mower onto its side, with a hand pump; Preparing for additional ...

Operation Manual - Page 14

... to drain the used oil properly at the Full mark on the dipstick. Figure 21 5. Wait 3 minutes for Maintenance. 3. Install the dipstick into the oil fill tube, then remove the dipstick. 10. Replace the air filter (Figure 19). 3. Drain the excess oil until the oil level is at a local recycling center. 14 Return the mower to settle...

Operation Manual - Page 15

...the engine does not run with a 40-amp plug-in type fuse. 1. Replacing the Fuse Electric-start models only WARNING ... Note: When the battery no longer holds a charge, recycle or dispose of California to the mower wire harness located below the ignition key (Figure 22)....the battery, and locate the fuse (Figure 24. 15 Always use the charger in the battery compartment area. 3. Note: Your ...

Operation Manual - Page 16

... all mounting hardware (Figure 26). Tip the mower onto its side with a block of gasoline. Use a block of the blade to hold the ...blade steady (Figure 25). Fuse Figure 24 G017398 2. Install the battery compartment with a spare fuse in serious personal injury. Figure 26 Important: Position the curved ends of wood to point toward the mower...

Operation Manual - Page 17

... both the fully forward and fully rearward positions. 4. Allow the engine to the grass bag. Cleaning the Mower Service Interval: Before each use or daily WARNING The mower may dislodge material from rusting. 10. Start the engine and run it for the purpose of adjustment, adjust the self-propel drive cable. 1. Washout port...

Operation Manual - Page 18

...model only). 2. On the last refueling of oil through the spark plug hole, and pull the starter rope slowly several times to distribute oil throughout the cylinder to the spark plug. 18 ... models only). 2. Important: Route the cables to local codes, or use it . 1. Removing the Mower from the spark plug. 7. Recycle it according to the outside of hard starting. Charge the battery for ...

Operation Manual - Page 20

...service during reasonable periods of purchase: Products 22 in Recycler and 20 in Mulcher/Bagger and Attachments GTS (...use over one month • Special operational conditions where starting procedures - cool temperature starts such as filters, fuel, lubricants, oil... one location, or institutional or rental use, is used for your sole remedy under "Lawn Mowers") or access our web site at...

Parts Catalog - Page 1

Form No. 3371-846 Rev A 22in Recycler® Lawn Mower Model No. 20332-Serial No. 312000001 and Up Parts Catalog Register at www.Toro.com. Original Instructions (EN)

Parts Catalog - Page 2

... of the part, the X is the multiplication symbol, and the y represents the reference number. The n represents the quantity of this type appear in illustration and in parts lists. This catalog uses two special reference number formats, one part, the reference number has the form nX y. Service Assembly Reference Numbers Parts in service...

Parts Catalog - Page 4

...Side Chute and Rear Door Assembly Ref. Description 16 114-7959 1 Latch-Recycle 17 117-1031 1 Spring-Compression 18 32104-120 2 Screw-PPH 19 ... Housing ASM 1:2 94-8072 1 Decal-Danger 1:3 115-4676 1 Decal-Recycler 1:4 112-8867 1 Decal-Port, Washout 2 114-7963-01 1 Baffle-Front 5 114-7961 1 Baffle-Rear 6 115-4677 1 Chute-Recycle 7 46-8091 9 Screw-HWH 8 112-6416 1 Bracket-Cover 9...