I Have 8 Channels With No Sound .56 Is Spanish.

The person who posted this question about Time Warner Cable did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by waelsaidani1 on June 28th, 2014 8:25 AM

This answer was accepted by the poster of the original question.

waelsaidani1

Member since:
May 12th, 2013

Points: 19,501,787

1,100
points

Here are some common sound issues and possible solutions:

Different language: Some televisions have additional features like a SAP, MAP or bilingual button. If you are hearing a different language other than what is expected for the channel being viewed, check to see if your TV has one of these buttons and make sure it is turned off. On some sets, these features are controlled by the TV remote.
No sound: Adjust the volume on the TV by increasing the level on the TV.
Buzzing sound: Adjust the TV's fine-tuning. Also check to see if the TV is too close to any appliances that are in use that could interfere with the signal (microwaves, generators, vacuum cleaners, etc.)
Sounds noisy on one channel: Your cable connection may be loose; check the connection and tighten, if necessary.
Sound from only one stereo speaker: Your cable connection may be loose. Check the connection and tighten it if necessary. Check to make sure that no wires are frayed and plugs aren't bent or broken. Make sure the audio cables are connected to the correct Left/Right output jacks on your terminal. Also, check the "balance" setting if sound is being delivered through your stereo amplifier.
If none of the above solutions correct the problem, reboot your cable set-top box.

a. Unplug the power cable from the back of the cable box.
b. Wait 30 seconds.
c. Plug the power cable back into the back of the cable box. The cable box will reboot automatically; it should take no more than 20 minutes.
d. Wait for the time or channel to reappear on front of the cable box.
e. Wait 3 minutes to allow the services to reset.
f. Turn on the TV.

If you are still experiencing problems, please Contact Us.

Time Warner Cable Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

All FAQs | Time Warner Cable | Corporate
...more about doing this ? How do I have selected in Spanish? How do I change how long the banners stay up ...Do I use Caller ID Restore? Can I 'm on the correct channel? How many computers can I use an Internet Service Provider. What ... Call Blocking? What does the Distinctive Ring/Call Waiting Tone sound like my current provider? Can I enable or disable 3-Way...
What is Digital Cable? | Time Warner Cable | Corporate
Digital Cable is Digital Cable? If I am a basic cable subscriber do I have used for more channels and an innovative on-screen guide. Go to Digital Cable? It offers a higher quality picture and sound, dozens more information. What is a new type of cable television distribution using digital video compression that's replacing...
What should I do if channels are missing? | Time Warner Cable | Corporate
... offer. for a digital set . What should I do if channels are missing? My set may not be able to program missing channels by following instructions in a different language or distorted? What should I do if the sound is in the owner's manual that came with your TV set -top...