2011 Suzuki Grand Vitara Support Question
Find answers below for this question about 2011 Suzuki Grand Vitara.Need a 2011 Suzuki Grand Vitara manual? We have 1 online manual for this item!
Question posted by kbuwil on May 21st, 2014
How To Replace Oil Filter Suzuki Grand Vitara 2.4l
Current Answers
Answer #1: Posted by waelsaidani1 on May 21st, 2014 6:20 AM
Engine Oil and Filter: 1, 2 INSPECTION AND MAINTENANCE Replace the Oil Filter 2.4 L engine NOTE: • When it is difficult to remove the oil filter, we recommend you take your vehicle to your SUZUKI dealer for oil filter replacement. • For 3.2 L engine, since special procedures are required, we recommend you take your vehicle to your SUZUKI dealer for oil filter replacement. EXAMPLE Refill with Oil and Check for Leaks 1) Pour oil through the filler hole and install the filler cap. For the approximate capacity of the oil, refer to the "Capacities" item in the "SPECIFICATIONS" section. 2) Start the engine and look carefully for leaks at the oil filter and drain plug. Run the engine at various speeds for at least 5 minutes. 3) Stop the engine and wait about 5 minutes. Check the oil level again and add oil if necessary. Check for leaks again. 54G093 78K055 (1) Oil filter (2) 3/4 turn 5) Tighten the filter 3/4 turn from the point of contact with the mounting surface (or to the specified torque) using an oil filter wrench. 6) Reinstall the engine under cover. Tightening torque specification 14 Nm (10.1 lb-ft, 1.4 kg-m) 1) Using an oil filter wrench, turn the oil filter counterclockwise and remove it. 2) Using a clean rag, wipe off the mounting surface on the engine where the new filter will be seated. 3) Smear a little engine oil around the rubber gasket of the new oil filter. 4) Screw on the new filter by hand until the filter gasket contacts the mounting surface. CAUTION When replacing the oil filter, it is recommended that you use a genuine SUZUKI replacement filter. If you use an after-market filter, make sure it is of equivalent quality and carefully follow the manufacturer's instructions and precautions. CAUTION To tighten the oil filter properly, it is important to accurately identify the position at which the filter gasket first contacts the mounting surface. CAUTION To prevent oil leakage, make sure that the oil filter is tight, but do not overtighten it. 7-12 79K21-03E
Answer #2: Posted by TechSupport101 on May 21st, 2014 6:03 AM
http://www.helpowl.com/a/Suzuki/2011-Grand%20Vitara/Manuals/5836
Related Manual Pages
Similar Questions
how long is the oil dipstick for a 2011 Suzuki Grand Vitara 2.4?
what's the correct proceedure to remove the rear internal side panel of the swb grand vitara to get ...
I've misplaced my maintenance manual for the 2007 Grand Vitara and just broke 100,000 miles. What ar...
The fuse keeps blowing when i indicate left.Is this a common problem on the suzuki grand vitara?Anyo...